Question

In: Chemistry

fill blanks: D) a geothermal power plant running on a binary power cycle uses ........... as...

fill blanks:

D) a geothermal power plant running on a binary power cycle uses ........... as the working fluid.

e) using biomass as a fossil fuel does nto contribute to global climate change because .................................

F) the three renewable froms of energy that each provide about 6% of the total energy consumed in the USA are ............... , .................. , and ..............

G) when the atmospheric increases with altitude is called an .................

Solutions

Expert Solution

D) Pentane hydrocarbon is used as working fluid in geothermal power plant running on binary power cycle. Pentane is used because of its low boiling point.

E) biomass releases the carbon which is released naturally when organic matter is decomposed.so it formed a closed cycle because carbon that is released by burning it is reused by other plants in their growing cycle. Moreover it doesn't contain elements like mercury and sulfur found in coal so it's emmisions are therefore safer.

F) hydro ,wind ,biomass

G) atmospheric temperature increases with altitude is called an inversion. Due to this reason stratosphere is so stable.


Related Solutions

A binary geothermal power plant uses geothermal water at 160°C as the heat source. The plant...
A binary geothermal power plant uses geothermal water at 160°C as the heat source. The plant operates on the simple Rankine cycle with isobutane as the working fluid. Heat is transferred to the cycle by a heat exchanger in which geothermal liquid water enters at 160°C at a rate of 555.9 kg/s and leaves at 90°C. Isobutane enters the turbine at 3.25 MPa and 147°C and leaves at 79.5°C and 410 kPa. Isobutane is condensed in an air-cooled condenser and...
Design a geothermal source power generation system; a) Describe the type of geothermal power plant (Total...
Design a geothermal source power generation system; a) Describe the type of geothermal power plant (Total Flow / Flash / Binary) b) Describe the turbine isentropic efficiency c) Show the entire cycle in the T-s diagram. d) Calculate the power produced. answer for expert: Not all , just one of theese three ( Total flow / flash or binary)
The initial investment for a geothermal power plant is $60,000,000 and is to be paid in...
The initial investment for a geothermal power plant is $60,000,000 and is to be paid in two years (year 0 and year 1) equally. The electricity generated by the plant is expected to bring revenue of 10,000,000 per year increasing at a rate of 3% annually. The total annual expenses of the plant will be 1,500,000 increasing at a rate 4% annually. The company that owns the plant plans to borrow 50% of the capital expenditure at a rate 6%....
Explain the biggest challenge in maintaining a geothermal power plant.
Explain the biggest challenge in maintaining a geothermal power plant.
In a double flash geothermal power plant, the high-pressure separator is operating at 1 MPa and...
In a double flash geothermal power plant, the high-pressure separator is operating at 1 MPa and the adiabatic low-pressure separator is operating at 300 kPa. The steam quality entering the adiabatic high-pressure separator is 0.3. The mass flow of saturated liquid leaving the low-pressure separator is 15 kgs. The exit pressure of the steam turbine is 15 kPa and the turbine isentropic efficiency is 0.8. Calculate a. The mass flow at the turbine exit b. The mass flow rate entering...
Explain briefly the difference between a conventional power plant and a combined cycle power plant with...
Explain briefly the difference between a conventional power plant and a combined cycle power plant with the aid of neat diagrams.
Know the following two equations i.e. fill in the blanks with the corresponding signs: Bond D...
Know the following two equations i.e. fill in the blanks with the corresponding signs: Bond D = f(     )? Bond S = f(    )? Put the signs over each explanatory variable.
An insulated heat exchanger uses geothermal water to heat water for a chemical plant. Water enters...
An insulated heat exchanger uses geothermal water to heat water for a chemical plant. Water enters the heat exchanger at a rate of 36 kg/s and is heated from 23 ∘∘C to 69 ∘∘C. The geothermal water enters the exchanger at a rate of 41.4 kg/s and at an initial temperature of 130 ∘∘C. The specific heat of the geothermal water is 4.31 kJ/(kg K). Determine the rate of heat transfer between the two streams and the rate of entropy...
A Rankine cycle power plant is being developed to operate an irrigation system. In this power...
A Rankine cycle power plant is being developed to operate an irrigation system. In this power plant solar energy will be used to boil a low boiling point fluid within glazed flat plate solar collectors. The working fluid that has been selected is the commonly used refrigerant R 134a (1, 1, 1, 2 tetrafluoroethane), tabulated properties of which may be found in Tables A11, A12 and A13 at the rear of the prescribed text. The plates being used for the...
A Rankine cycle power plant is being developed to operate an irrigation system. In this power...
A Rankine cycle power plant is being developed to operate an irrigation system. In this power plant solar energy will be used to boil a low boiling point fluid within glazed flat plate solar collectors. The working fluid that has been selected is the commonly used refrigerant R 134a (1, 1, 1, 2 tetrafluoroethane), tabulated properties of which may be found in Tables A11, A12 and A13 at the rear of the prescribed text. The plates being used for the...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT