When Vo = 0.5× Vmax, [S] = 1× Km. Which of the following is true when...

When Vo = 0.5× Vmax, [S] = 1× Km. Which of the following is true when [S] = 4× Km?

V0 = 40% of Vmax

none of these

V0 = 8% of Vmax

Vo = 80% of Vmax

Vo = 4% of Vmax

Expert Solution

queen_honey_blossom answered 1 year ago

plot 1/Vo Vs 1/[S] (Lineweaver-Burk plot) and calculate the values of Km and Vmax from the...

plot 1/Vo Vs 1/[S] (Lineweaver-Burk plot) and calculate the values of Km and Vmax from the intercepts .Give units

Biochemistry- Which of the following is true? A. The Vmax is reached when the concentration of...

Biochemistry- Which of the following is true? A. The Vmax is reached when the concentration of substrate is double the Km. B. The Km value decreases in the presence of a competitive inhibitor. C. At high substrate levels the reaction velocity increases in a linear manner with increasing S concentration D. At very low substrate levels doubling the S concentration nearly doubles the observed reaction rate so that the rate increases in a linear manner. E. When the substrate level...

BIOCHEMISTRY: Vmax and Km values For the following problem

An enzyme catalyzed reaction has a Km of 3.76 mM and a Vmax of 6.72 nM/s....

An enzyme catalyzed reaction has a Km of 3.76 mM and a Vmax of 6.72 nM/s. What is the reaction velocity in nM/s, when the substrate concentrations are: A. 0.500 mM B. 15.6 mM C. 252 mM D. Now assume you have added a competitive inhibitor that has a concentration of 15.6 µM with a KI of 7.30 µM to the enzyme in question 9. Calculate the velocity at the same substrate concentrations as above: E. 0.500 mM F. 15.6...

A reversible inhibitor I is competitive with the substrate S when both have equal 1/Vmax ...

A reversible inhibitor I is competitive with the substrate S when both have equal 1/Vmax c. equal 1/Vmax & 1/KM equal 1/KM d. equal slope A reversible inhibitor I is uncompetitive with the substrate S when both have equal 1/Vmax c. different 1/Vmax & 1/KM equal 1/KM d. different slope

1. Which of the following is true of the calculation of equivalent units when there is...

1. Which of the following is true of the calculation of equivalent units when there is nonuniform application of manufacturing inputs? Equivalent units are calculated using weighted average cost method only. The ending work in process is ignored in the calculation of equivalent units. Equivalent cost of ending work in process is considered as the equivalent cost throughout the period. Equivalent units are calculated for each category of manufacturing input. 2. The hard disk department of a computer manufacturing company...

Which of the following statements is/are TRUE? (i.e. select ONLY the answer(s) that is/are TRUE.) 1.RNA...

Which of the following statements is/are TRUE? (i.e. select ONLY the answer(s) that is/are TRUE.) 1.RNA polymerase does not require primer to initiate the process of assembly of nucleotide triphosphates. This is in contrast to DNA replication, where primer is required at initiation. 2.The addition of a Poly-A tail on the end of a transcript happens because of the transcription of the Poly-T signal from the corresponding gene. 3.The molecule Poly-A polymerase is responsible for addition of the Poly-A sequence...

Which of the following is a type 1 error? a. When H0is true and H0 is...

Which of the following is a type 1 error? a. When H0is true and H0 is accepted b. When Hais true and H0 is accepted c. When H0is true and Ha is accepted d. When Hais true and Ha is accepted

1. Which of the following is not true? A) when a series has the same average...

1. Which of the following is not true? A) when a series has the same average growth rate from period to period, then it can be approximated by including trend in a regression. B) dummy variables can be used to address the problem of seasonality in regression models. C) yt = α0 + β0st + β1st−1 + β2st−2 + β3st−3 +ut , it is possible to estimate long-run effect of change in st on yt . D) serial correlation of...

1. Which of the following statements is true of the accounting for finished goods when a...

1. Which of the following statements is true of the accounting for finished goods when a job is completed? Overhead costs are assigned to Finished Goods using a predetermined rate. Finished Goods is debited when goods are sold. The cost of completed units is credited to Work-in-Process and debited to Finished Goods. The costs of the completed job are retained in Work-in-Process until the proceeds are collectible for the job. 2. Slim Technology Inc. records the following amounts before reconciling...

Question