Question

In: Mechanical Engineering

A jet of water 50 mm in diameter with a velocity of 20 m/s strikes a...

A jet of water 50 mm in diameter with a velocity of 20 m/s strikes a flat plate inclined at an angle of 30° to the axis of the jet. Determine

(i) the normal force exerted on the plate when the plate is stationary

(ii) the normal force exerted on the plate when the plate is moving at 5 m/s in the direction of the jet

(iii) the work-done on the plate and the efficiency for case (ii).

Solutions

Expert Solution


Related Solutions

A 2-in diameter jet of water having a velocity of 30 ft/s is deflected parallel to...
A 2-in diameter jet of water having a velocity of 30 ft/s is deflected parallel to a curved vane. The jet flows freely in the atmosphere in a horizontal plane. Calculate the x and y forces exerted on the water by the vane. Defelction is 90 Degrees
Air at 25°C flows over a 10-mm-diameter sphere with a velocity of 20 m/s, while the...
Air at 25°C flows over a 10-mm-diameter sphere with a velocity of 20 m/s, while the surface of the sphere is maintained at 75°C. What is the rate of heat transfer from the sphere? q = ___ W ? Please provide correct final answer for guaranteed thumbs up rating !
The mean velocity in an artery of internal diameter 2.5 mm is 0.25 m/s. Assuming that...
The mean velocity in an artery of internal diameter 2.5 mm is 0.25 m/s. Assuming that blood has a viscosity of 0.004 Pa.s and a density of 1000 kg m−3. a) Determine: i. whether the flow is laminar or turbulent ii. the volume flow rate through the artery b) Assume that the diameter of this blood vessel above is doubled, what would happen to the total volumetric flow rate? Explain your response. c) What would happen in terms of type...
In a galvanised steel water supply line 100 m long and 50 mm in diameter, water...
In a galvanised steel water supply line 100 m long and 50 mm in diameter, water is pumped from a reservoir to a vented storage tank at an elevation 8 m above it. The following fittings are use: 1 hinged foot valve with strainer, 3 x 90? elbows, 2 gate calves (open), 20 screwed sockets, 1 sudden exit. The water viscosity is 1 x 10-6 m2/s and the density is 1000 kg/m3. (a) Calculate the friction factor at a flow...
) A 50 mm-diameter propeller was installed in a 150 mm-diameter water pipe and the propeller...
) A 50 mm-diameter propeller was installed in a 150 mm-diameter water pipe and the propeller speed was measured for a range of water discharge in the pipe. The water had a density and dynamic viscosity of 1000 kg/m3 and 0.00112 Ns/m2 respectively. The measured results were as follows: Q (litres/s): 12 28 45 63 95 120 160 180 N (rps): 5 10 15 20 30 40 60 80 Plot the dependence of propeller coefficient against propeller Reynolds number. A...
with a velocity v = 4.6i m/s. It the strikes the six ball, which has an...
with a velocity v = 4.6i m/s. It the strikes the six ball, which has an identical mass and is initially at rest. After the collision the eight ball is deflected by an angle of θ = 26° and the six ball is deflected by an angle of Φ = 35°, as shown in the figure. Part (a) Write an expression for the magnitude of six ball's velocity, in terms of the angles given in the problem and the magnitude...
A cast iron water pipe of 500 mm inside diameter and 20 mm thick, is supported...
A cast iron water pipe of 500 mm inside diameter and 20 mm thick, is supported over a span of 10 meters. Find the maximum bending stress in the pipe metal, when the pipe is running full. Take density of cast iron = 70.6 kN/m3 and water = 9.8 kN/m3
Water at a mean velocity of 0.2 m/s is heated from 20 to 40°C by passing...
Water at a mean velocity of 0.2 m/s is heated from 20 to 40°C by passing it through a 0.5-cm-ID tube. The 2 surface is heated with a uniform heat flux of 6000 W/m . Find the following: a) The length required to heat the water to a given temperature.,b) the surface temperature at the inlet of the tube. Given that the following information: The physical properties of liquid at 30 °C: ?? =4182?⁄??.°?,?=0.6405?⁄?.°?,??=3.57,?=0.5537×10−6?2⁄?,?=988??⁄?3
A cue ball (0.17 kg) is moving at a velocity of 11.3 m/s when it strikes...
A cue ball (0.17 kg) is moving at a velocity of 11.3 m/s when it strikes two billiard balls (0.16kg), at rest, "dead center" and comes to rest. If one billiard ball moves at a velocity of 4.1 m/s at an angle of 39 radians measured clockwise relative to the incoming direction of the cue ball, and another ball moves at an angle measured counter-clockwise relative to the incoming direction of the cue ball, how fast is the second ball...
Ball A of mass 0.55 kg has a velocity of 0.65 m/s east. It strikes a...
Ball A of mass 0.55 kg has a velocity of 0.65 m/s east. It strikes a stationary ball, also of mass 0.55 kg. Ball A deflects off ball B at an angle of 37° north of A's original path. Ball B moves in a line 90° right of the final path of A. Find the momentum (in kg m/s) of Ball A after the collision.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT