Question
In: Other
consider a natural gas pipeline. The pipeline is made of steel of thickness 2.00 cm. The...
consider a natural gas pipeline. The pipeline is made of steel of thickness 2.00 cm. The steel is coated on the inside with a 0.100 mm layer of Ni. The concentration of natural gas inside the pipeline is 0.100 kg/m3. The concentration outside is 0 kg/m3. The diffusion coefficient of natural gas in Ni is 2.01 x 10-21 m2/s and the diffusion coefficient of natural gas in steel is 7.00 x 10-17 m2/s. Calculate the flux of natural gas through the pipe assuming steady-state and linear geometry.
a. 1.89 x 10-15 kg/(m2.s)
b. 5.27 x 10-16 kg/(m2.s)
c. 2.00 x 10-18 kg/(m2.s)
d. 9.91 x 10-15 kg/(m2.s)
Solutions
Amanda K answered 5 months agoRelated Solutions
When the transportation of natural gas in a pipeline is not feasible for economic reasons, it...
When the transportation of natural gas in a pipeline
is not feasible for economic
reasons, it is first liquefied using nonconventional refrigeration
techniques and
then transported in super-insulated tanks. In a natural gas
liquefaction plant,
the liquefied natural gas (LNG) enters a cryogenic turbine at 3 MPa
and -160
°C at a rate of 20 kg/s and leaves at 0.3 MPa. If 115 kW power is
produced by
the turbine, determine the efficiency of the turbine. Take the
density of...
Compressed natural gas is fed into a small underground pipeline having an inside diameter of 5.9...
Compressed natural gas is fed into a small underground pipeline
having an inside diameter of 5.9 in. The gas enters at an initial
temperature of 120oC and constant pressure of 132.3 psig. The
metered volumetric flow rate at standard pressure of 14.7 psia and
standard temperature of 25oC is 195.4 ft3/min. The ground
temperature is constant at 15oC and serves as an “infinite sink”
for heat transfer. a) Show that the mass flow rate is 0.0604
kg/sec, volumetric flow rate...
9. A stainless steel tube having an outside diameter of 0.6 cm and a wall thickness...
9. A stainless steel tube having an outside diameter of 0.6 cm
and a wall thickness of 0.05 cm is to be insulated with a material
having a thermal conductivity of 0.065 W/mK. If the inner and outer
convective heat transfer coefficients are 5.9 W/m2K.
what will be the heat loss per meter of length for insulation
thicknesses of 0, 0.25, 0.5, 0.75, 1.00, and 1.25 cm if the inside
temperature is 95 C and the outside temperature is 10...
WestGas Conveyance, Inc., is a large U.S. natural gas pipeline company that wants to raise $120...
WestGas Conveyance, Inc., is a large U.S. natural gas pipeline
company that wants to raise $120 million to finance expansion.
WestGas wants a capital structure that is 50% debt and 50%
equity. Its corporate combined federal and state income tax rate is
30%. WestGas finds that it can finance in the domestic U.S.
capital market at the rates listed:
Costs of Raising Capital in the Market
Cost of
Domestic
Equity
Cost of
Domestic
Debt
Cost of
European
Equity
Cost of...
WestGas Conveyance, Inc., is a large U.S. natural gas pipeline company that wants to raise $120...
WestGas Conveyance, Inc., is a large U.S. natural gas pipeline
company that wants to raise $120 million to finance expansion.
WestGas wants a capital structure that is 50% debt and 50%
equity. Its corporate combined federal and state income tax rate is
36%. WestGas finds that it can finance in the domestic U.S.
capital market at the rates listed:
Costs of Raising Capital in the Market
Cost of
Domestic
Equity
Cost of
Domestic
Debt
Cost of
European
Equity
Cost of...
Kinder Morgan, an oil and gas pipeline company, is contemplating the expansion of its TransMountain Pipeline,...
Kinder Morgan, an oil and gas pipeline company, is contemplating
the expansion of its TransMountain Pipeline, which runs from
Alberta to the British Columbia coast. The project is estimated to
cost $7.4 billion and is expected to have a useful life of 15
years, with a salvage value of $0.5 billion. The new equipment will
be added to an existing CCA Class with a rate of 5%. The pipeline
expansion will increase capacity from the current level of 300,000
barrels...
Consider a gas turbine engine, fueled by natural gas, for generating electricity. A.) Calculate the adiabatic...
Consider a gas turbine engine, fueled by natural gas, for
generating electricity.
A.) Calculate the adiabatic flame temperature for this system,
assuming we’ll use about 110% TA.
B.) Estimate (calculate) the power output for this turbine, per
lbm or kg of air.
C.) If I’d like to provide the generator with 12,000 shp (shaft
horsepower), what air mass flow do I need?
D.) If this is an open cycle turbine, the exhaust gas has
considerable remaining energy. How much heat...
A 10 cm x 10 cm x 10 cm block of steel (density of steel =7900...
A 10 cm x 10 cm x 10 cm block of steel (density of steel =7900
kg/m3) is suspended from a spring scale. The scaleis in
newtons.
a. What is the scale reading if theblock
is in air?
b. What is the scale reading after
theblock has been lowered into a beaker of oil and is
completelysubmerged?
Consider a sample containing 2.00 mol of an ideal diatomic gas. Assuming the molecules rotate but...
Consider a sample containing 2.00 mol of an ideal diatomic gas.
Assuming the molecules rotate but do not vibrate, find a) the total
heat capacity of the sample at constant volume and b) the total
heat capacity at constant pressure. C and d) repeat parts a) and b)
assuming the molecules both rotate and vibrate. EXPLAIN how you got
these answers.
Answers should be:
a: 2mol*5/2 R
b: 2 mol*7/2 R
c: 2 mol * 7/2 R
d: 2 mol*9/2...
An object 2.00 cm high is placed 30.8 cm to the left of a converging lens...
An object 2.00 cm high is placed 30.8 cm to the left of a
converging lens having a focal length of 25.8 cm. A diverging lens
having a focal length of −20.0 cm is placed 110 cm to the right of
the converging lens. (Use the correct sign conventions for the
following answers.)
(a) Determine the final position and magnification of the final
image. (Give the final position as the image distance from the
second lens.)
final position :__________ cm...
ADVERTISEMENT
ADVERTISEMENT
Latest Questions
- Part A. Outline and explain all the VARIABLES and FACTORS that determine valuation and valuation analysis...
- Study the file polygon.h. It contains the header file for a class of regular polygons. Implement...
- what challenges can myths and stereotypes create for american indians?
- Date accuracy is very important because dates are used for discounts, payment terms and many reports....
- How many milliliters of concentrated hydrochloric acid solution (36.0% HCl by mass, density = 1.18 g/mL)...
- How does the rotating membership of the FOMC work? Why does the president of New York's...
- A gym owner is considering opening a location on the other side of town. The new...
ADVERTISEMENT