Question

Discuss the installation procedure for an optical drive, and note how this procedure changes depending on the interface. Also, explain when drivers are unnecessary to install in some cases. Discuss the need to set a drive to either master or slave and what types have this feature. Please explain in one page.

Answer 1

Installation procedure is as follows :

1. match the drive into a spare drive bay

2. match the IDE Cable(wide ribbon cable) Plug the cable in gently and as straight as attainable thus as to not bend any pins on the drive.

3. match the ability cable.

4. match the IDE cable into the motherboard.

Changes looking on interface :

The first installation selections area unit whether or not to put in the drive on the first or Secondary ATA interface and whether or not to assemble the drive because the master or slave device. If you're upgrading associate degree existing drive or substitution a unsuccessful drive, it'd appear cheap to assemble the new drive identical manner the recent drive was designed. that is not continually true. several systems have non-optimal interface configurations.

The issue is that though PATA interfaces enable 2 devices to be connected, only 1 will be active at a time. So, as an example, once a tough drive connected to the first ATA channel is reading or writing knowledge, associate degree optical drive connected to identical channel should wait till the disc drive finishes exploitation the channel before it will browse or write knowledge. every device should take its flip, that slows performance of each devices once they area unit in use at the same time.