Question
In: Electrical Engineering
A train runs between 2 stations, 2 km apart at a average speed of 40kmph. The...
A train runs between 2 stations, 2 km apart at a average speed of 40kmph. The train is made to run according to the quadrilateral speed time curve. If the max speed is to be limited to 60 kmph, acceleration to 2 kmphps, coasting retardation to 0.15 kmphps and the braking retardation to 3 kmphps. Determine the duration of acceleration, coasting and braking.
Solutions
Manojponduru answered 1 year agoRelated Solutions
A train runs between San Diego, and Kansas City, which is 4 km apart and maintains...
A train runs between San Diego, and Kansas City, which is 4 km
apart and maintains voltages of 450 volts and 400 volts
respectively. The resistance of go and return is 0.05 ohm per km.
The train draws a constant current of 500 A while in motion. What
are the currents supplied by the two stations if the train is at
the distance of minimum potential?
A train travels between stations 1 and 2, as shown in the figure. The engineer of...
A train travels between stations 1 and 2, as shown in the
figure. The engineer of the train is instructed to start from rest
at station 1 and accelerate uniformly between points A and B, then
coast with a uniform velocity between points B and C, and finally
decelerate uniformly between points C and D until the train stops
at station 2. The distances AB, BC, and CD are all equal, and it
takes 5.63 min to travel between the...
Train driving 5 % uphill (2.9o) with speed 120 km/h. Train total mass is 100 000...
Train driving 5 % uphill (2.9o) with speed 120 km/h.
Train total mass is 100 000 kg. The gear ratio is 1 (no
transmission) and the train wheel diameter is 1 m. (Give the answer
of accuracy of at least three significant digits.) Calculate the
required torque: Answer kNm Calculate the required power:
A plane with a speed of 800.0 km/hr due east passes directly above a train traveling...
A plane with a speed of 800.0 km/hr due east passes directly
above a train traveling due southeast at 100.0 km/hr on a straight
level road. The altitude of the aircraft is 10.0 km. How fast is
the distance between the plane and the train increasing 45 s after
the aircraft passes directly above the train?
1. A train moving at a constant speed of 52.0 km/h moves east for 38.0 min,...
1. A train moving at a constant speed of 52.0 km/h moves east
for 38.0 min, then in a direction 45.0° east of due north for 21.0
min, and then west for 65.0 min. What is the average velocity of
the train during this run? a) magnitude- km/h b) °
(counterclockwise from east) 2. A golf ball is struck at ground
level. The speed of the golf ball as a function of time is shown in
the figure below, where...
1. Rachael runs 2 km to her bus stop, and then rides 4.5 km to school....
1. Rachael runs 2 km to her bus stop, and then rides 4.5 km to
school. On average, the bus is 45 km/h faster than Rachael’s
average running speed. If the entire trip takes 25 min, how fast
does Rachael run?
2. Write an equation of a rational function that satisfies all
of these conditions
● Vertical asymptote at x = -8 and x = 5
● Horizontal asymptote at y = 0
● x-intercept at (-2, 0)
● f(0)...
Two Systems 80 Km apart are communicating through a direct Metallic cable (note: signal speed is...
Two Systems 80 Km apart are communicating through a direct
Metallic cable (note: signal speed is 2 x 10^8 m/s). The data is in
the form of 60 KB packets with transmission rate 1M bps. Calculate
the following:
Data transmission time per packet.
Propagation delay.
bit duration.
Bit length.
Number of bits in the cable between the sender and
receiver.
Two Systems 80 Km apart are communicating through a direct Metallic cable (note: signal speed is...
Two Systems 80 Km apart are communicating through a direct
Metallic cable (note: signal speed is 2 x 10^8 m/s). The data is in
the form of 60 KB packets with transmission rate 1M bps. Calculate
the following:
Data transmission time per packet.
Propagation delay.
bit duration.
Bit length.
Number of bits in the cable between the sender and
receiver
Two Systems 80 Km apart are communicating through a direct Metallic cable (note: signal speed is...
Two Systems 80 Km apart are communicating through a direct
Metallic cable (note: signal speed is 2 x 10^8 m/s). The data is in
the form of 60 KB packets with transmission rate 1M bps. Calculate
the following:
Data transmission time per packet.
Propagation delay.
bit duration.
Bit length.
Number of bits in the cable between the sender and receive
A cow that is 2 meters long watches a train passing at 90% of the speed...
A cow that is 2 meters long watches a train passing at 90% of
the speed of light. According to the cow the train measures 15
meters.
What is the factor of temporal expansion between time in the
benchmark of the cow and time in the benchmark of the train?
b. How tall is the cow according to the train passengers?
vs.
How long does the train take to pass the cow according to the
cow?
d. According to...
ADVERTISEMENT
ADVERTISEMENT
Latest Questions
- Enumerations Create an advanced enumeration to represent months (JANUARY – DECEMBER) called enuMonths Add internal properties...
- What is the minimum size of the automorphism group of a simple directed graph having more...
- The birthday paradox says that the probability (chance) that two people in a room will have...
- #include <iostream> #include "lib.hpp" using namespace std; int main() { // declare the bool bool...
- Why do we compare means instead of individual scores? for comparing average SAT test scores across...
- NPV Your division is considering two projects with the following cash flows (in millions): 0...
- The equivalent synchronous impedance of a 25kVA, 400V three-phase Y-connected synchronous generator is 0.05 + j1.6...
ADVERTISEMENT