Question

In: Physics

1. The input and output pistons of a hydraulic lift have circular tops. The radius of...

1.

The input and output pistons of a hydraulic lift have circular tops. The radius of the output piston is 74.3 times the radius of the input piston. Neglecting friction: find the minimum force, in N, that must be applied to the input piston so the output piston raises a trash bin of mass 25,547 kg.    

2.

A cube of mass 9.36 kg floats in a liquid of specific gravity 1.31 with 22.4% of its volume submerged. Find the length of one side of the cube, in m.

Solutions

Expert Solution


Related Solutions

A hydraulic lift in a garage has two pistons: a small one of cross-sectional area 4.50cm2...
A hydraulic lift in a garage has two pistons: a small one of cross-sectional area 4.50cm2 and a large one of cross-sectional area 220cm2 . There are two parts to this question please give CORRECT answer. Part A If this lift is designed to raise a 3400-kg car, what minimum force must be applied to the small piston? Part B If the force is applied through compressed air, what must be the minimum air pressure applied to the small piston?
A hydraulic lift has two connected pistons with cross-sectional areas 10 cm2 and 490 cm2. It...
A hydraulic lift has two connected pistons with cross-sectional areas 10 cm2 and 490 cm2. It is filled with oil of density 700 kg/m3. 1. What mass must be placed on the small piston to support a car of mass 103 kg at equal fluid levels? m = 20.41kg 2. With the lift in balance with equal fluid levels, a person of mass 60 kg gets into the car. What is the equilibrium height difference in the fluid levels in...
A hydraulic jack is designed to lift a car by exerting an output force 100 times...
A hydraulic jack is designed to lift a car by exerting an output force 100 times as large as the input (see class notes). (a) What must be the ratio of the cylinder diameter on the output side to that on the input side? (b) If the input side is pushed down by 10 cm, how much does the output side move up? (The fluid volume lost on the input side is gained on the output side.) (c) Show that...
Question 1 Calculate the Hydraulic Radius for a trapezoidal channel that has a bottom width of...
Question 1 Calculate the Hydraulic Radius for a trapezoidal channel that has a bottom width of 4 feet, side slopes, s = 20, a Manning’s n value of 0.012, and bottom slope of 1.5%, and a depth of flow of 1 foot. a. 0.54 ft b. 1.3 ft c. 2.1 ft d. 2.9 ft e. 3.7 ft 2 points Question 2 A trapezoidal channel that has a bottom width of 4 feet, side slopes 2:1 (H:V) and bottom slope of...
1. Jackson's new plant makes pistons where the variation in radius must be minimal. You sample...
1. Jackson's new plant makes pistons where the variation in radius must be minimal. You sample 24 pistons and find a standard deviation of 1.63 mm. Assuming the radii to be normally distributed, ind: a.The 98% confidence for the population std.dev. 2. You live near a Mac Donnel's and want to find the population parameters for the number of visits from a neighborhood similar to yours on a typical week. a. You ask 73 on Ken's neighbor and get the...
1.Consider a satellite of the earth in a circular orbit of radius R. Let M and...
1.Consider a satellite of the earth in a circular orbit of radius R. Let M and m be the mass of the earth and that of the satellite, respectively. Show that the centripetal acceleration of the satellite is aR = -(v^2/R)*(r/r) where v = |v| is the magnitude of the velocity V and r/r is a unit vector in the radial direction. 2.Using Newton's second low of motion and the law of universal gravitation, determine the speed v=|V| and the...
1. A certain satellite travels in an approximately circular orbit of radius 7.5 × 106 m...
1. A certain satellite travels in an approximately circular orbit of radius 7.5 × 106 m with a period of 6 h 27 min. Calculate the mass of its planet from this information 2. (a) At what height above Earth's surface is the energy required to lift a satellite to that height equal to the kinetic energy required for the satellite to be in orbit at that height? (b) For greater heights, which is greater, the energy for lifting or...
Consider 2-bit input functions that has either constant output (0 or 1) or balanced output (the...
Consider 2-bit input functions that has either constant output (0 or 1) or balanced output (the number of {0,1} outputs are equal to each other). First a class is selected with1/2 probability and then one of the functions that belong to the chosen class is selected uniform randomly. We would like to guess the class of the function with minimum function evaluations. • What is the average number of guesses before we identify the chosen class using classical bits? •...
1. Khalif runs a full lap around a circular track of radius 20 m in 100...
1. Khalif runs a full lap around a circular track of radius 20 m in 100 s. What is the magnitude of his average velocity? 2. A 10 Newton force is needed to move an object with a constant velocity of 5.0 m/s. What power must be delivered to the object by the force? 3. A ball is kicked horizontally with an initial speed of 8.0 m/s from the edge of a cliff. A stop watch measures the ball’s trajectory...
1. Suppose that output q is a function of a single input, labor (L). Describe the...
1. Suppose that output q is a function of a single input, labor (L). Describe the returns to scale associated with each of the following production functions: a. q = 3L. Answer: b. q = L3. Answer:
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT