Water travels through a pipe at 5.13 m/s. The pipe expands from a crossectional area of...

Water travels through a pipe at 5.13 m/s. The pipe expands from a crossectional area of 2.9 m² to an area of 11.6 m².
What is the speed of the water in the second part of the pipe in m/s?

How much is the pressure change in KPa as the pipe expands? The density of water is 1000 kg/m3. Enter a positive value for an increase in pressure, a negative value for a decrease.
(Kpa)

Solutions

Expert Solution

genius_generous answered 1 year ago

Next > < Previous

Related Solutions

Water is moving with a speed of 11.3 m/s through a pipe with a cross-sectional area...

Water is moving with a speed of 11.3 m/s through a pipe with a cross-sectional area of 4.5 cm2. The water gradually descends 30.0 m as the pipe's cross section increases by a factor of three. What is the speed of flow at the lower level? Tries 0/16 How much higher is the pressure at the lower level compared to the upper level?

A fluid travels through a pipe of cross-sectional area A1 then moves through a connection into...

A fluid travels through a pipe of cross-sectional area A1 then moves through a connection into another pipe of cross-sectional area A2. If A1 is larger than A2, the velocity of the fluid will ______. Group of answer choices A. increase B. decrease C. remain constant D. evaporate

1. A submarine (sub A) travels through water at a speed of 8.00 m/s, emitting a...

1. A submarine (sub A) travels through water at a speed of 8.00 m/s, emitting a sonar wave at a frequency of 1,400 Hz. The speed of sound in the water is 1,533 m/s. A second submarine (sub B) is locate such that both submarines are traveling directly towards each other. The second submarine is moving at 9.00 m/s a) What frequency is detected by an observer riding on sub B as the submarines approach each other? b) The submarines...

Hot water from a boiler of power plant are discharged through a 0.2-m-diameter, thin-walled pipe with...

Hot water from a boiler of power plant are discharged through a 0.2-m-diameter, thin-walled pipe with a velocity of 3.5 m/s. The pipe passes through a room whose air temperature is 3°C and the exterior surface of the pipe is uninsulated and pipe length is 30 m. (a) At a position in the pipe where the mean water temperature is 40°C, determine the heat loss and the pipe wall temperature. (b) If the pipe is covered with a 20-mm-thick layer...

A water is flowing through a circular varying diameter pipe. The water completely fills the pipe...

A water is flowing through a circular varying diameter pipe. The water completely fills the pipe at all its sections. 1- What is the water velocity of the water at the first section if you know that the diameter of the pipe at this section= 22 cm and the water is flowing at a rate of 2.5 m3/s? 2- What is the diameter of the pipe at the second section if you know that the water velocity at this section...

Water is being pumped through a horizontal pipe that is 36.0 m long and 13.5 cm...

Water is being pumped through a horizontal pipe that is 36.0 m long and 13.5 cm in diameter. A pump maintains a gauge pressure of 742 Pa at a large open tank at one end of the pipe. The other end of the pipe is open to the air. If this pipe is replaced by a second one of length 9 m and diameter 5.0 cm, what gauge pressure must the pump provide to give the same volume flow rate...

Water movinng in a horizontal pipe has a velocity of 9.0 m/s when the radius of...

Water movinng in a horizontal pipe has a velocity of 9.0 m/s when the radius of the pipe is 0.0025 metr. determine the velocity of the water when it enters a wider section of the pipe and the radius is 0.075 meter. Please show work Determine the density of a unkown smaple by using Archemdes Principle and water. the mass measurement of the sample in air is 200 grams, the mass measurement of the sample in water 147 grams. please...

Question