Question

In: Chemistry

How to calculate theoritical NOx and SO2 (mg/Nm3) in gases at coal fired power plant, if...

How to calculate theoritical NOx and SO2 (mg/Nm3) in gases at coal fired power plant, if known :

Coal Calorific Value = 4500 kcal/kg
Fuel consumption = 180 t/h
Excess air = 18%
Oxygen in exhaust gases = 5%
Flue Gas Temperature in exhaust gases = 135 deg C

Carbon Content = 30.110
Hydrogen Content = 3.610
Oxygen Content = 9.850
Sulfur Content = 0.330
Nitrogen Content = 0.700
Ash Content = 5.740
Moisture Content = 32.530

Thank you!

Solutions

Expert Solution


Related Solutions

1000 MW coal-fired power plant emits SO2 at the legally allowed limit of 6.47 x 108...
1000 MW coal-fired power plant emits SO2 at the legally allowed limit of 6.47 x 108 g/sec (equivalent to 0.6 lb per 106 BTU). The stack has an effective height of 300 m. It is a cloudy summer day and the wind speed at 10-m is measured at 2.5 m/sec. What is the ground level concentration of SO2 4 km directly downwind. Assume a value for “p” of 0.25.EnvEng please help me solve! thanks!
A coal-fired power plant produces power  with costs . Each unit of power earns the plant ....
A coal-fired power plant produces power  with costs . Each unit of power earns the plant . Burning coal releases particulate matter (PM2.5), a pollutant that is known to cause heart disease, lung disease, and birth defects. The coal plant borders a wildlife sanctuary which sells tourism visits  for a price $30. However, the sanctuary's animals are getting sick due to the negative externality of PM2.5, such that the costs to the sanctuary are . The local government decides to tax the...
At a coal-fired power plant, assume that lignite coal is being burned as shown in the...
At a coal-fired power plant, assume that lignite coal is being burned as shown in the following stoichiometric combustion reaction equation, which assumes that the nitrogen in the lignite and in the air is all converted to NO and that combustion is complete: CH0.96O0.18N0.016S0.012 + x (O2 + 3.78 N2) → CO2 + 0.48 H2O + 0.016 NO + 0.012 SO2 + 3.78x N2 (a) What is the value of the coefficient, x? (b) To ensure complete combustion, air must...
Consider a coal-fired steam power plant that produces 175 MW of electric power. The power plant...
Consider a coal-fired steam power plant that produces 175 MW of electric power. The power plant operates on a simple ideal Rankine cycle with turbine inlet conditions of 7 MPa and 550°C and a condenser pressure of 15 kPa. The coal has a heating value (energy released when the fuel is burned) of 29,300 kJ/kg. Assuming that 75% of this energy is transferred to the steam in the boiler and that the pump has an efficiency of 80% and the...
If a coal-fired power plant burns 2 kg of coal to produce electricity, and the electricity...
If a coal-fired power plant burns 2 kg of coal to produce electricity, and the electricity is used to power an elevator motor that is 60% efficient, how high can the elevator and passengers be lifted up if their total mess is 1500 kg? and then How many human workers using muscle power('energy servants") would be needed to lift the elevator up to the same height, if they had one minute to do so? Assuming that one energy servant is...
Your power plant emits nitrous oxides (NOx) into the atmosphere as a byproduct of burning coal....
Your power plant emits nitrous oxides (NOx) into the atmosphere as a byproduct of burning coal. While your scrubbers collect much of the pollutant before it leaves your smokestacks, they cannot get it all. You have an allowance of one hundred pounds of NOx per day. The state environmental commission shows up periodically to test whether you are staying within your allowance. If you are not within your allowance, you will have to purchase more allowance from a plant that...
A coal-fired power plant proposes to burn 3% sulfur coal with a heating value of 11,000...
A coal-fired power plant proposes to burn 3% sulfur coal with a heating value of 11,000 Btu/lb. If the plant is to meet the standard of performance given by EPA New Source Performance Standards (NSPS), what percent cleanup is required for SO2? What percent sulfur could the coal contain if the standards are to be met with no clean-up devices?
Explain how the sulfur dioxide released in a coal-fired power plant in the U.S. can decrease...
Explain how the sulfur dioxide released in a coal-fired power plant in the U.S. can decrease the pH of a lake in Canada. Describe how nitrogen oxides form HNO3 in the atmosphere.
A 600 MW pulverized coal-fired power plant of 40% efficiency uses coal with an ash content...
A 600 MW pulverized coal-fired power plant of 40% efficiency uses coal with an ash content of 15% and a heating value of 26,700 kJ/kg. Assume 35% of the ash content goes up the stack as particulate matter in the flue gas. The PM emission is controlled by an ESP which has the following efficiencies and weight distribution in the given size ranges. Find the fly ash emitted in g/s.
A coal-fired power plant uses 400 ◦C steam to turn a turbine. Afterwards, the steam is...
A coal-fired power plant uses 400 ◦C steam to turn a turbine. Afterwards, the steam is condensed at a temperature of 25 ◦C. If the plant burns 1 million kg of coal in one hour, running at maximum efficiency, what is the amount of work that could be done by the turbine in that hour? (Coal contains 27 kJ of energy per g).
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT