1-What is the resistance of a 5km long copper wire with a diameter
of 4mm?
a. 1.65 ohms
b. 0.0015 ohms
c. .0065 ohms
d. 6.7 ohms
2- three 4mF capacitor are connected in series across a 12 V
battery. The total charges stored by this compination of capacitor
is
A. 24 mC
B. 16 mC
C. 48 mC
D. 144 mC
E. None of the above
3. What would be the energy stored in the capacitor in the
previous...
a)What is the resistance of a nichrome wire at 0.0 degrees C if its resistance 100.00 ohms at 11.5 degrees C?
(b)What is the resistance of a carbon rod at 25.8 degrees C if its resistance is 0.0160 ohms at 0.0 degrees C?
A number 14 copper wire has a diameter of 1.628 mm. Calculate
the resistance of a 34.0 m long piece of such wire.
(Use 1.72×10-8 Ωm for the resistivity of copper.)
2.809×10-1 Ohm
For safety, the National Electrical Code limits the allowable
amount of current which such a wire may carry. When used in indoor
wiring, the limit is 15.0 A for rubber insulated wire of that size.
How much power would be dissipated in the wire of the above...
A 400-W cylindrical resistance heater is 1 m long and
0.5-cm-diameter. The resistance wire is placed horizontally in a
fluid at 20◦C, flowing at a velocity of 20 m/s. Determine the outer
surface temperature of the resistance wire in steady operation if
the fluid is
(a) air and
(b) water. Ignore any heat transfer by radiation and evaluate
properties of air at 800 K and properties of water at 315 K.
Two light bulbs, one with a resistance of 30 ohms and
the other 40 ohms, are arranged in two different circuits with a
120 volt source.
A] The two bulbs are first connected in parallel to the
source.
i. Draw a schematic of the circuit
–clearly labeled.
ii. Determine the current, voltage and power through each
bulb.
B] The two bulbs are now connected in series to the
source.
i. Draw a schematic of the circuit
–clearly labeled.
ii. Determine...
A 3 phase 6 pole, asynchronous AC motor
stator resistance 0.34 ohms
rotor resistance 0.12 ohms
stator inductance of 0.5H
rotor inductance of 0.2H
magnetizing inductance 12.35
a)Draw the equivalent electrical circuit for this motor for 1
phase
b) is slip s=0.3 find the speed, torque, current at the stator
and efficiency if the voltage supply is 240V per phase at 70 Hz
with a Wye connection
2)If an LRC series circuit has a resistance of 20 ohms and an
inductor of L = 1 H, find the capacitance C so that the circuit is
critically damped. Solve this case with the external force is
E(t)=32e^(-32t) volts, q(0)=0, q'(0)=5
This problem has 3 parts.
A single resistor with resistance R ohms is connected to a
battery.
part a - If the single resistor is replaced with 2 identical
resistors each of R ohms connected in series, will the battery have
to provide more power, less power or the same? Explain your choice,
include any equations that apply.
part b If instead of connecting the two resistors in series,
they are connected in parallel, will the battery have to provide...
1.
A resistor stamped with Red Red Black Orange Silver has what
resistance?
A. 2203 ohms
B. 220,000 ohms
C. 22,000 ohms
D. 660 ohms
2. The resistance created when one coulomb of charge is forced
through a 1.0 volt difference in one second is
A. 1ohm
B. 10 ohms
C. 0.001 ohm
D. 1.0 kiliohm
3. the specific material resistivity depends on what?
a. the type of metal
b. the density of the material
c. the cross sectional area...