a single stub tuner, connected in parallel, has a 50 ohm main line, and a 50...

a single stub tuner, connected in parallel, has a 50 ohm main line, and a 50 ohm short- circuited stub .It is used to match a load of Zr = 20+j70 to a 50 ohm system. What are the lengths of the line and stub in centimeters if the single stub tuner is using air filled coaxial lines and the system is operating at 600MHz

Expert Solution

Manojponduru answered 1 year ago

Two resistors, R1 = 20-ohm and R2 = 30-ohm, are connected in parallel to each other,...

Two resistors, R1 = 20-ohm and R2 = 30-ohm, are connected in parallel to each other, and this combination is connected across a 30-V source of emf. The current through the resistor R2 is:

A) A 150 + j300 Ohm load is connected to a 75 Ohm transmission line. Determine...

A) A 150 + j300 Ohm load is connected to a 75 Ohm transmission line. Determine the value of the reactance to put in parallel at the input to the line and the length in wavelengths of the shortest transmission line to match with a 75 Ohm source. B) Redo A using a short-circuited stub as the equivalent parallel reactance.

Electromagnetic Waves: Design single stub matching network for the transmission line of Zo = 50 ohms...

Electromagnetic Waves: Design single stub matching network for the transmission line of Zo = 50 ohms terminated with Z1 = 100+ j100 ohms. Find SWR and Reflection Coefficient .

Two resistors 30 Ω and 50 Ω are connected in parallel and this parallel arrangement is...

Two resistors 30 Ω and 50 Ω are connected in parallel and this parallel arrangement is then connected in series with two resistors 20 Ω each. The combination is placed across a 10V potential difference. Hence construct the diagram of the above circuit. According to your observation evaluate the total current in the circuit and also the total power delivered to the resistors and also show that the total power dissipated is equal to the sum of the power dissipated...

A 50 ohm transmission line has an unknown load impedance ZL. A voltage maximum occurs at...

A 50 ohm transmission line has an unknown load impedance ZL. A voltage maximum occurs at z = -0.15(wavelength). At z = -0.20(wavelength) the real part of the impedance is 30 ohms. Find ZL using the Smith chart.

1. Three identical resistors are connected in parallel to a single battery. The current through the...

1. Three identical resistors are connected in parallel to a single battery. The current through the resistors must be... a. one-third of the current through the battery. b. the same for the resistors as for the battery. c. different for each resistor. d. higher for one resistor and lower for the other two. 2. A 6Ω and a 12Ω resistor are connected in series with a 36 volt battery,. How many Joules per second are dissipated by the 12Ω resistor....

Two parallel connected loads take a total of 2.4 kW, with a 0.8 line delay at...

Two parallel connected loads take a total of 2.4 kW, with a 0.8 line delay at 120 Vrms and 60 Hz. One load absorbs 1.5 kW with a fp delay of 0.707. Determine: a) The fp of the second charge b) The parallel element required to correct the fp of the two loads and convert it to a delay of 0.9

A 20KVA , 2400/240 single-phase transformer has Reqp=4.45 ohm and Xeq1=6.45 ohm, Plot the voltage regulation...

A 20KVA , 2400/240 single-phase transformer has Reqp=4.45 ohm and Xeq1=6.45 ohm, Plot the voltage regulation as load current increased from no-load to full-load at different power factor 0.85 lagging, 1.0 and 0.85 leading using Matlab.

A 100 ohms load is connected to a 50 ohms transmission line. Determine the value of...

A 100 ohms load is connected to a 50 ohms transmission line. Determine the value of the reactance to put in series at the input to the line and the length in wavelengths of the shortest transmission line to match with a 50 ohms source.

1- A 480-V, 60-Hz, delta connected, synchronous generator has a synchronous reactance of 0.5 ohm and...

1- A 480-V, 60-Hz, delta connected, synchronous generator has a synchronous reactance of 0.5 ohm and Its rated Line current is 100 A. if the generator is connected to a 480V grid Draw the phasor diagram and find EA, delta angle and output power under the following conditions a- The generator supply the rated current at 0.8 PF lagging. b-The generator supply the rated current at 1.0 PF. c- The generator supply the rated current at 0.8 PF leading.

Question