Question

In: Physics

Compare (take the ratio) the rate of heat conduction through a 20.0-cm-thick wall that has an...

Compare (take the ratio) the rate of heat conduction through a 20.0-cm-thick wall that has an area of 10.0 m2 and a thermal conductivity twice that of glass wool with the rate of heat conduction through a 0.750-cm-thick window that has an area of 2.00 m2, assuming the same temperature difference across each. Show a few steps. Qualitatively, explain how you can reduce heat conduction through a window in winter.

Solutions

Expert Solution

genius_generous answered 1 year ago
Next > < Previous

Related Solutions

A carpenter builds an exterior house wall with a layer of wood 3.0 cm thick on...
A carpenter builds an exterior house wall with a layer of wood 3.0 cm thick on the outside and a layer of Styrofoam insulation 2.0 cm thick on the inside wall surface. The wood has k=0.080W/(m⋅K), and the Styrofoam has k= 0.010 W/(m⋅K). The interior surface temperature is 20.0 ∘C , and the exterior surface temperature is -12.0 ∘C What is the rate of heat flow per square meter through this wall?
A carpenter builds an exterior house wall with a layer of wood 3.0 cm thick on...
A carpenter builds an exterior house wall with a layer of wood 3.0 cm thick on the outside and a layer of Styrofoam insulation 2.4 cm thick on the inside wall surface. The wood has k=0.080W/(m⋅K), and the Styrofoam has k= 0.010 W/(m⋅K). The interior surface temperature is 20.0 ∘C , and the exterior surface temperature is -14.0 ∘C . Part A What is the temperature at the plane where the wood meets the Styrofoam? Express your answer using two...
The rate of heat transfer, Q [energy/time = power] through a pipe wall between a fluid...
The rate of heat transfer, Q [energy/time = power] through a pipe wall between a fluid and the surroundings depends on fluid properties: density (ρ), viscosity (μ), specific heat (cp [energy/temperature/mass]); and also on pipe and flow properties: the length (l), diameter (D), and thermal conductivity (λ [power/length/temperature]) of the pipe, fluid mean velocity (V), and the temperature difference (ΔT) between the pipe wall and the surroundings. Use dimensional analysis to express this system in terms of dimensionless numbers. The...
A thick lens has an index of refraction of 1.60. It is 4-cm thick and is...
A thick lens has an index of refraction of 1.60. It is 4-cm thick and is surrounded by air. The radius of curvature of the front surface is 5 cm, and the radius of curvature of the back surface is 12 cm. A 1-cm tall object is placed to the left of the first surface. At what angle above the optic axis should a ray strike the front side of the lens 0.5 cm above the optical axis so that...
A plane wall has thickness of 5 cm, thermal conductivity of 2 W/mK and generates heat....
A plane wall has thickness of 5 cm, thermal conductivity of 2 W/mK and generates heat. The left face of the wall (x=0) has a surface temp. of 80C and has air at 20C flowing past it with a heat transfer coefficient of 50 W/m^2K. If the right face is insulated then the temperature distribution through the wall has a general format T(x)=A+B*x+C*x^2 (a) Draw a properly labeled diagram (including a representative temperature distribution), state all assumptions and calculate the...
A wall is constructed of two layers of 2-cm-thick sheetrock (k = 0.17 W/m·K) separated by...
A wall is constructed of two layers of 2-cm-thick sheetrock (k = 0.17 W/m·K) separated by 16 cm by wood studs (k = 0.11 W/m·K) whose width is 5 cm. The studs are placed vertically 55 cm apart, and the space between them is filled with stagnant air (16 by 55 cm) as insulation (k = 0.026 W/m·K). Pay attention to the measurements! The house is maintained at 20°C and the ambient temperature outside is ?9°C. Taking the heat transfer...
1. Find the electric field magnitude midway through the nonconducting wall of a thick-walled pipe of...
1. Find the electric field magnitude midway through the nonconducting wall of a thick-walled pipe of infinite length with inner radius w, outer radius 3w, and a uniform volumetric charge density ρ. Answer in terms of the permittivity. 2. Find the electric field strength due to two completely hollow, concentric spherical shells made of metal. The inner shell has a radius w and carries a uniform surface charge density -σ. The outer has radius 2w and uniform charge density +4σ....
Heat conduction from a hotter object to a colder object through a barrier (e.g. warm inside...
Heat conduction from a hotter object to a colder object through a barrier (e.g. warm inside out to cold outside air through a window) is descrbed by Q?t=kAL|T1?T2| where k is the conductivity of the barrier, L is the distance the heat has to travel between hotter and colder objects, A is the total cross sectional area of the barrier that is perpendicular to heat flow, and T1 and T2 are the two temperatures. In this problem, you will connect...
A freezer planned to be insulated with 10 cm thick Styrofoam. At what rate the compressor...
A freezer planned to be insulated with 10 cm thick Styrofoam. At what rate the compressor must remove heat from the freezer to keep the inside temperature at -18 degrees C in a place where the air temperature is 22 degree. The freezer dimensions are 2m tall,1m wide, and 1m deep.
A product has a target length of 20.0 cm, and the process has a standard value...
A product has a target length of 20.0 cm, and the process has a standard value for the standard deviation of 0.05 cm. Calculate the standard deviation control chart upper limit when the sample size is 5 please show work
ADVERTISEMENT
Subjects
ADVERTISEMENT
Latest Questions
ADVERTISEMENT