A Debye-scherrer pattern of tungedten(BCC) is made with cu kalpha radiation .The first four lines on...

A Debye-scherrer pattern of tungedten(BCC) is made with cu kalpha radiation .The first four lines on this pattern were aboreved to have the following thita values:

line Angle

1 20.3ْ

2 29.2ْ

3 36.7ْ

4 43.6ْ

determine the Miller incidices of each reflection by the use of eq (3-10) and Apppendix10 and calculate their relative integrated intensities. From book CULLITU

Solutions

Expert Solution

genius_generous answered 1 year ago

Next > < Previous

Related Solutions

In an XRD pattern using Cu Kα radiation, a certain cubic crystal shows peaks at 2θ...

In an XRD pattern using Cu Kα radiation, a certain cubic crystal shows peaks at 2θ values (in degrees) of 44.3, 64.4, 81.6, 98.0. It is known that the size of the cubic crystal is greater than 2.5 Angstroms. Based on this information and the location of the peaks, we conclude that the lattice of the crystal is 1. simple cubic 2. face centered cubic 3. body centered cubic 4. none of the other choices

Plot the 3-Dimensional Radiation Pattern, Plot of Azimuth and Elevation radiation pattern of the Horn antenna....

Plot the 3-Dimensional Radiation Pattern, Plot of Azimuth and Elevation radiation pattern of the Horn antenna. Simulate it for the 100 MHz? What is the Directivity of the antennas. What is the Beam-width and Sidelobe levels?

The first four peaks in the X-ray powder diffraction pattern of sodalite are at 2 values...

The first four peaks in the X-ray powder diffraction pattern of sodalite are at 2 values of 9.97°, 14.12°, 17.32° and 20.02°. The radiation used for the experiment was Cu K with  = 1.5418 Å. Determine the lattice type and calculate the length, a, of the cubic unit-cell.

Plot the radiation pattern of loop antenna with the circumference approximately equals to ?, operating at...

Plot the radiation pattern of loop antenna with the circumference approximately equals to ?, operating at 1 GHz frequency.

An XRD experiment was performed Cu Ka radiation of wavelength 0.154 nm on an FCC crystal...

An XRD experiment was performed Cu Ka radiation of wavelength 0.154 nm on an FCC crystal with lattice constant = 3.61 Å. What are the Miller indices of the planes with lowest and highest Bragg angles?

In the Bohr model, the Paschen series of spectral lines is caused by radiation absorbed or...

In the Bohr model, the Paschen series of spectral lines is caused by radiation absorbed or emitted as an electron transitions between the 2nd excited state and any higher excited state (3rd excited state and higher) of the hydrogen atom. The Paschen series spectral lines all involve infrared photons. a) Using the Bohr model, calculate the energy of the electron when it is in the 2nd excited state, in units of electron-Volts (eV). b) Calculate the energy of the electron...

Calculate the equilibrium concentrations of NH3, Cu2+, [Cu(NH3)]2+, [Cu(NH3)2]2+, [Cu(NH3)3]2+, and [Cu(NH3)4]2+ in a solution made...

Calculate the equilibrium concentrations of NH3, Cu2+, [Cu(NH3)]2+, [Cu(NH3)2]2+, [Cu(NH3)3]2+, and [Cu(NH3)4]2+ in a solution made by mixing 500.0 mL of 3.00 M NH3 with 500.0 mL of 2.00 x 10-3 M Cu(NO3)2. The sequential equilibria are Cu2+ (aq) + NH3(aq) ⇐⇒ [Cu(NH3)]2+ (aq) K1 = 1.86 x 104 [Cu(NH3)]2+ (aq) + NH3(aq) ⇐⇒ [Cu(NH3)2]2+ (aq) K2 = 3.88 x 103 [Cu(NH3)2]2+ (aq) + NH3(aq) ⇐⇒ [Cu(NH3)3]2+ (aq) K3 = 1.00 x 103 [Cu(NH3)3]2+ (aq) + NH3(aq) ⇐⇒ [Cu(NH3)4]2+ (aq)...

Diffusion in material You are hardening a very thick tool plate made of BCC Fe by...

Diffusion in material You are hardening a very thick tool plate made of BCC Fe by increasing the carbon concentration in its surface layer by heating the tool in the presence of a C-rich gas (e.g. methane) which maintains a constant C concentration at the surface. A heat treatment at 600 °C for 100 minutes results in a C concentration of 0.75 wt% at a position 0.5 mm below the surface. How long would it take to obtain the same...

The complex ion Cu(NH3)42 is formed in a solution made of 0.0400 M Cu(NO3)2 and 0.400...

The complex ion Cu(NH3)42 is formed in a solution made of 0.0400 M Cu(NO3)2 and 0.400 M NH3. What are the concentrations of Cu2 , NH3, and Cu(NH3)42 at equilibrium? The formation constant*, Kf, of Cu(NH3)42 is 1.70 × 1013.

The complex ion Cu(NH3)42 is formed in a solution made of 0.0200 M Cu(NO3)2 and 0.400...

The complex ion Cu(NH3)42 is formed in a solution made of 0.0200 M Cu(NO3)2 and 0.400 M NH3. What are the concentrations of Cu2 , NH3, and Cu(NH3)42 at equilibrium? The formation constant*, Kf, of Cu(NH3)42 is 1.70 × 1013.

Subjects