Question

In: Electrical Engineering

QUESTION 30 In general, construction of the mechanical systems does not include which of the following?...

QUESTION 30

In general, construction of the mechanical systems does not include which of the following?

Rough In

Finish

System design

Startup

1 points   

QUESTION 31

Which of the following OCPD contains spring loaded electrical contacts that open circuits in the event of short circuit or overload?

Time Delay Fuse

Non-Time Delay Fuse

Circuit Breaker

Plug Fuse

1 points   

QUESTION 32

A _______ drain is a cast iron or plastic plumbing fixture set flush with the finished floor to receive water drained from the floor and convey it into the sanitary drainage system.

a.
Floor

b.
Sewer

c.
Rainwater

d.
None of the above

1 points   

QUESTION 33

In mechanical system design for All Air HVAC, the Operating Mode that utilizes Outside Air as "free cooling" is called?

Reciprocating Compressor

HEPA Filters

Oversized condenser coil

Economizer

1 points   

QUESTION 34

What is using outside sunlight in offices to lower energy cost called?

Sun Downing

Daylight harvesting

Light filtering

1 points   

QUESTION 35

PVC pipe connections are most commonly:

Glued

Soldered

Threaded

Flared

1 points   

QUESTION 36

What is the purpose of stairwell pressurization?

Send an alarm to the occupants.

Provide strong positive air pressure in the stairwell

Provide cooling in the stairwell

Provide strong negative air pressure in the stairwell

1 points   

QUESTION 37

Which of the following is not part of "passive" fire protection?

Wall Assembly

Fire Stopping

Fireproofing Steel

sprinklers

1 points   

QUESTION 38

What piping material is generally NOT used in domestic water systems?

a.
Copper

b.
Cast Iron

c.
CPVC

d.
PEX

Solutions

Expert Solution


Related Solutions

This week, your Mechanical and Electrical Systems in Architecture, Engineering, and Construction textbook refers to the...
This week, your Mechanical and Electrical Systems in Architecture, Engineering, and Construction textbook refers to the National Electrical Code (NEC), or NFPA 70, the set of specifications and standards for installing electrical wiring and equipment in the United States. Similarly, the Canadian Electrical Code (CEC), or CE Code, defines the requirements for electrical installation in Canada. For this week’s Discussion, you will focus on the inspection requirements for electrical systems used in commercial buildings in your community. Begin by researching...
Answer the following question. Describe an electro-mechanical machine. How do the systems work together to achieve...
Answer the following question. Describe an electro-mechanical machine. How do the systems work together to achieve a common goal?
So what is the basic definition of Mechanical and Electrical Systems? In addition, what does the...
So what is the basic definition of Mechanical and Electrical Systems? In addition, what does the word "energy" mean?
• Features of computer-based accounting systems which distinguish them from manual or mechanical accounting systems •...
• Features of computer-based accounting systems which distinguish them from manual or mechanical accounting systems • Factors for consideration in risk assessment in a computer-based environment Millichamp (2008) • Ways in which IT benefits an entity’s internal control system • Risks IT poses to an entity’s internal control system • Consideration in auditing sales invoicing and sales reporting processes in a manual and a computer-based environment - Auditing to gain assurance on the management assertion of completeness of sales
Which of the following is an example of mechanical isolation?
Which of the following is an example of mechanical isolation?Many insects have intricate "lock and key" mechanisms that prevent the male genitalia of one species from engaging with the female genitalia of a different species.A sponge excretes eggs and sperm into the water, but only gametes from the same species will fertilize each other.A mule, the offspring of a horse and a donkey, is sterile.A female moth produces a pheromone to which male moths of another species are indifferent.
The "headline" unemployment rate (U-3) does not include which of the following
The "headline" unemployment rate (U-3) does not include which of the followingdiscouraged workersother marginally attached workersthose working part-time for economic reasonsall of the aboveThe demand for loanable funds is negatively related to the real interest rate becausehigher real interest rates generate more savinghigher real interest rates raise the cost of capitalhigher real interest rates are caused by monetary policyhigher real interest rates lower the cost of capitalQUESTION 37For a closed economy, GDP is $11 trillion, consumption is $7 trillion, taxes...
Two general frameworks for planning include program planning and community health planning. Which of the following...
Two general frameworks for planning include program planning and community health planning. Which of the following approaches illustrates a type of community health planning?
Which of the following items does NOT have a constant relationship with sales in general when...
Which of the following items does NOT have a constant relationship with sales in general when we use the percent of sale method to construct pro forma financial statements? Common stock Inventory Accounts receivables Accounts payables
Which one of the following systems has adjacent energy level spacing that does not change with...
Which one of the following systems has adjacent energy level spacing that does not change with increasing quantum number? particle in a one dimensional box Hydrogen atom harmonic oscillator Free rigid rotator The ionization of the H atom is 13.6 eV, it corresponds to the energy difference between the ground state n=1 and the energy level n=: ∞ 100 10 1000 1
Question 5 Which of the following statements is false: A. Conventional product costing systems recognise a...
Question 5 Which of the following statements is false: A. Conventional product costing systems recognise a range of non-volume based cost drivers. B. In conventional costing, the high-volume products are often subsidising the low-volume products. C. Conventional costing systems tend to create a product cost distortion problem. D. Conventional costing systems tend to over cost high-volume product lines.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT