How many studs are needed to construct 100 feet of a 2 x 4 stud wall?...

How many studs are needed to construct 100 feet of a 2 x 4 stud wall? The wall has one 8-footwide window, four 4-foot-wide windows, two 36-inch-wide doors, one 30-inch-wide door, four corners, two intersections, and eight hold downs located at corners. The stud spacing is 16 inches on center. Allow for two additional studs for each corner, intersection, or doorway; six additional studs for each window less than 6 feet in length; eight additional studs for each window 6 feet or more in width; and one additional stud for each hold down located at a corner

Solutions

Expert Solution

Ally Wells answered 5 months ago

Next > < Previous

Related Solutions

Consider a wall with the following dimensions: 120 feet long x 15 feet high x 9...

Consider a wall with the following dimensions: 120 feet long x 15 feet high x 9 inches thick. Also consider using a concrete pump with a capacity of 800 cubic feet per hour. Concrete mix consists of Type 1 concrete with retarder, and a unit weigh of 155 pcf. The maximum pressure applied on the wall form is approximately 2,200 psf. What is the rate of pour? What is the maximum temperature at which the concrete can be poured? Clearly...

How many 2 g tablets are needed to prepare 100 mL of a 10% solution?

Determine the quantity of grout needed for the wall in problem 6-1 if 18 cubic feet...

Determine the quantity of grout needed for the wall in problem 6-1 if 18 cubic feet of grout is required per 100 square feet of block. (Problem 6-1) Determine the number of 7 5/8-inch-high by 5 5/8-inch-wide by 15 5/8-inch-long concrete blocks required to complete a wall 80 feet long by 12 feet high. Allow for a 3/8-inch mortar joint.

Consider the reaction: P4 + 6Cl2 -> 4PCl3. a. How many grams of Cl2 are needed to react with 20.00 g. of P4?

Consider the reaction: P4 + 6Cl2 -> 4PCl3. a. How many grams of Cl2 are needed to react with 20.00 g. of P4? __________ b. You have 15.00 g. of P4 and 22.00 g. of Cl2, identify the limiting reactant and calculate the grams of PCl3 that can be produced as well as the grams of excess reactant remaining. LR _________ grams PCl3 ___________ grams excess reactant ________ c. If the actual amount of PCl3 recovered is 16.25 g., what...

How many 100 gram scored tablets are needed to make 0.5 liter of a 50% solution?

Approximately how many flops are needed to find the LU factorization of an n x n...

Approximately how many flops are needed to find the LU factorization of an n x n matrix using Doolittle’s method? If a computer requires 1 second to find an LU factorization of a 500 x 500 matrix, what would you estimate is the largest matrix that could be factored in less than 1 hour?

. [4 pts] The temperature of a 4 foot metal rod at a point x feet...

. [4 pts] The temperature of a 4 foot metal rod at a point x feet from its left endpoint is given by T(x) = 1 + 3x 2 , 0 ≤ x ≤ 4, where T is measured in degrees Celsius (and x is measured in feet). Find the average temperature of the rod. 5. [6 pts] A particle moves along a coordinate line and has an acceleration given by a(t) = 4t+ 6 cm/sec2 . If the particle’s...

How many grams of CuSO4 (dot) H2O are needed to prepare 50 mL of a 4%...

How many grams of CuSO4 (dot) H2O are needed to prepare 50 mL of a 4% (w/v)solution of CuSO4?

Part A: How many mL of a 100 mg/dL Ferrozine solution are needed to complex 5.5×10−8...

Part A: How many mL of a 100 mg/dL Ferrozine solution are needed to complex 5.5×10−8 moles of iron? Part B: How many moles of Fe3+ can be reduced by 1.3 mL of 0.291 M hydroxylamine solution? Part C: As part of this laboratory, you may have to add iron to a solution. If you have 16 mL of a solution that contains 37 μg dL-1, how many mL of 500 μg dL-1 iron must be added to reach a concentration of 150 μg dL-1?...

2. How many ATP molecules are needed to give 22 kcal of energy? How much energy...

2. How many ATP molecules are needed to give 22 kcal of energy? How much energy is given by 7.5 moles of ATP? 5. How many ATP will be produced if maltose is degraded and it undergoes glycolytic pathway only? 6. How many ATP will be produced if maltose is completely oxidized through cellular respiration? 7. How many ATP will be produced if the amino acid leucine will be used as a metabolite in the krebs cycle?

Subjects