Question

In: Mechanical Engineering

1. When recovery/recycling equipment is used to remove refrigerant from a mobile A/C system, how much...

1. When recovery/recycling equipment is used to remove refrigerant from a mobile A/C system, how much lubricant will be removed during operation?
A. 4 ounces
B. Generally, very lttle, if any
C. The complete system lubricant charge
D. At least 6 ounces

2. Which SAE standard(s) must be referred to on the label of approved HFC-134a refrigerant recycling machines?

A. SAE J1988 or SAE J1627
B. SAE J1989 or SAE J2791
C. SAE J1990 or SAE J2297
D. SAE J2210 or SAE J2788

3. CFC-12 recovery equipment has SAE 3/8-inch service fittings. HFC- 134a recovery equipment has:
A. 1/2 inch Acme threads
B. 10 mm threads
C. Quick-couple design
D. Same as CFC-12 recovery equipment

4. To recover and recharge refrigerant from an HFO-1234yf system, a shop will need:
A. Only a new storage tank
B. A new recovery, recycling and recharging machine
C. No new equipment
D. A new compressor

5. To what does Global Warming Potential (GWP) refer?
A. Relative ability to warm a car cabin
B. Relative ability to produce global warming effect
C. A global attempt to address global warming
D. Relative ability to cool the planet

Solutions

Expert Solution

Answer 1. b. Generally, very little if any

Answer 2. d. SAE J2210

Answer 3. c . They are facilitated with quick connection design.

Answer 4. b. One cannot retrofit it with R-134a. Reason is its cost. Due to its similarity they are replacing H134a but to introduce new service new equipment will be required. In order to service HFO-1234yf systems, shops will need an SAE J2843 R/R/R machine, an SAE J2912 or J2927 Refrigerant Analyzer, and an SAE J2913 leak detector. These tools are mandatory to comply with the EPA law.

Answer.5 b.Global warming potential (GWP) is a relative measure of how much heat a greenhouse gastraps in the atmosphere. It compares the amount of heat trapped by a certain mass of the gas in question to the amount of heat trapped by a similar mass of carbon dioxide.

Please kindly refer answer..these are based upon studies from several articles..


Related Solutions

A heat pump-bases HVAC system can remove heat from a building by (a) compressing the refrigerant...
A heat pump-bases HVAC system can remove heat from a building by (a) compressing the refrigerant to make it hotter than the outside air (b) compressing the refrigerant to make it cooler than the outside air (c) expanding the refrigerant to make it hotter than the outside air (d) blowing the heat out of the building using a fan
Answer these and explain your reasoning. 1. How much energy would it take to remove the...
Answer these and explain your reasoning. 1. How much energy would it take to remove the electron from unexcited hydrogen completely so that it is no longer bound to its proton? 2. Suppose a hydrogen atom in the n=3 state emitted light by decaying into the n=2 state. What color would that light be seen as? What about one starting at n=4 and ending in n=2? Can a hydrogen atom emit infrared light and end up in the n=2 state?...
How much energy would be needed to remove three electrons from a ground state beryllium atom?
The following are all ionization energies for beryllium.     1st Ionization     2nd Ionization     3rd Ionization     4th IonizationEnergy (kJ/mol)89917571484521000How much energy would be needed to remove three electrons from a ground state beryllium atom?
How do I remove a node from a linked list C++? void LinkedList::Remove(int offset){ shared_ptr<node> cursor(top_ptr_);...
How do I remove a node from a linked list C++? void LinkedList::Remove(int offset){ shared_ptr<node> cursor(top_ptr_); shared_ptr<node> temp(new node); if(cursor == NULL) { temp = cursor-> next; cursor= temp; if (temp = NULL) { temp->next = NULL; } } else if (cursor-> next != NULL) { temp = cursor->next->next; cursor-> next = temp; if (temp != NULL) { temp->next = cursor; } } }
1. Explain how to record the recovery of an account previously written off when the direct...
1. Explain how to record the recovery of an account previously written off when the direct write-off method was used. 2. Explain how to record the recovery of an account previously written off when the allowance method was used. 3. Describe the financial statement presentation of both the allowance for uncollectible accounts and the loss from uncollectible accounts
What digits are used in binary number system? How much is 305.511 in binary form?
What digits are used in binary number system? How much is 305.511 in binary form?
Question 1 a. How much governmental financial information is used by citizens? From what sources? b....
Question 1 a. How much governmental financial information is used by citizens? From what sources? b. How is governmental financial information filtered by information intermediaries, such as the newspaper and interest groups? With what effect? In a short paper, debate its relevance for your country in the present day and age. Explain how you would conduct the necessary research to answer your chosen question.
How much energy is given off when 55g of steam at 155 C is cooled to...
How much energy is given off when 55g of steam at 155 C is cooled to water at 75 C. Given: C steam:2.0 J/gc C water:4.18 J/g C ice:2.03 J/gc deltaH(vap)=40.7 Kj/mol deltaH(fus): 6.02 Kj/mol
How much heat is required to raise an 820g copper pan from 11?C to 91?C if...
How much heat is required to raise an 820g copper pan from 11?C to 91?C if (a) the pan is empty; (b) the pan contains 1.4kg of water; and (c) the pan contains 3.8kg of mercury? Part A Express your answer using two significant figures. ?Qa =   kcal   SubmitMy AnswersGive Up Part B Express your answer using two significant figures. ?Qb =   kcal   SubmitMy AnswersGive Up Part C Express your answer using two significant figures. ?Qc =   kcal  
Synthesis of aspirin lab when 5 grams of salicylic acid is used: how much of ACETIC...
Synthesis of aspirin lab when 5 grams of salicylic acid is used: how much of ACETIC acid in mL should be used ( I KNOW ACETIC ANHYDRIDE IS BETTER BUT I AM ASKING FOR ACETIC ACID)? how many drops of Phosphoric acid should be used? How long should the mixture be heated? What tempture should it be heated at? How much DI water should be added (one mL at a time)?
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT