what are the effective loads acting to the structure?

Expert Solution

Ally Wells answered 2 months ago

What are the attributes of an effective ambidextrous organizational structure? Please explain.

The three Primary failure modes for concrete dams are: 1-Stability under acting loads 2-Load-bearing capacity (due...

The three Primary failure modes for concrete dams are: 1-Stability under acting loads 2-Load-bearing capacity (due to e.g. degradation or cracks) 3-Water-tightness Describe these-give the reason for when and how each of them Will occur?

A truss structure is used to build the transmission tower shown with dimensions and loads shown below.

Assuming the structure does not deform out-of-plane, and that none of the members buckle, find the force and stress that each member named in the table below carries and the change in length of each of those members if they are composed of structural steel.abcdhF1F1θθF2F2ϕϕ1.9 m3.4 m2.4 m5.2 m9.5 m6 kN54 deg6.7 kN23 degMembers:(Denote tension forces, tensile stresses, and elongations with positive values; compressive forces, compressive stresses and compactions with negative values.)MemberCross-SectionalArea(mm2)(mm2)ForceStressChange inLengthBCBC260BPBP200PQPQ260PCPC200CDCD260DPDP200NPNP260

Find a real physical example of a mechanical structure or machine that has a moment acting on it.

Find a real physical example of a mechanical structure or machine that has a moment acting on it. (a) Make a clear, labeled drawing of the situation. (b) Estimate the dimensions, and the magnitudes and directions of the forces that act on it. Show these on your drawing. Briefl y explain why you estimate the dimensions and forces to have the numerical values that you assigned. (c) Select a moment pivot point, explain why you chose that point (perhaps it is important...

What is the fastest and slowest acting insulin?

Identify an internal control structure and describe an effective internal control structure, relating to accounting and...

Identify an internal control structure and describe an effective internal control structure, relating to accounting and preparing accurate financial statements.

1. Transcriptional regulation in eukaryotes is controlled by both cis- and trans-acting elements. The following structure...

1. Transcriptional regulation in eukaryotes is controlled by both cis- and trans-acting elements. The following structure was isolated from honey bees. It shows such elements as well as parts of a gene body indicated with relative positions. The arrow denotes the transcription start site (the drawing is not in scale). Figure 1 A) Indicate what the elements or segments, number 1, 2, 3 and 4, are most likely to stand for. B) Which numbered segments can interact with trans-acting factors?...

Types of Structures and Loads

Three loads are connected in parallel to an AC supply of 120∠0° V. The loads are...

Three loads are connected in parallel to an AC supply of 120∠0° V. The loads are 40∠30° Ω, 50 - j30 Ω and 30 + j40 Ω. a) Draw the circuit diagram b) Determine the amplitude and phase angle of the supply current graphically by constructing a phasor diagram using a suitable scale of the load currents and source voltage. c) State the overall power factor using the answer from part (b). d) Construct another phasor diagram for the system...

The objective of this assignment is to identify and analyse the characteristics of effective organisational structure,...

The objective of this assignment is to identify and analyse the characteristics of effective organisational structure, to investigate the differences between the organisational structure of a “high performance organisation” and “low performance organisation”, and to analyse the role of leadership in developing and maintaining effective structure in a successful organization. All the information gathered to be transformed into a review paper to reflect understanding as future subject matter expert. REQUIREMENT: You are required to use organisational models, theories, concepts and...

Question