Question

In: Chemistry

An HEXAPEPTIDE was sequenced using differing enzyme and chemical reagents. The results of these experiments, along...

An HEXAPEPTIDE was sequenced using differing enzyme and chemical reagents. The results of these experiments, along with an explanation of how to interpret the results are provided below. Using this information, provide the 1 ̊ structure for this HEXAPEPTIDE.

Show work/answer for points B-F

Observations from Sequencing Experiments

A. The amino acid content in the peptide was: Y, R, M, K, G, D

B. Reactions with the peptide and 1-fluoro-2,4-dinitrobenzene yielded DNP-G.

C. Treatment of the peptide with chymotrypsin yielded two tripeptides.

D. Treatment of the peptide with trypsin yielded three dipeptides.

E. Treatment of the peptide with carboxypeptidase yielded methionine.

F. N-terminal sequencing of one the chymotrypsin-produced tripeptides (from part C) yielded DNP-K.

Solutions

Expert Solution


Related Solutions

Using 1.0 nM enzyme X for the enzyme kinetics experiments, you obtained the reaction rates at...
Using 1.0 nM enzyme X for the enzyme kinetics experiments, you obtained the reaction rates at different concentrations of substrate (shown in the following table). Assume that the enzyme X follows a typical Michaelis-Menten kinetics. [substrate] (μM) Reaction rate (μmol/min) 2 7 5 17 10 29 20 44 50 67 100 80 200 89 500 95 1000 98 a) Estimate the Vmax and Km values of the enzyme in this reaction using double reciprocal plot. b) If 5.0 nM of...
Using 1.0 nM enzyme X for the enzyme kinetics experiments, you obtained the reaction rates at...
Using 1.0 nM enzyme X for the enzyme kinetics experiments, you obtained the reaction rates at different concentrations of substrate (shown in the following table). Assume that the enzyme X follows a typical Michaelis-Menten kinetics. [substrate] (μM) Reaction rate (μmol/s) 2 7 5 17 10 29 20 44 50 67 100 80 200 89 500 95 1000 98 a) Estimate the Vmax and Km values of the enzyme X in this reaction using the double reciprocal plot. b) If 5.0...
Studies (kinetic, stereochemical, chemical modification, and site-specific mutagenesis experiments) on the enzyme triosephosphate isomerase have identified...
Studies (kinetic, stereochemical, chemical modification, and site-specific mutagenesis experiments) on the enzyme triosephosphate isomerase have identified the B as Glu165 and HA as His95 (J. R. Knowles, Nature 350, 121 (1991). To aid your understanding, draw the active site as a pocket that extends into the enzyme and place the Flu and His on opposite sides of the pocket. Answer the following questions: a. Drawing of the pocket: b. How might the replacement of Glu with Asp affect the catalytic...
Experiments A and B are 2 experiments performed by mixing alkaline phosphatase enzyme with Pnpp substrate....
Experiments A and B are 2 experiments performed by mixing alkaline phosphatase enzyme with Pnpp substrate. The reaction was run for 5 minutes for each tube, then stopped by adding NaOH. A)Changing enzyme concentration Tube Reaction Buffer (mL) 5.4 mM of pNPP substrate (mL) 0.002 mg/ml of AP enzyme (mL) 3M of NaOH (mL) Absorbance Final Enzyme concentration (mM) Velocity (umol/min/mL) 1 3.41 0.04 0.05 0.875 0.284 2 3.36 0.04 0.1 0.875 0.387 3 3.31 0.04 0.15 0.875 0.509 4...
An experimenter performs two sets of enzyme kinetics experiments. One set of experiments, when plotted as...
An experimenter performs two sets of enzyme kinetics experiments. One set of experiments, when plotted as a double-reciprocal plot, yielded a y-intercept of 0.043 μM-1·min and an x-intercept of -20.0 mM-1. A second set of experiments, when similarly plotted, yielded a y-intercept of 0.129 μM-1·min and an x-intercept of -60.0 mM-1. The second set of experiments contained 92 nM of an uncompetitive inhibitor. Given these data, what is the Ki' (in nM to the nearest tenths) for this inhibitor? Hint:...
1. When an enzyme runs a chemical reaction, what happens to the enzyme at the end...
1. When an enzyme runs a chemical reaction, what happens to the enzyme at the end of the reaction? a) it is unchanged, and can run another reaction b) it is weakened, and is slower the next time c) it becomes part of the product, and is used up d) it is permanently damaged, or destroyed 2. When an enzyme accelerates a reaction rate, what does the enzyme do, thermodynamically (energy-wise)? a)lowers the activation energy for the reaction b) allows...
1.   The following data were obtained from 3 separate enzyme kinetic experiments using 3 different substrates...
1.   The following data were obtained from 3 separate enzyme kinetic experiments using 3 different substrates S1, S2 and S3 forming products P1, P2 and P3 respectively. The amount of enzyme in each reaction is 1 µM. Find out the rate and graph the data using a Michaelis-Menton and Lineweaver-Burk plots and determine the values for Km, Vmax, Kcat, and Kcat/Km. Which among the 3 substrate is best substrate for this enzyme and why? (4 points) [S] (mM)   [P1] (mM)...
Explain the “one gene – one enzyme hypothesis” and describe the experiments that led to the...
Explain the “one gene – one enzyme hypothesis” and describe the experiments that led to the development of this theory.
A chemist is performing four experiments and each experiment has five results. The results for each...
A chemist is performing four experiments and each experiment has five results. The results for each experiment are given in the following table. An experiment is considered successful if the average of the five test results for a given experiment is between 25 and 32. Using a nested loop, write a script that (Python): - Compute and display the test results average for each experiment - Indicate is the experiment was successful or not 1st Results 49.1 15.8 16.9 25.2...
The effect of an inhibitor on an enzyme was tested and the experiment gave the results...
The effect of an inhibitor on an enzyme was tested and the experiment gave the results below. Plot on Excel the data using a double-reciprocal plot (Lineweaver-Burke), determine Km and Vmax of the no inhibitor and each type of inhibitor and the type of inhibition that is occurring. [S] µM      V (µmol/min) V (µmol/min) V (µmol/min)                   with 0.0 nM    with 25 nM     with 50 nM                   Inhibitor          Inhibitor          Inhibitor ______      ___________ ___________ ___________                      0.4          0.22                0.21                 0.20...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT