Exhaust gases from a manufacturing plant are being discharged through a 10-m-tall exhaust stack with outer...

Exhaust gases from a manufacturing plant are being discharged through a 10-m-tall exhaust stack with outer diameter of 1.2 m. The exhaust gases are discharged at a rate of 1.2 kg/s, while temperature drop between inlet and exit of the exhaust stack is 30°C, and the constant pressure specific heat of the exhaust gasses is 1600 J/kg·K. On a particular day, wind at 27°C is blowing across the exhaust stack with a velocity of 10 m/s, while the outer surface of the exhaust stack experiences radiation with the surrounding at 27°C. Solar radiation is incident on the exhaust stack outer surface at a rate of 1400 W/m2, and both the emissivity and solar absorptivity of the outer surface are 0.9. Determine the exhaust stack outer surface temperature in oC. The properties of air at 80°C are k = 0.02953 W/m?K, v = 2.097 × 10?5 m2/s, and Pr = 0.7154. (Round the final answer to two decimal places.)

Expert Solution

if you like my answer....plz do upvote

samet mamat answered 2 years ago

Exhaust gases having properties similar to dry air enter a thin-walled square duct exhaust stack at...

Exhaust gases having properties similar to dry air enter a thin-walled square duct exhaust stack at 500 ºC. The stack is made of galvanized iron and is 20 m tall and 0.25 m side. If the gas flow rate is 0.5 kg/s and the stack surface has the outside ambient temperature of 10 ºC estimate: a) the outlet temperature of the exhaust gas b) the heat transfer coefficient c) the rate of heat transfer d) the pressure drop

Hot water from a boiler of power plant are discharged through a 0.2-m-diameter, thin-walled pipe with...

Hot water from a boiler of power plant are discharged through a 0.2-m-diameter, thin-walled pipe with a velocity of 3.5 m/s. The pipe passes through a room whose air temperature is 3°C and the exterior surface of the pipe is uninsulated and pipe length is 30 m. (a) At a position in the pipe where the mean water temperature is 40°C, determine the heat loss and the pipe wall temperature. (b) If the pipe is covered with a 20-mm-thick layer...

Flue gases from an incinerator are released to atmosphere using a stack that is 0.62 m...

Flue gases from an incinerator are released to atmosphere using a stack that is 0.62 m in diameter and 10.0 m high. The outer surface of the stack is at 45°C and the surrounding air is at 10°C. Determine the rate of heat transfer from the stack, assuming a. there is no wind and, b. the stack is exposed to 21 km/h winds.

Assume the water for a boiler is preheated using flue gases from the boiler stack. The...

Assume the water for a boiler is preheated using flue gases from the boiler stack. The flue gases are available at a rate of 0.25 kg/s at 150°C, with a specific heat of 1000 J/kg · K. The water entering the exchanger at 15°C at the rate of 0.05 kg/s is to be heated to 90°C. The heat exchanger is to be of the type with one shell pass and four tube passes. The water flows inside the tubes, which...

Airflow through a long, 0.15-m-square air conditioning duct maintains the outer duct surface temperature at 10°C....

Airflow through a long, 0.15-m-square air conditioning duct maintains the outer duct surface temperature at 10°C. If the horizontal duct is uninsulated and exposed to air at 35°C in the crawlspace beneath a home, what is the heat gain per unit length of the duct? Evaluate the properties of air at 300 K. For the sides of the duct, use the more accurate Churchill and Chu correlations for laminar flow on vertical plates. What is the Rayleigh number for free...

1.Water samples were taken from water used for cooling as it was being discharged from a...

1.Water samples were taken from water used for cooling as it was being discharged from a power plant into a river. It has been determined that as long as the mean temperature of the discharged water is at most 150 F, there will be no negative impact on the river's ecosystem. To investigate whether a plant is in compliance with regulations that prohibit a mean discharge water temperature above 150 F, researchers took 50 water samples at randomly selected times...

Brenda is a 26 year old female who is being discharged from the hospital after a...

Brenda is a 26 year old female who is being discharged from the hospital after a vaginal delivry of 8 pound healthy infant. Brenda is instructed by the nurse to eat a diet high in fiber and 8 glasses of water per day to prevent constipation. Rxplain the role of fiber and water to promote defecation

The rate of emission of SO2 from the stack of a power plant is 150 gm/sec....

The rate of emission of SO2 from the stack of a power plant is 150 gm/sec. The stack height is 50 m. Calculate the effective plume height on a sunny September day when the wind velocity is 5 m/sec. Use Class B stability. The effluents are being released at 10m/s and at a temperature of 310oK. The atmospheric temperature is 293oK. The stack diameter is 0.5 m

- Sulphur dioxide is being emitted at a rate of 2.5 kg/s from a stack with...

- Sulphur dioxide is being emitted at a rate of 2.5 kg/s from a stack with an effective height of 160m (H). The average wind speed at stack height is 2.0 m/s in an atmospheric stability type B. a) Estimate the magnitude and location of the maximum ground level concentration. b) Estimate the magnitude and location of the maximum ground level concentration if the wind speed is doubled. c) Estimate the magnitude and location of the maximum ground level concentration...

Steam in a heating system flows through tube whose outer diameter is 10 cm and whose...

Steam in a heating system flows through tube whose outer diameter is 10 cm and whose walls are maintained at a temperature of 150°C. Circular aluminum alloy 2024-T6 fins (k = 186 W/m · °C) of outer diameter 15 cm and constant thickness 2 mm are attached to the tube. Heat is transferred to the surrounding air at T∞ = 25°C, with a heat transfer coefficient of 50 W/m2 C . If the total tube length is 5 m and...

Question