Question

In: Physics

An object that weighs 1180 N rests on a lever at a point 0.370 m from...

An object that weighs 1180 N rests on a lever at a point 0.370 m from a support. On the same side of the support, at a distance of 3.00 m from it, an upward force with magnitude F is applied. Ignore the weight of the board itself. If the system is in equilibrium, what is F? Express your answer in Newtons. where P = 1180 and x = 0.370. N

Solutions

Expert Solution


Related Solutions

A uniform cubical crate is 0.575 m on each side and weighs 900 N. It rests...
A uniform cubical crate is 0.575 m on each side and weighs 900 N. It rests on the floor with one edge against a very small, fixed obstruction. At what height above the floor must a horizontal force of 625.0 N be applied to the crate to just tip it?
Torque can be calculated by multiplying the force (N) applied at 90° to the lever arm at a distance (m) from the pivot point (point of rotation)
Torque can be calculated by multiplying the force (N) applied at 90° to the lever arm at a distance (m) from the pivot point (point of rotation), the compound SI unit for the torque is N⋅m. If the force (at 90° to the lever arm) applied is 15 N and it is applied at 2.0 m from the pivot point (point of rotation), what is the torque on the lever?
a)An object of mass ?m rests on a horizontal frictionless surface. A constant horizontal force of...
a)An object of mass ?m rests on a horizontal frictionless surface. A constant horizontal force of magnitude ?F is applied to the object. This force produces an acceleration: always only if ?F is larger than the weight of the object only while the object suddenly changes from rest to motion only if ?F is increasing choice A b)Now let there be friction between the surface and the object. If the object has a mass of 10 kg, and ??μs =...
A 92.0-N uniform, horizontal board 14.0 m long rests on two supports, each 1.00 m from...
A 92.0-N uniform, horizontal board 14.0 m long rests on two supports, each 1.00 m from the end of the board. A 385-N block is placed on the board 3.00 m from one end as shown below. Find the force exerted on the board by each support.
An object has a weight of 7.2 N in air. However, it apparently weighs only 3.9...
An object has a weight of 7.2 N in air. However, it apparently weighs only 3.9 N when it is completely submerged in water. What is the density of the object? a. 650 kg/m3 b. 3.3 x 103 kg/m3 c. 2.2 x 103 kg/m3 d. 7.2 x 103 kg/m3
A door 1.00 m wide and 2.30 m high weighs 330 N and is supported by...
A door 1.00 m wide and 2.30 m high weighs 330 N and is supported by two hinges, one 0.70 m from the top and the other 0.70 m from the bottom. Each hinge supports half the total weight of the door. Part A: Assuming that the door’s center of gravity is at its center, find the horizontal component of force exerted on the door by hinge on the top. Ftop h=..... N Part B: Find the horizontal component of...
An object is placed 68cm from a screen 1. At what point from the object should...
An object is placed 68cm from a screen 1. At what point from the object should a converging lens with a focal length of 17cm be placed so that it will produce a sharp image on the screen? (in cm   from the object) 2. What is the image's magnification?
Luc, who is 1.80 m tall and weighs 950 N, is standing at the center of...
Luc, who is 1.80 m tall and weighs 950 N, is standing at the center of a playground merry-go-round with his arms extended, holding a 4.0 kg dumbbell in each hand. The merry-go-round can be modeled as a 4.0-m-diameter disk with a weight of 1500 N. Luc's body can be modeled as a uniform 40-cm-diameter cylinder with massless arms extending to hands that are 85 cm from his center. The merry-go-round is coasting at a steady 35 rpm when Luc...
A spring cannon has a spring constant of 350 N / m and the bullet weighs...
A spring cannon has a spring constant of 350 N / m and the bullet weighs 10 grams. What is the maximum height, measured above the equilibrium position of the spring, that the spring cannon can shoot the ball up to if the maximum compression of the spring is 3.0 cm? (Continuation of the previous question) Before firing, the spring is compressed 2.0 centimeters in relation to the equilibrium position and the firing angle is set to ?? = 41...
A uniform ladder is 16 m long and weighs 240 N. In the figure, the ladder...
A uniform ladder is 16 m long and weighs 240 N. In the figure, the ladder leans against a vertical, frictionless wall at height h = 7.0 m above the ground. A horizontal force F→ is applied to the ladder at distance d = 2.8 m from its base (measured along the ladder). If force magnitude F = 46 N, what are (a)x-, (b)y-components of the force of the ground on the ladder? If F = 140 N, what are...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT