For steel member is subjected to cyclic loads, The experimental results indicated failure at a number...

For steel member is subjected to cyclic loads,

The experimental results indicated failure at a number of cycles of 52 when the maximum stress is 1071 MPa. Also, failure at a number of cycles of 380,000 when the applied maximum stress is 506 MPA.

Find the fatigue equations for stress vs number of cycles using

σ = A N^B And σ = A (2N)^b

2) Plot on the same diagram both functions

3) Discuss the results of the two plots.

4) Find the number of cycles to failure when the maximum stress is 950 MPa in both functions

Solutions

Expert Solution

Ally Wells answered 7 months ago

Next > < Previous

Related Solutions

A high carbon steel shaft is used in an engine and subjected to different loads. In...

A high carbon steel shaft is used in an engine and subjected to different loads. In order to analyse the stress in the shaft, consider a rectangular element within the material. This element is subjected to compressive stress of 135 MPa and shear stress of 166MPa in the vertical direction. The compressive stress in the horizontal direction is 176MPa with a shear stress of 115MPa. a. Sketch the state of stress on this element. b. Determine the maximum and minimum...

A steel cantilever member as shown below is subjected to a transverse load at its end...

A steel cantilever member as shown below is subjected to a transverse load at its end that varies from 135 N to -45 N as axial load varies from 450 N to -110 N. Determine the required diameter at the change of section for infinite life using a factor of safety of 2. The strength properties of the material are: Sut=550 MPa, Sy=470 MPa, Se(corrected)=275 MPa, Test data indicate that the theoretical stress concentration factor for bending and axial loads...

Subjects