Question

In: Chemistry

Starting with 1.2 g of trans-chalcone and 0.85 g of ethyl acetoacetate, you obtained 1.64 g...

Starting with 1.2 g of trans-chalcone and 0.85 g of ethyl acetoacetate, you obtained 1.64 g of the final product. Calculate the theoretical and percentage yield of the reaction.

Solutions

Expert Solution


Related Solutions

Suppose you disolve 1.2 g of KH2PO4 in 1L of water and then adjust the pH...
Suppose you disolve 1.2 g of KH2PO4 in 1L of water and then adjust the pH of the solution to 6.8. What are the concentrations of the species listed below? A) [H3PO4] B) [H2PO−4] C) [HPO−24] D) [PO−34]
If you started with 0.100g of tetraphenylcyclopentadienone and 0.100g of diphenylacetylene and obtained 0.089 g of...
If you started with 0.100g of tetraphenylcyclopentadienone and 0.100g of diphenylacetylene and obtained 0.089 g of hexaphenylbenzene from the experiment. Calculate percent Yield of hexaphenylbenzene? Tetraphenylcyclopentadienone MolarMass= 384.478g/mol diphenylacetylene MolarMass = 178.24 g/mol
Given any positive integer n, the hailstone sequence starting at n is obtained as follows. You...
Given any positive integer n, the hailstone sequence starting at n is obtained as follows. You write a sequence of numbers, one after another. Start by writing n. If n is even, then the next number is n/2. If n is odd, then the next number is 3n + 1. Continue in this way until you write the number 1. For example, if you start at 7, then the next number is 22 (3 × 7 + 1). The next...
When trans-cinnamic acid reacts with bromine, the product is 2,3-dibromo-3-phenylpropanoic acid. You measure out 0.30 g...
When trans-cinnamic acid reacts with bromine, the product is 2,3-dibromo-3-phenylpropanoic acid. You measure out 0.30 g of trans-cinnamic acid, 10 mL of dichloromethane, and a 0.5M solution of bromine. When the reaction is finished, you have 0.223 grams of 2,3-dibromo-3-phenylpropanoic acid. A. How many moles of trans-cinnamic acid was used? B. What is the limiting reagent? C. What is the theoretical yield (in moles)? D. What is the actual yield (in moles)? E. What is the total percent yield?
Assume that Kish Inc. hired you as a consultant to help estimate its cost of capital. You have obtained the following data: D0 = $1.00; P0 = $25.00; and g = 7.00% (constant).
Assume that Kish Inc. hired you as a consultant to help estimate its cost of capital. You have obtained the following data: D0 = $1.00; P0 = $25.00; and g = 7.00% (constant). Based on the DCF approach, what is the cost of equity from retained earnings? Do not round your intermediate calculations.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT