Question

In: Physics

8) Would gravity do more work on a brick sliding down a frictionless ramp if the...

8) Would gravity do more work on a brick sliding down a frictionless ramp if the brick started from rest, or if it started with an initial velocity down the slope?

a) Gravity does more work if it started from rest.

b) Gravity does more work if it started with an initial velocity down the slope.

c) Gravity does the same amount of work in both cases.

9) In a particular instant, a rock slides horizontally along a slope. The force of friction acting on the slope is in what direction?

a) Up the slope

b) Down the slope

c) In the direction of travel of the rock

d) Opposite the direction of travel of the rock

10) I stand with my arms straight out and spin. Which body part has more centripetal acceleration?

a) My elegant hands

b) My gorgeous elbows

c) It’s a tie.

11) I stand on slope with one foot in the air. What could I do to increase the friction I receive from the slope?

a) Put my other foot down.

b) Pick up a physics book that was on the slope by me.

c) either

d) neither

Solutions

Expert Solution


Related Solutions

A bucket of water is sliding down a frictionless ramp, whose angle of inclination is \thetaθ....
A bucket of water is sliding down a frictionless ramp, whose angle of inclination is \thetaθ. What angle does the water surface make with the horizontal? Is it zero, \thetaθ, or greater than \thetaθ? You must provide a convincing argument.
A block slides down a frictionless inclined ramp. If the ramp angle is 26° and its...
A block slides down a frictionless inclined ramp. If the ramp angle is 26° and its length is 29 m, find the speed of the block as it reaches the bottom of the ramp, assuming it started sliding from rest at the top.
A mass m slides down a frictionless ramp and approaches a frictionless loop with radius R....
A mass m slides down a frictionless ramp and approaches a frictionless loop with radius R. There is a section of the track (between the ramp and the loop) with length 2R that has a kinetic friction coefficient of 0.5. From what height h must the mass be released to stay on the track? No figure. 1.5R 2.5R 3.5R 4.5R or 5.5R
A box (with a penguin inside) with mass, M, slides down a frictionless ramp, starting a...
A box (with a penguin inside) with mass, M, slides down a frictionless ramp, starting a height H above ground level. At the lowest point of the ramp (height = -0.1H) it slides through a curved section of track with radius, R= 0.25H. The box (w/ penguin) then rises to ground level (height = 0) and at that point, leaves a jump at an angle θ. At the highest point of its trajectory, h2, it strikes a blob of glue...
A cart of mass m1 = 11 kg slides down a frictionless ramp and is made...
A cart of mass m1 = 11 kg slides down a frictionless ramp and is made to collide with a second cart of mass m2 = 24 kg which then heads into a vertical loop of radius 0.25 m (a) Determine the height h at which cart #1 would need to start from to make sure that cart #2 completes the loop without leaving the track. Assume an elastic collision. (b) Find the height needed if instead the more massive...
A 2.2 kg cart slides eastward down a frictionless ramp from a height of 1.5 m...
A 2.2 kg cart slides eastward down a frictionless ramp from a height of 1.5 m and then onto a horizontal surface where it has a head-on elastic collision with a stationary 3.0 kg cart cushioned by an ideal Hooke’s Law spring. The maximum compression of the spring during the collision is 2.0 cm. [10 marks] a) Determine the velocity of the cart 1 just before the collision. [1 mark] b) At the point of maximum compression determine the velocity...
A 10 kg mass is sliding at 8 m/s along a frictionless floor toward an ideal...
A 10 kg mass is sliding at 8 m/s along a frictionless floor toward an ideal massless spring. When the mass hits the spring, they stick together without any loss of energy. The mass stops briefly at x = +4.2 m before moving back toward equilibrium. (Assume x = 0 at the point at which the mass sticks to the spring and t = 0 when the mass first makes contact with the spring.)a)What is the spring constant of the...
When calculating Work of a ball rolling down a ramp, you could use W=Fd and W=changein"K"to...
When calculating Work of a ball rolling down a ramp, you could use W=Fd and W=changein"K"to find the work done on that ball. However what if you are not given given a force or acceleration? How wpuld tou find the Work? how would you calculate acceleration?
The battery cells are heavy and if they do not work, they are no more than...
The battery cells are heavy and if they do not work, they are no more than an extra load that puts the functionality of electric cars at risk. So, if the liability of cells is low, adding the number of cells can be a bad idea. We summarize this fact to this rule that for an electric car to be functional, the majority of cells must work. If each cell breaks with the probability of ?, for which value of...
What specific tools would make you more productive at work?
What specific tools would make you more productive at work?
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT