Code in Matlab for a low pass filter and a high pass
filter. Each filter must...
Code in Matlab for a low pass filter and a high pass
filter. Each filter must show the frequency response (magnitude and
phase) in graphs properly labelled.
Low-Pass RC
Filter.
Design a low-pass RC filter that will attenuate the amplitude
of a 400 Hz sinusoidal wave by a factor of two. Draw a schematic
diagram for your filter, labeling Vin,
Vout, and your specific choices for
your R and C values.
At 400 Hz, does the output signal from your filter lead or lag
the input signal? By what phase does it lead or lag?
On the same set of axis, sketch Vin and
Vout as a...
Butterworth filter
a)Design a 5th order low pass Butterworth low-pass filter with a
cut-off frequency of 1592 Hz and a dc gain of 3dB. Find and present
the mathematical transfer function of the filter, showing all your
steps.
b) Write a Matlab code to plot the magnitude of this function
with a linear scale in dB units on the ordinate, and a log scale of
frequency on the abscissa.
The plot range should be: ordinate- linear scale from -100dB to...
In
matlab using a RC low pass filter Create a 1 Hz input signal (with
amplitude of one). Corrupt the input signal with signals greater
than or equal to 100 Hz and/or random noise. Use
randn(length(v_in,1)) to test filter
ı need an explanation filter types sound related (
low-pass, high pass, bandpass, band reject) but what ı need is not
contactor projection, more written explanation
Write a report 3-4 pages in DSP
Digital FIR filter design Analysis {Low Pass Filter(LPF) ,High
Pass Filter(HPF), Band Pass Filter (BPF), Band Stop Filter (BSF)}
Design
1-way of design and system pools evaluation
Find the area (in mm2) needed for each element to
design a Low Pass Filter which has ?=1?Ω, C=1.125nF, L=2.25mH using
on-chip elements for R, C and L with assuming room temp and process
limits of
1) Resistors from boron substrate doping 1E16cm-3 and Thickness
of 0.5µm and line width/space of 0.05µm.
2) Capacitors from SiO2 gate dielectric 1.8nm thick
any square dimension.
3) Inductors from Aluminum lines: 0.25µm high x 0.10µm wide
spaced 0.10µm apart in k=3.0 dielectric.
4)...