A. Draw an op-amp circuit that will act as a comparator. Label the reference node, the...

A. Draw an op-amp circuit that will act as a comparator. Label the reference node, the input voltages and the output voltage.

B. Draw an op-amp circuit with an output voltage that is the integral of an input voltage over time. Label the reference node, the input voltage and the output voltage.

C. Explain what happens when a current-carrying wire moves through a static magnetic field. INCLUDE A DETAILED SKETCH.

D. Give a brief explanation of how a DC armature-controlled motor works. INCLUDE A SKETCH.

E. Explain the difference between a field-controlled motor and an armature-controlled motor. Include a simple diagram of a motor electrical system.

ANSWER THIS QUESTION FULLY WITH HANDWRITING THAT IS READABLE!!!!!!

Expert Solution

Manojponduru answered 2 years ago

Using known op amp configurations, design and draw an op amp circuit to convert Farenheit to...

Using known op amp configurations, design and draw an op amp circuit to convert Farenheit to Celcius. C=5/9(F-32)

Create a noninverting schmitt trigger using voltage divider as it reference voltage. Designt requirement: 1. Op-amp(comparator)...

Create a noninverting schmitt trigger using voltage divider as it reference voltage. Designt requirement: 1. Op-amp(comparator) with V+ as 5V and V- connected to ground 2. Assume input is noisy voltage 3. Output should display only high and low(ground voltage values) 4. How many threshold values are there?

Determine the gain of the op-amp circuit in Fig. E4.2.

Design a circuit using Op amp that will combine four voltages according to the following ratio....

Design a circuit using Op amp that will combine four voltages according to the following ratio. You can only use invertor amplifier . All input voltages are positive and you cannot tamper with the sources Vo = 4V1 - V2 - 8V3 - 2V4

Describe the conditions under which an op-amp circuit will oscillate. Provide a technique to avoid undesirable...

Describe the conditions under which an op-amp circuit will oscillate. Provide a technique to avoid undesirable oscillation. Explain why the gain-bandwidth product (GBW) is limited for any amplifier, and why GBW is constant for a fully compensated voltage feedback op-amp. If a fully compensated op-amp has GBW = 4 MHz, and its closed-loop amplifier circuit has gain (closed-loop gain) = 100, what is the loop gain at 100 Hz?

Create an Op AMP based circuit that converts a 2 Vpp 350 Hz Square wave (Vin)...

Create an Op AMP based circuit that converts a 2 Vpp 350 Hz Square wave (Vin) into a 4 Vpp 350 Hz Sine Wave (Vout) that is in phase with the square wave. Show this using Multisim (please attach multisim picture).

a) Draw and label your own circuit diagram using standard schematic symbols for a circuit with...

a) Draw and label your own circuit diagram using standard schematic symbols for a circuit with a 12 V battery, a 15 ohm resistor, a 400 mH inductor, and a switch, all in series. b) Write a diffferential equation (in the form of a loop equation) describing the behavior of this circuit after the switch is closed. c) The switch is first closed at time t = 0. Write down an equation for current in the circuit as a function...

Question

A. Draw an op-amp circuit that will act as a comparator. Label the reference node, the...

Solutions

Expert Solution

Related Solutions