Logic circuit Question 1. Describe the "4bit adder/substracter" design process that can be computed between (a)...

Logic circuit Question

1. Describe the "4bit adder/substracter" design process that can be computed between (a) unsigned input or (b) signed input and draw a circuit diagram (using "1-bit Full Adder").

2. Check the three computations of "3+4", "7+4", and " (-4)+2" of the 4bit adder/substracter circuit designed

Solutions

Expert Solution

genius_generous answered 1 year ago

Next > < Previous

Related Solutions

Design an 8-bit adder. Show the truth table, logic circuit, and Verilog code.

. Create a half adder circuit using ladder logic. Use an input module to collect the...

. Create a half adder circuit using ladder logic. Use an input module to collect the values from two switches A0 and B0 and an output module to deliver the output Sum and Carry signals to bulbs. Use a ladder diagram to create the logic. You should be able to alter the switches and check the operation of your logic by checking which bulbs come on. You can’t use the logic convertor for ladder logic diagrams. Show your circuit, and...

Procedure a. Design and build a circuit based on the subtractor adder to implement the following...

Procedure a. Design and build a circuit based on the subtractor adder to implement the following equation: Y=2X +1.5 b. Check the operation of the circuit, entering 10 different values of X and measuring the result obtained in Y. Use a source of +-15 volts to polarize the circuit c. Graph the results and obtain the equation of that graph.

Using the principles and components of digital and linear logic circuits design a circuit that is...

Using the principles and components of digital and linear logic circuits design a circuit that is able to open and close the door of a garage of vehicles according to the following conditions: a) The door will open in the following cases: a.1) a manual push-button is activated and there is sunlight. a.2) the button is not activated, there is no sunlight and the light of a vehicle is detected. b) The door must close after 30 seconds of opening....

What is the process of evaluating the output of a logic circuit that contains a combination...

What is the process of evaluating the output of a logic circuit that contains a combination of various AND,OR,NOT gates? How can you use Multisim to evaluate the output of a combinational logic circuit? How did changing the order of thr gates affect the output?

Problem 3.73 (1-bit full adder using carry lookahead – gate level circuit) 3.73 Design a 4-bit...

Problem 3.73 (1-bit full adder using carry lookahead – gate level circuit) 3.73 Design a 4-bit full adder using carry look-ahead rather than ripple carry.

design full adder using 4:1 mux

design a logic circuit that counts the number of 1s in 12 inputs(a0...a11) and outputs a...

design a logic circuit that counts the number of 1s in 12 inputs(a0...a11) and outputs a 4-bit binary that represents the count of 1s. for example, if input is 111111111111 which has 12 1s, then output should be 1100 note :Do not use clocking. draw logic diagram.

Design a synchronous sequential logic circuit with input X (that has been synchronized to the clock)...

Design a synchronous sequential logic circuit with input X (that has been synchronized to the clock) and output Y. Every second high-to-low transition of X results in a one clock period long pulse on Y immediately after the transition. Otherwise, Y is 0. Draw a timing diagram (showing input, output and state variables) for an appropriate sequence on input X

Subjects