Does isoctane/n octane mixture follow roults law?

Solutions

Expert Solution

The binary system given follows Raoult' s law at low temperatures and shows small positive deviation from Rault's law at high temperatures

http://www.whxb.pku.edu.cn/EN/abstract/abstract23380.shtml

from above data, we can see experimentsal total pressure P=exp is greater than the theoretical Total pressure P=P₂⁰+(P₁⁰-P₂⁰)x from Raoult's law . Therefore It has Positive deviation from Raoult's law as the tempertaure increases.

Amanda K answered 1 year ago

Next > < Previous

Related Solutions

. A liquid mixture containing 25.0 wt% n-octane (ρoct = 703 kg/m3 ) and the balance...

. A liquid mixture containing 25.0 wt% n-octane (ρoct = 703 kg/m3 ) and the balance n-decane (ρdec = 730 kg/m3 ) flows into a tank mounted on a balance. The mass in kg indicated by the scale is plotted against time. The data fall on a straight line that passes through the points (t = 3 min, m = 225 kg) and (t = 10 min, m = 510 kg). (a) Estimate the volumetric flow rate of the liquid...

7. Suppose you were given a mixture of n-octane, sodium chloride and water to separate. Using...

7. Suppose you were given a mixture of n-octane, sodium chloride and water to separate. Using the information gathered for these and similar compounds in this experiment, and using what you know about the properties of these materials from other contexts, outline a procedure that could be used to do a quantitative separation of these three materials. Your procedure should be specific enough, that if followed, someone could determine the mass of each of the three materials present in the...

Does octane matter: Octane is a measure of how much fuel can be compressed before it...

Does octane matter: Octane is a measure of how much fuel can be compressed before it spontaneously ignites. Some people believe that higher-octane fuels result in better gas mileage for their cars. The number of miles driven for various drivers until the car ran out of gas was recorded. Does high-octane fuel result in better gas mileage? Use significance level 0.05. (Paired samples). Driver 1 2 3 4 5 6 7 8 9 10 11 87 octane 234 257 243...

A gasoline mixture containing 60.0% by weight octane (C8H18) and 40.0% by weight hexane (C6H14) has...

A gasoline mixture containing 60.0% by weight octane (C8H18) and 40.0% by weight hexane (C6H14) has a density of 0.660 g mL–1. Calculate the number of cubic meters of air at STP drawn through the carburetor when one imperial gallon of this gasoline is combusted in an automobile engine, assuming complete combustion of the fuel to carbon dioxide and water vapor. Air contains 21.0% by volume of oxygen. One pound (lb) = 453.59 g; one imperial gallon (IG) of water...

The table below shows the vapor pressures, VP (kPa) for n‐hexane and n‐octane. Vapor Pressure (kPa)...

The table below shows the vapor pressures, VP (kPa) for n‐hexane and n‐octane. Vapor Pressure (kPa) Vapor Pressure (kPa) Temp (C) n‐Hexane n‐Octane 68.7 101 13 79.4 137 23 93.3 197 37 107.2 284 58 121.1 400 87 125.7 456 101 Source. J. B. Maxwell, Data Book on Hydrocarbons (a) Assuming ideal solution and gas behavior, construct Txy and xy diagrams for this system at 101 kPa. (b) When a liquid containing 30 mol% n‐Hexane is heated, what is the...

A small quantity of n-octane is placed in a wide test tube at 20 degrees C...

A small quantity of n-octane is placed in a wide test tube at 20 degrees C and two capillaries are inserted vertically and immersed to the same depth. The radii of the capillaries are unknown but are of the order of 0.1 and 0.01 mm. Air is blown through each capillary in turn and the pressure necessary to just produce a slow stream of bubbles is recorded on a manometer filled with water. Show that the surface tension of each...

Write the equation for the complete combustion of octane. If the heat of combustion of octane...

Write the equation for the complete combustion of octane. If the heat of combustion of octane is -5294 kJ/mol, determine how many kJ of energy could be obtained from the combustion of one gallon of gasoline (assume the density is 703 kg/m3).

a. A mixture of 60 mol % n-proplycyclohexane and 40 mol % n-propylbenzene is distilled through...

a. A mixture of 60 mol % n-proplycyclohexane and 40 mol % n-propylbenzene is distilled through a simple distillation apparatus; assume that no fractionation occurs during the distillation. The boiling temperature is found to be 157 °C (760 torr) as the first small amount of distillate is collected. The standard vapor pressures of n-propylcyclohexane and n-propylbenzene are known to be 769 torr and 725 torr, respectively, at 157.3 °C. Calculate the percentage of each of the two components in the...

Consider a mixture of 30% n-butane, 35% n-hexane, 35% n-heptane. If the pressure is 202 kPa,...

Consider a mixture of 30% n-butane, 35% n-hexane, 35% n-heptane. If the pressure is 202 kPa, calculate the bubble point temperature in ?C and the unknown mole fractions. Specify whether the unknown mole fractions are vapor or liquid. .

Dalton's law states that the total pressure, Ptotal, of a mixture of gases in a container...

Dalton's law states that the total pressure, Ptotal, of a mixture of gases in a container equals the sum of the pressures of each individual gas: Ptotal=P1+P2+P3+… The partial pressure of the first component, P1, is equal to the mole fraction of this component, X1, times the total pressure of the mixture: P1=X1×Ptotal The mole fraction, X, represents the concentration of the component in the gas mixture, so X1=moles of component 1total moles in mixture Part A Three gases (8.00...

Subjects