Question

In: Statistics and Probability

The response time in milliseconds for 5 different type of circuits in automatic value shutoff mechanism...

The response time in milliseconds for 5 different type of circuits in automatic value shutoff mechanism is measured and reported as follows

           

            Circuit 1    Circuit 2       Circuits 3        Circuits 4           Circuit 5

            28                    25                    31                    31                    29

            25                    31                    25                    25                    31

            28                    30                    31                    25                    23

            25                    22                    23                    31                    28

            29                    27                    38                    21                    24

            35                    29                    29                    31                    19

            31                    29                    28                    30                    25

                                    23                    29                    23                    27

                                    35                    34                    22 25

  1. 24    22       31

29                    25

39

Test the hypothesis that all 5 circuits have same response time. Use alfa=.05. Use Scheffe’s methods for multiple comparison, if needed.by spss programme

Solutions

Expert Solution

Using Spss:

First Enter Data:

For this type of problem use One Way ANOVA:

Steps: Analyze-->Compare Means-->One Way ANOVA:

Then Click on Post Hoc.

Then tick on Scheffe.

output:

Here p value is greater than 0.05, so there is no significant difference between in five circuit.

Now see in Post Hoc Sceffe:

Here all pvalue is greater than 0.05, it is means all circuit are same response time.


Related Solutions

The response time in milliseconds was determined for three different types of circuits in an electronic...
The response time in milliseconds was determined for three different types of circuits in an electronic calculator. The results are recorded in table: Curcuit Type Response (R) R R R R 1 19 22 20 18 25 2 20 21 33 27 40 3 16 15 18 26 17 (a) What is the value of LSD? Use α=0.01. Round your answer to two decimal places (e.g. 98.76). (b) Apply Fisher's LSD method with α=0.01 and state which circuit type differs...
Question 1: The response time in milliseconds was determined for three different types of circuits in...
Question 1: The response time in milliseconds was determined for three different types of circuits in an electronic calculator. The results are recorded here. Circuit Type Response 1 19 22 20 18 25 2 20 21 33 27 40 3 16 15 18 26 17 Using α = 0.05, test the hypothesis that the three circuit types have the same response time. What is the p-value? Analyze the residuals from this experiment. If there is a significant difference, perform a...
Problem 3.22. The response time in milliseconds was determined for three different types of circuits that...
Problem 3.22. The response time in milliseconds was determined for three different types of circuits that could be used in an automatic valve shutoff mechanism. The results from a completely randomized experiment are shown in the following table: Circuit Type...........Response Time 1 9 12 10 8 15 2 20 21 23 17 30 3 6 5 8 16 7 a) Test the hypothesis that the three circuit types have the same response time. Use α=0.01. b) Use Tukey’s test to...
The response time (in seconds) was determined for three different types of circuits that could be...
The response time (in seconds) was determined for three different types of circuits that could be used in an automatic valve shutdown mechanism. The results are provided in the table below: Circuit type 1 9 12 10 8 15 2 20 21 23 17 30 3 6 5 8 16 7 Construct a set of orthogonal contrasts, assuming that at the outset of the experiment you suspected the response time of circuit type 2 to be different from the other...
A researcher hypothesizes that reaction time (RT) measured in milliseconds in response to a startling stimulus...
A researcher hypothesizes that reaction time (RT) measured in milliseconds in response to a startling stimulus will be lower (faster) before people drink 5 beers than it will be afterward. A sample of 12 patients is presented with a startling stimulus, and their mean score is 6.08 milliseconds with an SD of 1.38. They drink 5 beers, another startling stimulus is presented, and participants’ mean reaction time is 14.25 milliseconds with an SD of 3.7. The raw scores and Z-scores...
Part 5 The frequency response of RLC circuits : Design a passive filter: Band Pass, ISM...
Part 5 The frequency response of RLC circuits : Design a passive filter: Band Pass, ISM Band 433.050 MHz to 434.790 MHz . Prepare a report to describe your design. Your results should include the following : i. Simulation of the designed filters by using any simulation software. ii. Attach a 1 kΩ resistor as a load to the initial design of your filter. Explain how the transfer function change. Does the type of filter change? Does the cut-off frequency...
1.  An ISA may be implemented by many different processor circuits. Why is this of value in...
1.  An ISA may be implemented by many different processor circuits. Why is this of value in the marketplace? 2. What data structure is used by the machine code program placed in the instruction memory of a fixed-length instruction representation processor? 3. The bit strings of a machine code program can be thought of as having a type. What is a reasonable name for this type?
In terms of response time and antibody production, how is a primary immune response different from...
In terms of response time and antibody production, how is a primary immune response different from a secondary immune response? What is a difference between a pathogen and an allergen? How is an autoimmune disorder different from an allergy?
THIS IS THE THIRD TIME POSTING IT!!! CAN SOMEONE ANSWER THIS AND TYPE THE RESPONSE. THANK...
THIS IS THE THIRD TIME POSTING IT!!! CAN SOMEONE ANSWER THIS AND TYPE THE RESPONSE. THANK YOU! What are one example of a monopolistically competitive firm, oligopoly, and monopoly in your local area? In your example, please relate to the market characteristics of each of the market structures? Work cite and type is a most!!!!!
5. The driver's reaction time in response to a particular potential traffic hazard is the time...
5. The driver's reaction time in response to a particular potential traffic hazard is the time required from the point of initial detection of the hazard in one’s field of view to the time that vehicle control components are actuated (such as the movement of one’s foot to the brake pedal). The following data represent the measurements of the driver’s reaction time in seconds for the male and female participants of the experiment: 0.50 0.49 0.45 0.54 0.44 0.49 0.51...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT