Question

In: Physics

1- A magnet created when there is a current through a coil of wire is considered...

1- A magnet created when there is a current through a coil of wire is considered

a. electromagnet.
b. a solenoid.
c. polarized.
d. all of the above

2- The radii of the paths that ions follow in a mass spectrometer can be used to calculate the charge on the ion.
a. True
b. False

3- The __________ difference between two points separated by a distance d in a uniform field is represented by the equation ΔV = Ed.

a. electrical
b. potential
c. equipotential
d. volt

(I think its option B)

4- Electricity sent over power lines needs


a. low voltage and high current.
b. low voltage and low current.
c. high voltage and high current.
d. high voltage and low current.

5-Three resistors, 20 Ω, 40 Ω, and 40 Ω, are connected in parallel across a 12.0 V battery. What is the equivalent resistance of the this circuit diagram?


a. 10 Ω
b. 20 Ω
c. 30 Ω
d. 40 Ω

6-Transformers can change __________ with fairly little waste of energy.

a. magnetic fields
b. power
c. resistances
d. voltages

7-The _________ is proportional to the strength of the magnetic field.

a. magnetic flux per unit area
b. amount of space taken up by the magnet
c. mass of the magnet
d. size of the magnet

Solutions

Expert Solution


Related Solutions

The magnet moves as shown. The field of the magnet through the coil is
The magnet moves as shown. The field of the magnet through the coil is to the left and the primary flux through the coil is decreasing. to the right and the primary flux through the coil is decreasing. to the right and the primary flux through the coil is increasing. to the left and the primary flux through the coil is increasing.
1. A magnet is inserted into a coil of wire consisting of 10000 loops. The cross-sectional...
1. A magnet is inserted into a coil of wire consisting of 10000 loops. The cross-sectional area of the coil is 0.5 m2and is kept in a uniform magnetic field of B = 4 T. Assume that the angle between the surface normal of the coil and magnetic field is qo= 45oat t0= 0s. The coil is rotated at a constant rate to an angle, q= 900at t = 60s. What is the average induced voltage (emf) induced in the...
When a magnet is plunged into a coil at speed v, as shown in the figure, a voltage is induced in the coil and a current flows in the circuit.(Figure 1)
When a magnet is plunged into a coil at speed v, as shown in the figure, a voltage is induced in the coil and a current flows in the circuit. (Figure 1) Part A If the speed of the magnet is doubled, the induced voltage is ________. a.) twice as great b.) four times as great c.) half as great d.) unchanged  
When a magnet is plunged into a coil at speed v, as shown in the figure, a voltage is induced in the coil and a current flows in the circuit.(Figure 1)
When a magnet is plunged into a coil at speed v, as shown in the figure, a voltage is induced in the coil and a current flows in the circuit. (Figure 1) Part A If the speed of the magnet is doubled, the induced voltage is ________. a.) twice as great b.) four times as great c.) half as great d.) unchanged  
If the magnet moves as shown in the diagram, the primary flux through the coil
1) If the magnet moves as shown in the diagram, the primary flux through the coil A. increases and points to the right. B. increases and points to the left. C. decreases and points to the right. D. decreases and points to the left.   2) The magnetic flux is changing as it passes through two coils that are exactly the same. The induced voltage is greatest in the coil whose flux is changing fastest. True False   3) The...
1) A magnet is dropped vertically through a horizontal loop of wire, with the south pole...
1) A magnet is dropped vertically through a horizontal loop of wire, with the south pole of the magnet pointing downward. Describe the induced current in the loop, as viewed from above the loop. A)Counterclockwise as the magnet approaches, then clockwise after it passes through B)Clockwise as the magnet approaches, then counterclockwise after it passes through C)Counterclockwise always D)Clockwise always 2) When current flows into a resistor in a circuit, what is actually happening to the individual electrons? A)They slow...
a-Explain what happens when the magnet moves through the coil at different speeds b-How this affects...
a-Explain what happens when the magnet moves through the coil at different speeds b-How this affects the brightness of the bulb and the magnitude & sign of the voltage. c-Explain the difference between moving the magnet through the coil from the right side versus the left side. d-Explain the difference between moving magnet through the big coil versus the smaller coil.
What if we were to drop a magnet with the same mass through a copper coil...
What if we were to drop a magnet with the same mass through a copper coil at different heights? Is the greater the height the greater the emf? In addition, is the integral of Edt depend on the height. Lab: Faraday's Law
When a DC current passes through the coil, it will produce a magnetic flux around the...
When a DC current passes through the coil, it will produce a magnetic flux around the coil. Is this the reason why the coil get heated? Because the magnetic flux will be stable after all as DC current does not oscillate?
A one-meter-square coil of wire sits flat on a tabletop and bar magnet is dropped south-end-down...
A one-meter-square coil of wire sits flat on a tabletop and bar magnet is dropped south-end-down toward it. As the magnet approaches, the field magnitude through the coil increases linearly from 4 mT to 16 mT is 0.25 s. This produces a 96 milliamp current circulating in the coil. Find the resistance of the coil, and state which way (as viewed from above) the induced current circulates. An electric generator is intended to output 10 kJ of energy during each...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT