Pure water at 26.1 degres celcius flows at the rate of 5.514x10^-7 m^3/s through a packed...

Pure water at 26.1 degres celcius flows at the rate of 5.514x10^-7 m^3/s through a packed bed of benzoic acid spheres having a diameter of 6.375 mm. The total surface area of the spheres in the bed s 0.01198m^2 and the void fraction is 0.436. The tower diameter is 0.0667m. The solubility of benzoic acid is 2.9488x10^-2 kg mol/m^3.

a. What is the mass tranfer coefficient?

b. What is the outlet concentration of benzoic acid in the water?

Expert Solution

Amanda K answered 2 years ago

Air at 80oC flows through a packed bed of cylinders with effective diameter of 0.015 m...

Air at 80oC flows through a packed bed of cylinders with effective diameter of 0.015 m and length the same as the diameter. The bed void fraction is 0.40 and the length of the packed bed is 2 2 m. The air enters the bed at 1.3 atm abs at the rate of 2.45 kg/m .s. Calculate the pressure drop of air in the bed

Water flows at a rate of 6m^3 / s in a rectangular channel of 3m width...

Water flows at a rate of 6m^3 / s in a rectangular channel of 3m width and 60cm water depths . Check whether the hydraulic jump occurs or not . If it is occurred , then determine the total energy loss during the jump and the jump efficiency . What is the type of this jump ? Question by hydraulic structures material Theme Hydraulic Jump

Water flows through a 3 inch diameter pipe at a velocity of 10 ft/s. Find the...

Water flows through a 3 inch diameter pipe at a velocity of 10 ft/s. Find the a) volume flow rate in cfs(cubic feet per second) and gpm(gallons per minute) b) mass flow rate in slug/second.

3) Air flows steadily at the rate of 0.4 kg/s through an air compressor, entering at...

3) Air flows steadily at the rate of 0.4 kg/s through an air compressor, entering at 6 m/s with a pressure of 1 bar and a specific volume of 0.85 m3/kg, and leaving at 4.5 m/s with a pressure of 6.9 bar and a specific volume of 0.16 m3/kg. The internal energy of air leaving is 88 kJ/kg greater than that of the air entering. Cooling water in a jacket surrounding the cylinder absorbs heat from the air at...

4 m3/s of water flows in a Rectangular channel with base width 3 m, base slope...

4 m3/s of water flows in a Rectangular channel with base width 3 m, base slope J= 0.0016 and roughness coefficient K= 80. a) find the normal depths and critical depth of the current. B) determine the current regime. roughhness coefficient given 80

Water at a local bulk temperature of 24°C flows at 0.8 m/s through a smooth, 1.5-cm-ID...

Water at a local bulk temperature of 24°C flows at 0.8 m/s through a smooth, 1.5-cm-ID tube that is kept at 30°C and the flow is fully developed. a) The system is extremely clean and quiet; therefore, the flow stays laminar regardless of the magnitude of ReD, until a noisy air compressor is turned on in the laboratory. Then the flow suddenly goes turbulent. Calculate the ratio of turbulent to laminar heat transfer coefficients. Use the Gnielinski correlation for turbulent...

Water flows through a shower head steadily at a rate of 8 kg/min. The water is...

Water flows through a shower head steadily at a rate of 8 kg/min. The water is heated in an electric water heater from 158C to 458C. In an attempt to conserve energy, it is proposed to pass the drained warm water at a temperature of 388C through a heat exchanger to preheat the incoming cold water. Design a heat exchanger that is suitable for this task, and discuss the potential savings in energy and money for your area.

Water flows steadily through a splitter as shown in the figure with Q, = 0.08 m³...

Water flows steadily through a splitter as shown in the figure with Q, = 0.08 m³ / sec, Q, = 0.05 m3 / sec, D, = D2 = 12 cm, D3 = 10 cm. If the pressure readings at the inlet and outlets of the splitter are P, = 100 KPa, P2 = 90 KPa and P3 = 80 KPa, determine external force needed to hold the splitter. Disregard the weight effects.

Air flows through this tube at a rate of 1400cm3/s . Assume that air is an...

Air flows through this tube at a rate of 1400cm3/s . Assume that air is an ideal fluid. What is the height h of mercury in the right side of the U-tube?

Air flows through a 0.25-m-diameter duct. At the inlet the velocity is 300 m/s, and the...

Air flows through a 0.25-m-diameter duct. At the inlet the velocity is 300 m/s, and the stagnation temperature is 90°C. If the Mach number at the exit is 0.3, determine the direction and the rate of heat transfer. For the same conditions at the inlet, determine the amount of heat that must be transferred to the system if the flow is to be sonic at the exit of the duct.

Question