A refrigeration system is working on vapour compression cycle using R134a as refrigerant. The objective is...

A refrigeration system is working on vapour compression cycle using R134a as refrigerant. The objective is to keep the refrigerated space at temperature of 243K. The vapours enter the compressor at 0.6 bar and at 239K and after compression leaves at 12 bar and 338K. The condenser is water cooled, in which water is supplied at 291 K at mass flow rate of 15 Kg/hr. and leaves at 299K. The refrigerant leaves the condenser temperature of 315K after rejecting heat. The compressor is not perfectly insulated and it absorbs 450 J/sec of heat from the surrounding. Analyze the refrigerator by determining

Dryness fraction of refrigerant (x) at inlet of evaporator inlet, Refrigeration load in tones of refrigeration, COP of the refrigerator

Draw TS diagram of the process and label all operating temperature and pressure

Expert Solution

samet mamat answered 2 hours ago

An ideal vapor compression refrigeration cycle using r134a as the refrigerant is being used to cool...

An ideal vapor compression refrigeration cycle using r134a as the refrigerant is being used to cool a house. It provides 3 refrigeration tons ≈ 10.5kW of cooling (heat removal from the house air). The refrigerant in the evaporator operates at 400kPa while in the condenser it is at 1000kPa. Treat the surroundings as a thermal reservoir at 33◦C and the air in the house as a thermal reservoir at 19◦C. All reservoirs are at 100kPa. 1. What is the COPr...

An air conditioner using R134a as the working fluid operates on an ideal vapour compression system...

An air conditioner using R134a as the working fluid operates on an ideal vapour compression system between 0.3 and 0.8 MPa. If the specified capacity for air conditioning is 20 kW. What would be its capacity for food freezing for which the evaporator temperature -20oC. Show the cycle on a PH diagram and explain the effect of the changes to the compressor and condenser respectively.

Consider a vapour compression refrigeration cycle that uses R-134a as refrigerant. The R-134a enter

Consider a vapour compression refrigeration cycle that uses R-134a as refrigerant. The R-134a enters the compressor as a saturated vapour at 200 kPa, and exits the condenser as a saturated liquid at 900 kPa. The rate of refrigeration of the cycle is to be 6.0 tons of refrigeration (1 ton of refrigeration = 3.517 kW). The compressor isentropic efficiency is 80%. Determine: a) The temperature of evaporation and condensation of the refrigerant; b) Mass flow of the refrigerant R-134a, in ...

An ideal vapor compression refrigeration cycle with R134a as the working fluid operates between the pressure...

An ideal vapor compression refrigeration cycle with R134a as the working fluid operates between the pressure limits of 200 kPa and 1200 kPa. Determine a) the mass fraction of the refrigerant that is in the liquid phase at the inlet of the evaporator, and b) the amount of heat transfer (in kJ/kg) to the refrigerant in the evaporator (??).

There is a vapor compression type refrigeration cycle using the refrigerant HFC 134 a. In the...

There is a vapor compression type refrigeration cycle using the refrigerant HFC 134 a. In the condenser, it is isostatically cooled, the condensation temperature is 50 ° C., and the condenser outlet is the compressed liquid at 45 ° C. In the evaporator, it is isothermally heated, the evaporation temperature is 10 ° C. and the outlet of the evaporator is heated steam at 15 ° C. When the expansion valve performs isenthalpic expansion, and the adiabatic efficiency of the...

A vapor-compression refrigeration cycle operates at steady state with Refrigerant 134a as the working fluid. Saturated...

A vapor-compression refrigeration cycle operates at steady state with Refrigerant 134a as the working fluid. Saturated vapor enters the compressor at 2 bar, and saturated liquid exits the condenser at 10 bar. The isentropic compressor efficiency is 80%. The mass flow rate of refrigerant is 7 kg/min. Determine: (a) the compressor power, in kW. (b) the refrigeration capacity, in tons. (c) the coefficient of performance.

A single stage simple vapr compression refrigeration cycle using R12 refrigerant is operating at a condenser...

A single stage simple vapr compression refrigeration cycle using R12 refrigerant is operating at a condenser temperature of 40 degrees C and an evaporator temperature of -5 degrees C. If the compressor is a reciprocating type compressor with 4 cylinder, rotating at 1800 RPM, has a cylinder diameter of 5cm, stroke length to diameter ratio of 1.4, and clearance ratio of 5%. Assume a polytropic index to be 1.13. 1- Sketch the cycle flow diagram, and identify the states on...

An air conditioner using refrigerant-134a as the working fluid and operating on the ideal vapor-compression refrigeration...

An air conditioner using refrigerant-134a as the working fluid and operating on the ideal vapor-compression refrigeration cycle is to maintain a space at 30°C while operating its condenser at 1000 kPa. Determine the COP of the system when a temperature difference of 2°C is allowed for the transfer of heat in the evaporator. (Take the required values from saturated refrigerant-134a tables.) The COP of the system is ?

a refrigerator uses refrigerant 134a as a working fluid and operates on the vapour -compression refrigiration...

a refrigerator uses refrigerant 134a as a working fluid and operates on the vapour -compression refrigiration cycle.the evaporator is maintained at -100C and the refrigirant is a dry saturated vapour as it leaves the evaporator. the compressor has an efficiency of 80%.the conditions at the outlet of the condensor are 300C and 9 bar. 1-if the mass flow rate of the refrigerant is 0,08kg/s workout the rate of heat removal from the refrigerant space.the power input to the cpmpressor and...

A vapor-compression refrigeration cycle working with R22 contains a liquid-to-suction heat exchanger. The saturated liquid refrigerant...

A vapor-compression refrigeration cycle working with R22 contains a liquid-to-suction heat exchanger. The saturated liquid refrigerant at 40 °C leaving the condenser and entering the heat exchanger is used to superheat the saturated vapor refrigerant leaving the evaporator at 7 °C by 8 °C. If the compressor is capable of pumping 5 l/s of vapor refrigerant measured at the inlet to the compressor and the compression processes are considered isentropic in both cases listed below, determine; (a) The refrigerating capacity...

Question