caffeine (C8H10N4O2) pill are mixture and we will be separating caffeine from them. Determine the moles...

caffeine (C8H10N4O2) pill are mixture and we will be separating caffeine from them. Determine the moles of caffeine in a 1.75 g pill that is 29.33% by mass caffeine. determine % recovery of caffeine if you were able to isolate 33.6 mg of caffeine from the pill??

Expert Solution

mass of caffeine in a pill = 1.75*29.33/100 = 0.513 g

moles of caffeine in a pill = w/mwt

mwt = molarmass of caffeine = 194.2 g/mol

= 0.513/194.2

= 0.00264 mol

percent recovery of caffeine = mass of caffeine recovered / mass of caffeine in pill*100

= 0.0336/0.513*100

= 6.55%

queen_honey_blossom answered 2 years ago

What is the mechanism for separating 9-fluorenone and a carboxylic acid in mixture? We are using...

What is the mechanism for separating 9-fluorenone and a carboxylic acid in mixture? We are using a separatory funnel and adding the mixture of 9-fluorenone and a carboxylic acid to it. I need to know the mechanism of how they will separate into an aqueous and an organic layer.

We are separating a mixture that is 10 mol% methanol, 20 mol% ethanol, 30 mol% n-propanol...

We are separating a mixture that is 10 mol% methanol, 20 mol% ethanol, 30 mol% n-propanol and 40 mol% n-butanol in a distillation column. The feed is a saturated liquid. We desire to recover 98% of the ethanol in the distillate and 97% of the n-propanol in the bottoms product. The column has a total condenser and a partial reboiler and a feed rate of 100 kmol/hour at 1 atm pressure. The external reflux ratio is 5. In the enriching...

To determine which is the limiting reactant, we compare the ratio of moles of each reactant...

To determine which is the limiting reactant, we compare the ratio of moles of each reactant to the ratio of their coefficients in the balanced equation. Why do we base our choice of which substance is limiting, based on the number of initial moles, and not on its initial mass in grams?

An asymmetric ultrafiltration membrane is used with the aim of separating dyes from a liquid stream and to achieve a more concentrated dye-water mixture.

An asymmetric ultrafiltration membrane is used with the aim of separating dyes from a liquid stream and to achieve a more concentrated dye-water mixture. The feed waste stream arrives at a flow rate of 2.2m3.hour-1 with concentration of 1.2 kg.m-3. The membrane’s operating characteristic was calculated from various experiments: where the bulk concentration C has units of kg.m-3 and flux is measured in m3.hour-1.m-2. If two membrane modules, each of area 25 m2, are simply placed in series, give reasonable...

An asymmetric ultrafiltration membrane is used with the aim of separating dyes from a liquid stream and to achieve a more concentrated dye-water mixture.

An asymmetric ultrafiltration membrane is used with the aim of separating dyes from a liquid stream and to achieve a more concentrated dye-water mixture. The feed waste stream arrives at a flow rate of 3.0m3.hour-1 with concentration of 0.5 kg.m-3. The aim is to achieve a dye-water concentration leaving the membrane of 20 kg.m-3, so that it can be reused to dye fabric. The membrane’s operating characteristic was calculated from various experiments: where the bulk concentration C has units of ...

Distillation is one of the important unit operations in chemical process. It is a process of separating a component from its liquid mixture, which involves heating and cooling process.

Distillation is one of the important unit operations in chemical process. It is a process of separating a component from its liquid mixture, which involves heating and cooling process. There are various types of distillation methods, such as simple distillation, fractional distillation, steam distillation and vacuum distillation. Based on the above description, answer the following questions: Question 1 Identify three (3) factors to be considered in selecting a suitable distillation process. Question 2 Distillation may cause incomplete separation or partial separation of a component in...

Moles are what we are supposed to be solving based on the information from the table. No other information has been given.

Moles are what we are supposed to be solving based on the information from the table. No other information has been given. Data Table 1: Analysis of Alka-Seltzer Trial 1 Trial 2 Mass of acetic acid 5 g 5 g Density of acetic acid 1.00 g/mL Concentration of acetic acid 0.88 M Mass of Alka-Seltzer 3.21 g 3.21 g Volume of NaOH, initial 5 mL 5 mL Volume of NaOH, final 1.2 mL 1.8 mL Volume of NaOH, total...

Determine the number of moles of each gas present in a mixture of CH4 and C2H6 in a 2.50-L vessel at 25°C and 1.76 atm, given that the partial pressure of CH4 is 0.53 atm.

Determine the number of moles of each gas present in a mixture of CH4 and C2H6 in a 2.50-L vessel at 25°C and 1.76 atm, given that the partial pressure of CH4 is 0.53 atm. What is the number of moles of CH4? What is the number of moles of C2H6?

When we consume excessive carbohydrates and protein from diet, the body store them in the adipose...

When we consume excessive carbohydrates and protein from diet, the body store them in the adipose tissue in the form of triglycerides. Explain the key steps in the metabolic pathways that lead to triglyceride formation from glucose and amino acids.

We want to determine the constant of a spring using Hooke's Law as reference. From the...

We want to determine the constant of a spring using Hooke's Law as reference. From the experiment we can extract the following pairs (Applied Force (N), How much the spring elogated (m)): {(2,4),(4,7),(7,15),(8,16)}. a) Determine the value that minimizes the cuadratic error for the constant of the spring (F=kx) b) Could we find an approximate solution that generates a residual vector r with cuadratic norm ||r||^2 = 0.45?(Remember that r = b - ?? ̂. )

Question

caffeine (C8H10N4O2) pill are mixture and we will be separating caffeine from them. Determine the moles...

Solutions

Expert Solution

Related Solutions

What is the mechanism for separating 9-fluorenone and a carboxylic acid in mixture? We are using...

We are separating a mixture that is 10 mol% methanol, 20 mol% ethanol, 30 mol% n-propanol...

To determine which is the limiting reactant, we compare the ratio of moles of each reactant...

An asymmetric ultrafiltration membrane is used with the aim of separating dyes from a liquid stream and to achieve a more concentrated dye-water mixture.

An asymmetric ultrafiltration membrane is used with the aim of separating dyes from a liquid stream and to achieve a more concentrated dye-water mixture.

Distillation is one of the important unit operations in chemical process. It is a process of separating a component from its liquid mixture, which involves heating and cooling process.

Moles are what we are supposed to be solving based on the information from the table. No other information has been given.

Determine the number of moles of each gas present in a mixture of CH4 and C2H6 in a 2.50-L vessel at 25°C and 1.76 atm, given that the partial pressure of CH4 is 0.53 atm.

When we consume excessive carbohydrates and protein from diet, the body store them in the adipose...

We want to determine the constant of a spring using Hooke's Law as reference. From the...