Question

In: Other

Plot the shear flow distribution around the section, with values in terms of S and a

Fig. 8 shows the regular hexagonal cross-section of a thin-walled beam of sides ‘a’ and constant wall thickness t. The beam is subjected to a transverse shear force S, its line of action being along a side of the hexagon, as shown. Find the rate of twist of the beam in terms oft, a, S and the shear modulus G. Plot the shear flow distribution around the section, with values in terms of S and a

jld2.png

Solutions

Expert Solution


Related Solutions

Plot the shear strain and the shear strain rate as functions of the shear angle, for...
Plot the shear strain and the shear strain rate as functions of the shear angle, for several tool rake angles. Describe your observations.
Plot a binomial distribution for three different pairs of values of p and N; ii) plot...
Plot a binomial distribution for three different pairs of values of p and N; ii) plot a Chi-square distribution for three different degrees of freedom, and; iii) plot a t-distribution for three different degrees of freedom. For EACH set of distributions, note how the shape of the distribution is affected by changing parameters. You must choose an appropriate range of values for the x-axis so that the at least 99% of the density of the distribution is visible. A common...
a. Using shear flow ideas, explain why the HSS section is torsionally stiffer than the W...
a. Using shear flow ideas, explain why the HSS section is torsionally stiffer than the W section b. Compute the torsional constant for a W14X34 section and compare with the value from the AISC table c. What is the role of warping restraint on torsional stiffness? Explain with a figure
plot 1/Vo Vs 1/[S] (Lineweaver-Burk plot) and calculate the values of Km and Vmax from the...
plot 1/Vo Vs 1/[S] (Lineweaver-Burk plot) and calculate the values of Km and Vmax from the intercepts .Give units
define the terms - Shear strain in shaft - Shear stress in shaft - Polar moment...
define the terms - Shear strain in shaft - Shear stress in shaft - Polar moment of inertia - Polar section modulus - Torsion rigidity -torsion
What are the main factors affecting the shear capacity of the diagonal section?
What are the main factors affecting the shear capacity of the diagonal section?
Discuss the differences between Newtonian and non-Newtonian fluids in terms of shear stress vs. shear rate...
Discuss the differences between Newtonian and non-Newtonian fluids in terms of shear stress vs. shear rate characteristics.
Is it possible to obtain the maximum values of the transverse shear stress and flexural stress...
Is it possible to obtain the maximum values of the transverse shear stress and flexural stress without knowing the location of the maximum shear and moment? Explain your answer.
Derive the equation for the shear strain in terms of the mobile dislocation density and velocity
Derive the equation for the shear strain in terms of the mobile dislocation density and velocity
A direct shear test is conducted on a large specimen of dry sand (square cross section...
A direct shear test is conducted on a large specimen of dry sand (square cross section with following dimensions: 7.5 cm x 7.5 cm x 3.0 cm [height], Mass = 271.0 g) with a normal stress of 500 kPa. Failure occurred when the horizontal force was 1.96 kN. For the same sand, tests were also conducted to determine the specific gravity and the maximum and minimum void ratios. These tests yielded the following results: Gs= 2.65, emax=0.80, emin = 0.45....
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT