For Polymers lab. In what region of the two-phase system was the Nylon-6,10 polymer formed after...

For Polymers lab. In what region of the two-phase system was the Nylon-6,10 polymer formed after the sebacoyl chloride/cyclohexane and 1,6-hexanediamine/sodium hydroxide solutions were mixed? Why?

Expert Solution

queen_honey_blossom answered 3 years ago

What are the disadvantages of polymers? What is an electrical property of a polymer and is...

What are the disadvantages of polymers? What is an electrical property of a polymer and is there any exception to that electrical property? if so, what is it?

Mixtures of two different polymers belong to the class of polymer blends. a) Explain why a...

Mixtures of two different polymers belong to the class of polymer blends. a) Explain why a two-phase system can form when mixing two different polymers. Give two examples of morphology types that may occur (sketch). b) Show by example how the morphology of a blend influences the macroscopic properties of the blend.

what the stationary phase and mobile phases are used in the Aldol condensation lab?

Applying the phase rule. Consider the phase diagram for a one-component system. (a) What is the...

Applying the phase rule. Consider the phase diagram for a one-component system. (a) What is the variance and number of phases at (T1, p1)? (b) What is the variance and number of phases at (T2, p2)? (c) What is the variance and number of phases at (T3, p3)? (d) Which is the triple point?

Saturated water at 20 C flows inside the annular region formed by two concentric circular tubes....

Saturated water at 20 C flows inside the annular region formed by two concentric circular tubes. The OD=71 in mm, while the ID= 101 mm, The mass flow rate is 0.02 kg/s. , The outer surface is insulated, and the inner surface is kept at 71 C, . Determine the heat transfer coefficient from inner surface to water under fully developed velocity and temperature flow conditions. Use the following constant thermo-physical properties of water, ρ = 1000kg/m3; μ = 1×10-5...

In polymer Engineering - To manufacturing blends, what are the two blending methods? Also, what are...

In polymer Engineering - To manufacturing blends, what are the two blending methods? Also, what are the advantages and disadvantages of each method?

To manufacturing polymer blends, what are the two blending methods?Also, what are the advantages and disadvantages...

To manufacturing polymer blends, what are the two blending methods?Also, what are the advantages and disadvantages of each method? (4 pt)

How many spermatids are formed after spermatogenesis? What is the epididymis purpose? What is the function...

How many spermatids are formed after spermatogenesis? What is the epididymis purpose? What is the function of the Ductus (Vas) Deferens? What does the seminal vesicle do? What volume is contributed to the semen? Why is it so important that the semen be alkaline?

this question from HPLC lab : b. What are ways, other than changing the mobile phase...

this question from HPLC lab : b. What are ways, other than changing the mobile phase compositions, to change the total retention or selectivity of the system towards the compounds? other than changing the mobile phase compositions (Temperature, sorbent, pH, etc...?)

what typical activities should be performed in the stage or phase of system analysis of any...

what typical activities should be performed in the stage or phase of system analysis of any methods or models of SDLC

Question