For a classroom demonstration, a professor built an RL circuit similar to the one shown in...

For a classroom demonstration, a professor built an RL circuit similar to the one shown in the figure, with e m f = 6.00 V, L = 5.80 mH, and R = 3.80 Ω.

A rectangular circuit contains a battery of emf ℰ on its left side, with the positive terminal above the negative terminal. An open switch S is on the top side, an inductor L is on the right side, and a resistor R is on the bottom side.

(a) What is the inductive time constant of the circuit (in ms)? _________________ms

(b) Calculate the current in the circuit (in A) 250 µs after the switch is closed. _________________A

(c) What is the value of the final steady-state current (in A)? A (d) After what time interval (in ms) does the current reach 80.0% of its maximum value? _____________ms

Expert Solution

genius_generous answered 2 years ago

A series RL circuit is built with 190 Ω resistor and a 5.0-cm-long, 1.0-cm-diameter solenoid with...

A series RL circuit is built with 190 Ω resistor and a 5.0-cm-long, 1.0-cm-diameter solenoid with 800 turns of wire. A) What is the peak magnetic flux through the solenoid if the circuit is driven by a 12 V, 5.0 kHz source? B) What capacitance, in μF, has its potential difference increasing at 1.5×106 V/s when the displacement current in the capacitor is 0.60 A ?

Q1/ The current in an RL circuit builds up to one-third of its steady-state value in...

Q1/ The current in an RL circuit builds up to one-third of its steady-state value in 6.25 s. Find the inductive time constant. Q2/ A coil is connected in series with a 14.3 kΩ resistor. An ideal 48.4 V battery is applied across the two devices, and the current reaches a value of 2.37 mA after 4.78 ms. (a) Find the inductance of the coil. (b) How much energy is stored in the coil at this same moment?

My lab was about an RC circuit and RL circuit, and talking about/showing the relationship of...

My lab was about an RC circuit and RL circuit, and talking about/showing the relationship of voltage and current for a capacitor and inductor by using a theoretically calculated tau in comparison to an experimentally found tau (using current/voltage calculated from 36.8% of initial value) from a simulation and experimentally found tau from the slope of the natural log of the current in the RC circuit and voltage in the RL circuit versus time from the same simulation. My theoretical...

In a popular classroom demonstration, solid sodium is added to liquid water and reacts to produce...

In a popular classroom demonstration, solid sodium is added to liquid water and reacts to produce hydrogen gas and aqueous sodium hydroxide. Part A Write a balanced chemical equation for this reaction. Express your answer as a chemical equation. Identify all of the phases in your answer. SubmitMy AnswersGive Up Write the balanced chemical equation for each reaction. Part B - 3.79a Solid lead(II) sulfide reacts with aqueous hydrobromic acid to form solid lead(II) bromide and dihydrogen monosulfide gas. Express...

1. When a switch is closed in a RL circuit with a battery, which of the...

1. When a switch is closed in a RL circuit with a battery, which of the following statement is TRUE? Back emf is maximum in the beginning and decreases exponentially with time Back emf is zero in the beginning and increases exponentially with time Current is maximum in the beginning and decreases exponentially with time Current is zero in the beginning and increases exponentially with time 2. When an inductor is connected to an AC voltage source with Vmax= 5...

One RL series circuit contains the resistor R1= 2 Ω and inductor L = 10 H....

One RL series circuit contains the resistor R1= 2 Ω and inductor L = 10 H. (i) Write the first order differential equation for this circuit in time constant form. (ii) Determine the time constant for this system (iii) Calculate the steady state gain of the system. (iv) Determine the time constant and steady state gain when the inductance is doubled (v) In the context of positioning of poles on the S-plane, what does the ‘real part’ represent and what...

design and draw the circuit of RL HPF, find the required value of the inductor to...

design and draw the circuit of RL HPF, find the required value of the inductor to get critical Frequency F,r=20KHz, assume the resistor R=(100ohms) and the input Vrms=10V MULTISIM

The current in an RL circuit drops from 0.89 A to 12 mA in the first...

The current in an RL circuit drops from 0.89 A to 12 mA in the first second following removal of the battery from the circuit. If L is 13 H, find the resistance R in the circuit.

1. A dramatic classroom demonstration involves cooling a balloon from room temperature (293 K ) to...

1. A dramatic classroom demonstration involves cooling a balloon from room temperature (293 K ) to liquid nitrogen temperature (77 K). If the initial volume of the balloon is 2.5 L , what will its volume be after it cools? (Assume constant pressure.) Express your answer using two significant figures. ** different kind of question for #2.** 2. A sample of gas in a cylinder as in the example in Part A has an initial volume of 48.0 L ,...

Consider a simple RL circuit consisting of an ideal battery with voltage 30 V , a...

Consider a simple RL circuit consisting of an ideal battery with voltage 30 V , a resistor of resistance 15 Ω, an inductor of inductance 7.0 H, and a switch all in series. The switch is initially open. a) Determine the ratio of the voltage across the resistor to the voltage across the inductor when the current has a value of 1.5 A. b) How much time has elapsed if the voltage across the resistor is 20 V ?

Question