Air at 40 degrees C is humidified by flowing over a 1-m-long container filled with water....

Air at 40 degrees C is humidified by flowing over a 1-m-long container filled with water. The surface area of container is 0.5m^2.The interfacial temperature is 20 degrees C. If the initial humidity of the air is 0% and its velocity is 0.5 m/s, calculate the mass flow rate of vapor evaporated.

Expert Solution

samet mamat answered 2 years ago

Air at 20°C (1 atm) is flowing over a 0.025-m diameter sphere with a velocity of...

Air at 20°C (1 atm) is flowing over a 0.025-m diameter sphere with a velocity of 3.5 m/s. If the surface temperature of the sphere is constant at 80°C, determine the Reynolds number corresponding to the sphere, its average drag co-efficient, and the heat transfer rate from the sphere. The properties of air (1 atm) at the free stream temperature T∞ = 20°C, ρ = 1.204 kg/m3, k = 0.02514 W/m∙K, μ = 1.825 × 10−5 kg/m∙s, and Pr = 0.7309. At the surface temperature Ts= 80°C: μs =...

A container of water has 400 mL of water at 90 degrees C. You add 100...

A container of water has 400 mL of water at 90 degrees C. You add 100 grams of ice at -20 degrees C. What is the final temperature of the mixture? please show work

how long it takes for one gallon of tap water (40 F) in a container (...

how long it takes for one gallon of tap water (40 F) in a container ( fiberglass, metal, plastic) sitting in a room (72 F) to rise one degrees F? Thank you

Water flowing at a rate of 0.03 kg/s is heated from 20 to 40°C in a...

Water flowing at a rate of 0.03 kg/s is heated from 20 to 40°C in a horizontal pipe (inside diameter = 3 cm). The inside pipe surface temperature is 70°C. Estimate the convective heat transfer coefficient if the pipe is 1 m long. Assume forced convection conditions. Ts is not held constant! Properties of Water 20°C 30°C 40°C ρ (kg/m3) 998.2 995.7 992.2 k (W/mK) 0.597 0.615 0.633 μ (Pa s) 993.414 x 10-6 792.377 x 10-6 658.026 x 10-6 Cp...

Water at a temperature of 80 °C and velocity of 1.2 m/s is flowing parallel to...

Water at a temperature of 80 °C and velocity of 1.2 m/s is flowing parallel to one side of a smooth flat plate. The plate is maintained at a constant temperature of 24 °C and is 0.8 m long and 0.5 m wide. Determine the following: The heat flux at a distance x = 0.6m from the front edge of the plate, q” = ____________ The location of the maximum heat flux on the plate, x = _________ The total...

A graduated cylinder filled with water rests upside down in a container of water at 0...

A graduated cylinder filled with water rests upside down in a container of water at 0 C. The water is 7.00 cm deep. Attached to the base of the cylinder is a small ring (but since the cylinder is upside down, the ring is at the highest elevation, available for grabbing). The base of the cylinder has mass 10.0 grams with ring included. The cylinder itself has radius 3.00 cm, height 40.0 cm, and mass 100.0 grams (including the base...

Determine the friction factor, f if water at 71 °C is flowing at 9.1 m/s in...

Determine the friction factor, f if water at 71 °C is flowing at 9.1 m/s in 25.4 mm Schedule 40 steel pipe. Given, roughness, Ɛ = 4.57 X 10-5 m.

Two Film Cannisters are filled with water. These will be used in Calorimeter. One container will...

Two Film Cannisters are filled with water. These will be used in Calorimeter. One container will be used for heated pennies and the other for heated nickels. The pennies and nickels will be heated to a temp of 66 C. The cannister that will have pennies dropped into it, has a temperature of 20.1 C and a mass of 15.57g. The cannister that will have nickels dropped into it, has a temperature of 19.7 C and a mass of 17,33g....

3) A polystyrene container is filled to the brim with water at 0 0C and sealed...

3) A polystyrene container is filled to the brim with water at 0 0C and sealed with a polystyrene lid of the same thickness as the container. The sealed container is immersed in a reservoir of liquid Nitrogen at a temperature of 73 K. The surface area of the container is 5 x 10-2 m2 and the rate of heat flow from the inside to the outside of the container is 66 Watts. (a) Assuming the temperature of inner and...

cylindrical container with circular hole at the bottom with diameter d , is filled with water...

cylindrical container with circular hole at the bottom with diameter d , is filled with water to height h . Which of the following statement is correct for the itime required to empty the container If d is constant , the time is inversely proportional to the height of water . If h is constant , the time is inversely proportional to the area of hole . If his constant , the time is directly proportional to the area of...

Question