Question

In: Nursing

You are making an IV infusion that is to have a final concentration of 0.5 mg/mL....

You are making an IV infusion that is to have a final concentration of 0.5 mg/mL. You are making 1000 mL of the total solution and the vial of medication is a concentration of 25 mg/mL. How many mL of the medication should you place into the IV fluid?

Solutions

Expert Solution

THE AMOUNT OF MEDICATIO AVAILABLE   25MG/ML

The amount of final concentration of medication is 0.5/ml

The required amount of medication to be infused in 1000 ml

Steps of calculation

       1.   To identify amount of medication per liter, divide the known amount of medication in solution with total   volume dilution

                            Known amount of medication in solution                                         

­­­­­­­­­­­­­­­­­­­­­­­­­­­­­                              -----------------------------------------------             =          ­­­­­­­­­­­­­­­­­­

                                     Total volume dilution                  

                                    25ml

                      ------------------------     =0.025 ml

                                1000 ml

   2.       Then divide required dose per ml with the obtained value of concentration per liter

                                           Dose per ml required                                     

                                   ---------------------------------------               

                                   Concentration per milliliter                               

                                              0.5ml

                           ---------------------------------= 20ml/500mg

                                                     0.025

= 20 ml to be infused into the intravenous fluid in order to achieve the 0.5mg/ml for flow


Related Solutions

A drug for IV infusion is supplied as a 4 mL vial with a concentration of...
A drug for IV infusion is supplied as a 4 mL vial with a concentration of 2.5 mg /mL. the contents of the vial are transferred into an infusion bag to make a final volume of 1000 mL. The infusion is to run for a total of 120 minutes with a flow rate of 30 mL /hour. How much drug will be delivered?
A drug for IV infusion is supplied as a 10 mL vial with a concentration of...
A drug for IV infusion is supplied as a 10 mL vial with a concentration of 10% w/v. 5 mL of this vial is transferred into an infusion bag to make a final volume of 250 mL. The infusion rate is to be 10 mL / min. How long will it take to deliver a dose of 100 mg of the drug?
You are asked to prepare 500. mL of IV therapy solution, with a final concentration of...
You are asked to prepare 500. mL of IV therapy solution, with a final concentration of the following solutes: 3.3 % dextrose and 0.90 % normal saline (m/v). How much dextrose and sodium chloride would you need to weigh to prepare the solution?
At 1300 you begin an IV infusion at 67.5 ml/hr; the infusion is stopped at 1420...
At 1300 you begin an IV infusion at 67.5 ml/hr; the infusion is stopped at 1420 so the patient can leave the unit and go to a procedure. The patient returns at 1450 and you restart the infusion at 1510. The infusion runs for another 98 minutes. The concentration of medication in the bag is 0.85/50ml. How many mcg have already been infused? Round to a whole number.
You have 0.5 ml of a stock solution of 1 mg/ml BSA. You need at least...
You have 0.5 ml of a stock solution of 1 mg/ml BSA. You need at least 200 ul of the solutions listed below. Calculate the volume of BSA needed and the volume of water needed to make the solutions. 25 ug/ml 50 ug/ml 75 ug/ml 100 ug/ml 150 ug/ml 200 ug/ml
A patient is ordered 40 mg IV once daily. the concentration of the vial is 25mg/ml....
A patient is ordered 40 mg IV once daily. the concentration of the vial is 25mg/ml. the IV manual states to dilute the medication in a 50 ml bag of NS and infuse over 30 min. The drop factor is 10gtt/ml. At what rate in drops/min would you infuse the medication?
The dose of ofatumumab (Arzerra) for a patient is 300 mg. In preparing an IV infusion,...
The dose of ofatumumab (Arzerra) for a patient is 300 mg. In preparing an IV infusion, a pharmacist draws the calculated volume of drug from a 50-mL vial containing 1 g of the drug. This quantity is then added to a 1-L bag of normal saline. The infusion is programmed to flow at a rate of drug of 3.6 mg per hour. (a) What volume (in mL) of the drug from the vial is needed for the patient's dose? (b)...
0.5 mg/ml of rabbit anti-HIV gp120 monoclonal antibody. Dilute to a working concentration of 2 ug/ml...
0.5 mg/ml of rabbit anti-HIV gp120 monoclonal antibody. Dilute to a working concentration of 2 ug/ml in 1x PBS. Please show math and work 0.5 mg/ml of rabbit anti-HIV gp120 monoclonal antibody conjugated to HRP. Dilute to a working concentration of 0.5 ug/ml in 1x PBS. Please show math and work.
Hydromorphone 0.5 mg is ordered direct IV for the patient. Hydromorphone is available in 2 mg...
Hydromorphone 0.5 mg is ordered direct IV for the patient. Hydromorphone is available in 2 mg /mL. How many ml will the nurse draw up in the 1 mL syringe to give the ordered dose? _______ Clindamycin 0.6 g is ordered IV q.12h. for the patient. The pharmacy sends a vial of clindamycin labeled 900 mg / 6 mL. How many mL will the nurse administer to the patient? _________ mL Order: Heparin 50,000 units in 100 mL D5W. Run...
Order: 5% Dextrose in water at 75 ml/hr. Diltiazem IV infusion 5mg/hr Supply: Diltiazem 125 mg...
Order: 5% Dextrose in water at 75 ml/hr. Diltiazem IV infusion 5mg/hr Supply: Diltiazem 125 mg in 125 ml of 5% Dextrose in water. How many milliliters of 5% dextrose in water will the patient get in 4 hours?
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT