3. Electric power is transferred at very high voltages over long distances. Transmission of high voltage...

3. Electric power is transferred at very high voltages over long distances. Transmission of high voltage
Explain how it reduces power loss on the lines.
4. If two points have the same potential, this test load will be taken from one point to another.
Does it mean that no work will be carried out during the course? This need no force application
shows that it is not? Discuss.

Expert Solution

genius_generous answered 1 year ago

1 The line to ground voltages on the high voltage side of a step-up transformer are...

1 The line to ground voltages on the high voltage side of a step-up transformer are 100 kV, 33 kV and 38 kV on phases a, b and c respectively. The voltage of phase a leads that of phase b by 100° and lags that of phase c by 176.5°. Determine the symmetrical negative phase sequence component of phase a. 2. A 3-phase, 4-wire system supplies loads which are unequally distributed in the three phases. An analysis of the current...

5) Wave on transmission lines (a) Derive wave equations for voltage and currents over the transmission...

5) Wave on transmission lines (a) Derive wave equations for voltage and currents over the transmission lines. (b) Solve for general solutions (c) Indicate the definition of characteristic impedance

“High voltage” power lines are often seen suspended high above the ground. Two of these power...

“High voltage” power lines are often seen suspended high above the ground. Two of these power lines are suspended above a physics professor who is out for a walk. The power line on the left carries a current out of the page; the power line on the right carries a current into the page. a) What is the direction of the magnetic field produced by the two currents at the location of the physics professor? He is on the ground...

What types of consideration must be made when selecting the appropriate type and style of conductor for high voltage and long distance transmission?

1) What types of consideration must be made when selecting the appropriate type and style of conductor for high voltage and long distance transmission? How do thermal reaction and stress/strain propeties factor into these decision. 2) How do we acquire the metals that we used for conducting paths in our circuit? what are some impacts of these method on environment and social level?

Copper and aluminum are being considered for a high-voltage transmission line that must carry a current...

Copper and aluminum are being considered for a high-voltage transmission line that must carry a current of 60 A. The resistance per unit length is to be 0.170 Ω/ km. Compute for each choice of cable material the current density. The current density for copper? The current density for aluminum? Compute the mass per meter of the cable for each material. The densities of the copper and aluminum are 8960 and 2700 kg/ m3, respectively. The mass per meter of...

Problem 4. A high-voltage power supply should have a nominal output voltage of 350 V. A...

Problem 4. A high-voltage power supply should have a nominal output voltage of 350 V. A sample of four units is selected each day and tested for process-control purposes. The data (see sheet Problem4 in Homework 4.xlsx) give the difference between the observed reading on each unit and the nominal voltage times ten; that is, ?? = (observed voltage on unit ? - 350)*10 (a) Set up ?̅ and ? charts on this process. Is the process in statistical control?...

A high-level voltage power supply should have a nominal output voltage of 350 V. A sample...

A high-level voltage power supply should have a nominal output voltage of 350 V. A sample of four units is selected each day and tested for process-control purposes. The data (20 days, 1 sample/day) shown in the table below give the difference between the observed reading on each unit and the nominal voltage times ten; that is, xi = (observed voltage on unit 350)*10. Voltage Data Voltage Data Sample # xi Sample # xi 1 6 11 8 1 9...

A high voltage power line carries a current of 105 A at a location where the...

A high voltage power line carries a current of 105 A at a location where the Earth's magnetic field has a magnitude of 0.588 G and points the to the North, 74.7 degrees below the horizontal. Calculate the magnitude of the magnetic force exerted on a 253 m length of wire if the current in the wire flows horizontally toward the east? _____________________________________________________________ Calculate the magnitue of the magnetic force exerted on a 253 m length of wire if the...

If it should happen that a high voltage electric line should drop from the pole and...

If it should happen that a high voltage electric line should drop from the pole and make contact with a car, the person in the car should jump out of the car with both feet at the same time, rather than stepping out, one foot at a time. Explain the rationale behind this safety tip.

An electric motor has the power P = 45 kW with terminal voltage Ueff = 380...

An electric motor has the power P = 45 kW with terminal voltage Ueff = 380 V. The power factor is cos (φ) = 0.85. a) Explain the concept of the power factor! What is it? b) Calculate the apparent power S, reactive power Q, and the currents Ieff, IW (active current) and IB (reactive current)! c) What are the consequences for producers and consumers from the existence of reactive power or reactive current?

Question