a.) Define constant power load (CPL) and constant voltage load (CVL). Are power electronics devices constant...

a.) Define constant power load (CPL) and constant voltage load (CVL). Are power electronics devices constant power loads? If so, explain why.

b) How can Zener diodes work as voltage stabilizer?

c) Mention the typical value of resistance (Ohm-m) and conductance (Siemens/meter) for conductors, semiconductors and insulators.

Expert Solution

Manojponduru answered 9 months ago

How can we keep the terminal voltage equals to constant independently from load change?

Fundamental of power electronics: In a certain application, an unregulated dc input voltage can vary between...

Fundamental of power electronics: In a certain application, an unregulated dc input voltage can vary between 18 and 36 V. It is desired to produce a regulated output of 28 V to supply a 2 A load. control circuit automatically adjust D to maintain the constant output voltage and current. All ideal components. Hence, a converter is needed that is capable of both increasing and decreasing the voltage. Since the input and output voltages are both positive, converters that invert the...

For your choice of input voltage, load resistor and the value of the ripple voltage (as...

For your choice of input voltage, load resistor and the value of the ripple voltage (as percent of Vdc) design a circuit for the half-wave rectifier. Assuming the value of Von for the diode, calculate theoretically all parameters of the rectifier: Vp, Vdc, Idc, C, Isc, PIV and diode conducting interval.

what is the main difference between voltage source and voltage load? use sketches where suitable.

The complex power absorbed by a load is S= 850∠-25⁰. This means the load is ________...

The complex power absorbed by a load is S= 850∠-25⁰. This means the load is ________ and pf is___________(a) Inductive , lagging(b) Inductive, leading(c) Capacitive, lagging(d) Capacitive, leading The answer is D but why

The power supply frequency is 60Hz. a) What is the power factor of the load? b)...

The power supply frequency is 60Hz. a) What is the power factor of the load? b) What is the active power [W] and reactive power [VAR] consumed by the resistors and inductances? c) Connect capacitor C to points a and b to set the power factor of the entire load to 1. What is the capacitance [F] of the capacitor? Since there is no picture, just tell me how to solve it.

Bulb A is labeled with power P and voltage V, bulb B is labeled with power...

Bulb A is labeled with power P and voltage V, bulb B is labeled with power P/2 and voltage V. These two bulbs are connected in series and then to some source of voltage, which is unknown. Which one produces greater illumination?

what is the voltage output specification of the charging system when a load is placed on...

what is the voltage output specification of the charging system when a load is placed on the system?

Define the voltage regulation of an alternator. Is it good to have low voltage regulation? Justify...

Define the voltage regulation of an alternator. Is it good to have low voltage regulation? Justify your answer. Can the voltage regulation be negative? If the answer is YES, when it can happen? If the answer is NO why it cannot be?

JB Electronics JB Electronics manufactures three components used to produce cell phones and other communication devices....

JB Electronics JB Electronics manufactures three components used to produce cell phones and other communication devices. In a given production period, demand for the three components may exceed JB's manufacturing capacity. In this case, the company meets demand by purchasing the components from another manufacturer at an increased cost per unit. JB's manufacturing cost per unit and purchasing cost per unit for the three components are as follows: Source Component 1 Component 2 Component 3 Manufacture $ 4.25 $ 4.85...

Question