5. Draw a diagram with the following components : a.) mRNA with 15 nucleotides (indicate the...

5. Draw a diagram with the following components :

a.) mRNA with 15 nucleotides (indicate the sequence); label 5’ and 3’ ends.
b.) small and large ribosomal subunits (show the tRNA binding sites and label them A,P,E)
c.) tRNA carrying an amino acid that corresponds to the codon being read by the ribosome

Expert Solution

gladiator answered 2 years ago

Consider the following segment of mRNA produced by the normal order of DNA nucleotides: 5' UCU...

Consider the following segment of mRNA produced by the normal order of DNA nucleotides: 5' UCU AAG CGA GUU 3' What is the amino acid order if an insertion mutation adds a G to the beginning of the mRNA segment? What is the amino acid order if a deletion mutation removes the U at the beginning of the mRNA segment?

1. Draw a simple diagram of a prokaryotic ribosome, showing where the mRNA fits and the...

1. Draw a simple diagram of a prokaryotic ribosome, showing where the mRNA fits and the three grooves/sites inside. Be sure to label each of the subunits with their correct sizes (in S). Then answer the questions below using the diagram and what you know about translation. a.How does the mRNA know where to bind onto the ribosome? b.Which factor keeps the ribosomal subunits separate before translation begins? ______ c.Which factor guides the initiator tRNA to the correct site? ______...

draw the block diagram of the CRO and explain the different components

Draw a schematic and clearly indicate the components of a compound microscope. In a compound microscope,...

Draw a schematic and clearly indicate the components of a compound microscope. In a compound microscope, why must the objective lens (or objective + Tube lens) be a converging lens (or lens system)?

Genes are specific sequences of nucleotides that code for mRNA which may be translated into a...

Genes are specific sequences of nucleotides that code for mRNA which may be translated into a protein. The nucleotide is the building block of nucleic acids, RNA and DNA. A nucleotide is composed of a pentose sugar, attached to one of five nitrogenous bases, guanine (G), cytosine (C), thymine (T), or adenine (A) and phosphate groups. The bases are covalently bonded through an ester bond between the hydoxyl group of one ribose and the phosphate group of another nucleotide. All...

a) Three nucleotides are inserted into a protein-encoding gene. The insertion occurs such that the mRNA...

a) Three nucleotides are inserted into a protein-encoding gene. The insertion occurs such that the mRNA transcript has an additional 3 bases (NOT a stop) right next to the stop codon (on the 5’ side). Which of the following will be the result? b) Which of the following are consequences of encoding each amino acid using 3 nucleotides in the Genetic Code? (mre than one) A. There are three different reading frames in a single-stranded mRNA B. tRNA anticodons contain...

5. Draw a band diagram (label the component parts in your illustration) for the following ):...

5. Draw a band diagram (label the component parts in your illustration) for the following ): a) Calcium b) Silicon doped with Arsenic

Draw the Solow diagram for the General Solow Model and clearly indicate the steady state.

Draw the Solow diagram for the General Solow Model and clearly indicate the steady state. Starting from the original each time, draw in any changes and indicate any change in k~* and y~* if there is a decrease in n.

Draw a free body diagram of a piston, connecting rod and crank shaft. Indicate on the...

Draw a free body diagram of a piston, connecting rod and crank shaft. Indicate on the diagram the effective forces acting on the piston and the crank shaft during the expansion stroke. Now let’s do some sample calculations assume 2500 RPM and neglecting friction. b. For a compression ignition engine with a 200mm bore, a compression ratio of rc = 20, and a cylinder pressure of 100 bar when the crank shaft is at θ = 0°, 45° and 90°....

draw a PLC ladder diagram for 5 floor elevator

Question