A power station uses Diesel as fuel (C12H26), from the analysis of combustion gases, it's obtain...

A power station uses Diesel as fuel (C12H26), from the analysis of combustion gases, it's obtain that 30% of carbon is converted to CO and the rest to CO2.

Furthermore, the gases in the exhaust have a temperature of 450 K. with this information:

a) mass air-fuel ratio: In Kgair/Kgfuel

b) Theoric air percentage: %

c) Moles of water steam produced in the reaction: in kmol

d)"wasted" heat in the gases on the steam exhaust, if you consider that the ideal exit temprature of the combustion gases should be of 380K: in kJ/kg

Expert Solution

samet mamat answered 1 week ago

Obtain manufacturers’ data on thermocouple and thermistor temperature sensors for measuring temperatures of hot combustion gases...

Obtain manufacturers’ data on thermocouple and thermistor temperature sensors for measuring temperatures of hot combustion gases from a furnace. Explain the basic operating principles of each sensor and compare the advantages and disadvantages of each device. Consider sensitivity, accuracy, calibration, and cost.

From a combustion process using a mixture of methane (1)/ethane (2) as fuel, the ORSAT analysis...

From a combustion process using a mixture of methane (1)/ethane (2) as fuel, the ORSAT analysis of the stack gases is given in the table below: Component Xi (molar basis) CO2 0.0769 O2 0.0837 N2 0.8394 Assume that 100 kgmole of stack gases are produced. DETERMINE: 1. Sketch the process. Label all streams. 2. Write the chemical reaction(s) that take place during the process 3. Find the composition of the fuel (mole fraction) 4. Find the % excess air.

During the power stroke of an internal combustion engine, the air-fuel mixture is ignited and the...

During the power stroke of an internal combustion engine, the air-fuel mixture is ignited and the expanding hot gases push on the piston. Fuel efficiency is maximized in this process when the ignited gas is as hot as possible, the gas expands allowing a maximum amount of work to be done, and cooled exhaust gas is released at the end of the cycle. Assuming the engine exhibits the highest efficiency possible, which of the following statements concerning the exhaust gas...

FMEA (Failure Mode and Effect Analysis) Smelly Gus’s Gas Station sells gasoline. Each non-diesel station carries...

FMEA (Failure Mode and Effect Analysis) Smelly Gus’s Gas Station sells gasoline. Each non-diesel station carries 87, 89, and 93 octane unleaded gasoline. Customers must prepay for gasoline by inserting a credit card or by prepaying with cash inside the station. Instructions Complete a FMEA. Identify the pump’s: function(s), potential failures, potential effects of failures, potential causes of failures, and any possible process controls. Determine Criticality for each potential failure.

A diesel cycle operates at and receives 400BTU of energy from the combustion process. The hot...

A diesel cycle operates at and receives 400BTU of energy from the combustion process. The hot air standard is k=1.3. The diesel engine receives air at a pressure of 14.5psia, 90°F, and 0.55lb. What is the mean effective pressure of the engine? The cut-off ratio is 12% of the volume displacement and the percent clearance is 8%.

A hydro power station is required to deliver 48MW of power to the national grid from...

A hydro power station is required to deliver 48MW of power to the national grid from a site where the available head is 16m The alternator efficiency may be taken as 96%.The proposed rotational speed of the coupled turbo-alternators is 150r/min and the specific speed of the available turbines is 400. Estimate the number 9f units required

The Metropolitan Bus Company (MBC) purchases diesel fuel from American Petroleum Supply.

The Metropolitan Bus Company (MBC) purchases diesel fuel from American Petroleum Supply. In addition to the fuel cost, American Petroleum Supply charges MBC $300 per order to cover the expenses of delivering and transferring the fuel to MBC's storage tanks. The lead time for a new shipment from American Petroleum is 10 days; the cost of holding a gallon of fuel in the storage tanks is S0.03 per month, or $0.36 per year; and annual fuel usage is 240,000 gallons....

A small gas turbine uses C8H18(l) for fuel and it enters the combustion chamber at 25◦C...

A small gas turbine uses C8H18(l) for fuel and it enters the combustion chamber at 25◦C whereas air coming from the high pressure stage is at 287◦C . The products of combustion leave the combustion chamber at 1167◦C . The fuel is injected at a rate of 0.95 kg/min where it is mixed and burned with 400 % excess air. An analysis of combustions reveals that all the hydrogen in the fuel burns to H2O but only 90% of the...

(Combustion Analysis) 100 m3 of a fuel oil are burned per hour with 20 percent excess...

(Combustion Analysis) 100 m3 of a fuel oil are burned per hour with 20 percent excess air in a steam generator. The fuel oil has a density of 926 kg/m3 and the following mass composition: 87% C, 12% H2, 1% S. Air enters the boiler at 100 kPa and 15 °C. Determine the following: (a). The volumetric flow rate of the air (m3 /min) fed to the boiler; (b). The flue gas molar composition on a dry basis, reporting all...

The Metropolitan Bus Company (MBC) purchases diesel fuel from American Petroleum Supply. In addition to the...

The Metropolitan Bus Company (MBC) purchases diesel fuel from American Petroleum Supply. In addition to the fuel cost, American Petroleum Supply charges MBC $300 per order to cover the expenses of delivering and transferring the fuel to MBC's storage tanks. The lead time for a new shipment from American Petroleum is 10 days; the cost of holding a gallon of fuel in the storage tanks is $0.06 per month, or $0.72 per year; and annual fuel usage is 120,000 gallons....

Question