1. Discuss what will happen to the modulation process of an amplitude modulation (AM) signal if...

1. Discuss what will happen to the modulation process of an amplitude modulation (AM) signal if the carrier signal level remains constant and the sideband signal level increases and justify your answer

2. A normal modulation usually has a modulation index ranges from 0 to 1 but in some rare cases, the modulation index can be greater than 1. Discuss what will happen to the output of the receiver if this situation happens.

Expert Solution

Manojponduru answered 1 year ago

Please type at least 100 words: Compare AM (Amplitude Modulation) with FM (Frequency Modulation) in the...

Please type at least 100 words: Compare AM (Amplitude Modulation) with FM (Frequency Modulation) in the context of modulation techniques, frequency range, bandwidth requirements, complexity, noise, and hardware.

there is a sinusoidal message signal (f = 100 Hz). Make amplitude modulation with carrier frequency...

there is a sinusoidal message signal (f = 100 Hz). Make amplitude modulation with carrier frequency of 10KHz. Use three different modulation depths / indices (0.2 /0.60/0.8). Then demodulate this mixed signal (for these three cases) by try to get message signals. (need matlab codes and graphs)

2. An AM radio station broadcasts a signal at a carrier frequency ωc, with an amplitude...

2. An AM radio station broadcasts a signal at a carrier frequency ωc, with an amplitude modulation frequency of ωm << ωc, E(t) = E0[1 + A sin(ωmt)] sin(ωct) Show that this is the sum of a wave at the carrier frequency, the lower sideband (ωL = ωc−ωm), and the upper (high) sideband (ωH = ωc + ωm). What total bandwidth is required if the radio station wants to broadcast music that contains modulation frequency components from 20 to 10,000...

Q.N. 1:- An AM index between 0 and 1 indicates what? a. the AM signal is...

Q.N. 1:- An AM index between 0 and 1 indicates what? a. the AM signal is very small and will not be detected by the receiver b. distortion of the signal will prevent detection and demodulation c. the received modulated signal will have minimal distortion d. the AM index is not important Q.N. 2:- Given the following AM modulated signal, determine the original message, m(t): s(t) = 2.5[1+0.5 cos(2π25kHzt)] cos(2π88MHzt) a. m(t) = 1.25cos(2π25kHz*t) b. m(t) = 1.25cos(2π88MHz*t) c. m(t)...

what is the general trend for changes in amplitude of the EMG signal during an isometric...

what is the general trend for changes in amplitude of the EMG signal during an isometric fatiguing task?

1. What are two outcomes that may happen as a result of signal transduction? - one...

1. What are two outcomes that may happen as a result of signal transduction? - one is fast other is slow 2. Why is it better for cells to have pathways that have a small amount of “steps” and pathways that have a greater number of “steps” in their pathways? -think RTK/Ras/MapK versus JAK/STAT

Explain mathemetically and with diagrams, what is single sideband amplitude modulation? kindly Answer ASAP. Ill give...

Explain mathemetically and with diagrams, what is single sideband amplitude modulation? kindly Answer ASAP. Ill give u upvote

What is the amplitude of a typical ECG signal is as measured directly from skin surface...

What is the amplitude of a typical ECG signal is as measured directly from skin surface electrodes? How will this answer guide your amplifier design? What features can you incorporate in your measurement device to reduce noise (especially at 60 Hz)?

Faraday's Law: What would you observe about the amplitude of an induced signal as the frequency...

Faraday's Law: What would you observe about the amplitude of an induced signal as the frequency varied? Describe whether the behavior is consistenent with Eq. 3 (Vo= w(Nd)A(Bo)cos(theta)). In particular what should your graph of amplitudes against frequencies look like according to Eq 3? In comparisons with the predictions of Eq 3, why would it be important to adjust the function generator to keep the amplitude of the B field the same at each frequency?

what will happen when you loose a lot of blood (hemorrhage) 1. signal to NTS increase...

what will happen when you loose a lot of blood (hemorrhage) 1. signal to NTS increase 2. veins smooth muscle contraction goes up 3. vasodilation 4. increased stimulation of SA node 5. nothing

Question