desk study investigation of 18 story building phase 1 soil investigation

desk study investigation of 18 story building

phase 1 soil investigation

Expert Solution

Ally Wells answered 5 months ago

In a soil investigation for a construction project, two soil types were identified with the following...

In a soil investigation for a construction project, two soil types were identified with the following parameters (g = 9.81 m/s2): Soil Type Depth below ground level (m) Unit weights (kN/m3) Other parameters Soil 1 (sand) 6.5 g = 17 and gsat = 17.5 E =15000 kN/m2 Soil 2 (overconsolidated clay) 11.5 gsat = 20 e0=0.69, Cc=0.25, Cs=0.05 If the ground water level is at 2.5 m below the ground level, and the initial void ratio of the overconsolidated clay...

A three phase source supplies a building with 18 KV which has a group of four...

A three phase source supplies a building with 18 KV which has a group of four 3-phase loads as follows: LOAD 1: Wye connected; S=444 KVA and 0.84 lagging power factor LOAD 2: Delta connected; S=693.75 KVA and 0.64 leading power factor LOAD 3: Wye connected; Z= 140 + j240 Ω LOAD 4: Unbalanced wye-connected and grounded load, with Za = 14+j3 Ω , Zb = 5-j24Ω and Zc =1+j14 Ω What is the current phasor flowing through each conductor?

How is soil investigation important in civil engineering and give examples.

1. Explain the three phase model building process? SRM.

Write about Phase relations and their relevance with engineering properties of soil?

1. A developer in Chicago is planning to build a 7 story building with 28 condo...

1. A developer in Chicago is planning to build a 7 story building with 28 condo units (14 one bedroom units and 14 two bedroom units). The target market is the growth in new households living within a 1 mile radius of downtown Chicago with age groups 25-64. The construction takes approximately one year and is expected to be completed at the end of 2019. From comparable pricing data, they expect to sell the one bedroom condos for $750,000 each...

1) A ball is tossed from an upper-story window of a building. The ball is given...

1) A ball is tossed from an upper-story window of a building. The ball is given an initial velocity of 8..00 m/s at an angle of 20.0 below the horizontal. It strikes the ground 5 .00 s later. A) How far horizontally from the base of the building does the ball strike the ground? B) Find the height from which the ball was thrown. C) How long does it take the ball to reach a point 10.0 m below the...

4. In a two – story building, an exterior column is to be designed for a...

4. In a two – story building, an exterior column is to be designed for a service dead load of 1000 KN, maximum live load of 1500 KN, dead load moment of 60 KN m, and live load moment of 90 KN m. If the column dimensions will be restricted to 400 mm x 500 mm, fc’ = 27.6 MPa, and fy = 414 MPa, calculate the required column reinforcement

In a two – story building, an exterior column is to be designed for a service...

In a two – story building, an exterior column is to be designed for a service dead load of 1000 KN, maximum live load of 1500 KN, dead load moment of 60 KN m, and live load moment of 90 KN m. If the column dimensions will be restricted to 400 mm x 500 mm, fc’ = 27.6 MPa, and fy = 414 MPa, calculate the required column reinforcement.

Question 1 Run a regression model to estimate the cost of a building using average story...

Question 1 Run a regression model to estimate the cost of a building using average story height (mean centered) and total floor area (mean centered) as predictors. Using the adjusted R Square statistic, how much variation in the dependent variable can be explained by the model? Select one: a. between 95% and 98% b. above 98 percent c. between 90% and 95% d. less than 90% Question 2 Run a regression model to estimate the cost of a building using...

Question