Let's consider a four-cylinder engine with phase angles of 0o,90o,270,o180o. Commute mass for each cylinder 2kg,...

Let's consider a four-cylinder engine with phase angles of 0^o,90^o,270,^o180^o. Commute mass for each cylinder 2kg, crank length 50 mm, connecting rod 250mm, distance between cylinder axes 150 mm. The crankshaft rotates at a constant speed of 800 rpm. According to the given, find the shaking moment acting on the motor block due to imbalance.

Solutions

Expert Solution

Detailed answer of above asked question is solved as below.

samet mamat answered 7 months ago

Next > < Previous

Related Solutions

Calculate air to fuel ratio by mass, for a four-cylinder SI engine running on i) gasoline...

Calculate air to fuel ratio by mass, for a four-cylinder SI engine running on i) gasoline and ii) a mixture of 20% methanol and 80% gasoline both at stoichiometric conditions. Assume gasoline is represented with C8H18 . Calculate any loss of power when gasoline-methanol mixture is used and discuss your results.

A single-cylinder, four stroke research engine operates on Otto cycle. The specification of the engine is...

A single-cylinder, four stroke research engine operates on Otto cycle. The specification of the engine is shown as below:- Displacement volume of the cylinder = 540 cm3 Clearance volume of the cylinder = 60 cm3 Minimum temperature = 200°C Minimum pressure = 200 kPa Net work output = 1000 kJ/kg Sketch the process on a P-V diagram and by using constant specific heat at room temperature, determine: i) the temperature and pressure at each process, ii) the thermal efficiency of...

A four-cylinder four-stroke engine is operating at a bmep of 2 bar. The pressure at inlet...

A four-cylinder four-stroke engine is operating at a bmep of 2 bar. The pressure at inlet valve closure is 0.37 bar, and the fmep is 0.8 bar. Assuming that the engine gross indicated efficiency is unchanged, verify that disablement of the valves on two cylinders would reduce the fuel consumption by about 13 per cent compared with about an 8 per cent fuel saving if the fuel was not supplied to two cylinders. Assume that the gross imep is proportional...

A four-cylinder petrol engine has a swept volume of 2000 cm3, and the clearance volume in...

A four-cylinder petrol engine has a swept volume of 2000 cm3, and the clearance volume in each cylinder is 60 cm3. Calculate the air standard cycle efficiency. If the introduction conditions are 1 bar and 24 ?C, and the maximum cycle temperature is 1400 ?C, calculate the mean effective pressure based on the air standard cycle. ANSWERS(59.1%; 5.30 bar)

A two-cylinder, four-stroke gas engine has a bore of 380 mm and a stroke of 585...

A two-cylinder, four-stroke gas engine has a bore of 380 mm and a stroke of 585 mm. At 240 rev/min the torque developed is 11.86 kNm. If the engine is supplied with a mixture of gas and air in the proportion of 1 to 7 by volume. The estimated volumetric efficiency is 85% and the Qnet,p of the gas is 38.6 MJ/m3. Calculate the brake thermal efficiency of the engine.

A test was conducted on a 4-stroke four cylinder engine having 6.9 cm diameter and 8.9...

A test was conducted on a 4-stroke four cylinder engine having 6.9 cm diameter and 8.9 cm stroke. The fuel supply to the engine is 0.065 kg/min. The B.P measurements are given below with constant engine speed of 300 rpm: With all cylinder firing = 16.9 kW Cut off at 1st cylinder = 8.46 kW Cut off at 2nd cylinder = 8.56 kW Cut off at 3rd cylinder = 8.6 kW Cut off at 1st cylinder = 8.46 kW If...

mechanical vibration Consider a single cylinder engine such as the one shown here where r is...

mechanical vibration Consider a single cylinder engine such as the one shown here where r is the radius of crank (5.0 cm), l is the length of the connecting rod (16 cm), Mp is the effective mass of piston (1.5 kg), M is total mass of engine (75 kg), w is the engine speed (24p rad/s), k is the spring constant (220 KN/m), and z is the damping ratio (0.02). Assume that the crank and the remaining portion of the...

(a) Find four angles, one in each of the quadrants, with the reference angle of 4◦...

(a) Find four angles, one in each of the quadrants, with the reference angle of 4◦ . Your angles should be between 0◦ and 360◦ . That is, for all four of your angles θ, 0 ◦ ≤ θ ≤ 360◦ . (b) Find an angle A with 0◦ < A < 360◦ that has the same sine as θ = 4◦ (but is not θ = 4◦ ). (c) Find an angle with 0◦ < A < 360◦ that...

The displacement volume of an internal combustion engine is 2.19 liters. The processes within each cylinder...

The displacement volume of an internal combustion engine is 2.19 liters. The processes within each cylinder of the engine are modeled as an air-standard Diesel cycle with a cutoff ratio of 2.5. The state of the air at the beginning of compression is fixed by p1 = 1.6 bar, T1 = 325 K and V1 = 2.36 liters. If the cycle is executed 2100 times per min, determine: a) the compression ratio, b) the net work per cycle, in kJ,...

The displacement volume of an internal combustion engine is 2.22 liters. The processes within each cylinder...

The displacement volume of an internal combustion engine is 2.22 liters. The processes within each cylinder of the engine are modeled as an air-standard Diesel cycle with a cutoff ratio of 2.5. The state of the air at the beginning of compression is fixed by p1 = 1.6 bar, T1 = 325 K and V1 = 2.36 liters. If the cycle is executed 2100 times per min, determine: a) the compression ratio, b) the net work per cycle, in kJ,...

Subjects