Question

In: Mechanical Engineering

Construct a sketch to show the working of an air handler of the blow-through type with...

Construct a sketch to show the working of an air handler of the blow-through type with cooling and
heating coils in series? Clearly label all parts and components and briefly explain its working?

Solutions

Expert Solution

Working of the Blow-through type Air handling unit:

  • The Fresh air and return air are mixed to the required proportions in the MIXING CHAMBER. The quatities of both are being adjusted by flaps or dampers.
  • The blower unit contains a CENTRIFUGAL FAN which circulates the air and maintains the draft in the system.
  • The air from the mixing chamber is sucked through a filter medium and blown through a COOLER where the air is cooled and dehumified. Then it passses through the humidifier where it gets humidified as required.
  • Now the air passes through a heating coil and is discharged to the accomodation spaces.
  • Heater is just a steam coil.
  • Cooler is the evaporator section of a conventional airconditioning system.

Related Solutions

Sketch and describe the working of a Locomotive boiler. Show the positions of fusible plug, blow...
Sketch and describe the working of a Locomotive boiler. Show the positions of fusible plug, blow off cock, feed check valve and superheater. Mention the function of each. Describe the method of obtaining draught in this boiler.
With the aid of sketch, explain the main differences between window type air-conditioner and split type...
With the aid of sketch, explain the main differences between window type air-conditioner and split type air-conditioner. Why the window type and split type air-conditioner is not commonly used for high rise commercial building?
With proper illustrations, show the working of voltage regulator through Zener Diode
With proper illustrations, show the working of voltage regulator through Zener Diode
Pressure for air and fluids can be measured and used to fly, float, blow, suck or...
Pressure for air and fluids can be measured and used to fly, float, blow, suck or coast according to specific laws and principles. Terminology can change for the same actions if used with water or with air. 1) These terms are used in the chapter. Give an example of an item that illustrates your definition. Is there a formula or measurement unit that is commonly used? give an Example & Formula of each term Newton's 1st law of Motion Newton's...
You are working with a type 2 diabetic who reveals through a “usual intake” interview that...
You are working with a type 2 diabetic who reveals through a “usual intake” interview that he only eats refined grains and lifestyle habits indicate that he is not physically active. Explain the importance of the introduction of whole grains and exercise to his diet and routine in the management of his condition.​
explain the construction and working of indirect arc furnace with sketch
explain the construction and working of indirect arc furnace with sketch
sketch, label & discuss the lattice structure showing the bonding & sketch band diagram. Show the...
sketch, label & discuss the lattice structure showing the bonding & sketch band diagram. Show the Si chip connected to D.C. voltage, indicate charge carriers, and show donor/acceptor levels. a. A Si doped with Ge( has 4 velectrons).
Define logistic growth and sketch a sample growth of this type of growth. in what type...
Define logistic growth and sketch a sample growth of this type of growth. in what type of situation would logistic growth occur?
Describe with a neat sketch the working of a single plate friction clutch
Describe with a neat sketch the working of a single plate friction clutch
Show by a graphical presentation that the angular momentum is quantized, sketch.
Show by a graphical presentation that the angular momentum is quantized, sketch.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT