Question

In: Mechanical Engineering

A noise source produces sound mainly at 2500 Hz and an SPL of 95 dB at...

A noise source produces sound mainly at 2500 Hz and an SPL of 95 dB at the location of a worker. In order to decrease this worker’s noise exposure, the employer decides to build a brick wall (? = 400 kg/m2) between source and worker. What would the sound level at the worker’s location be after the wall is built. Assume that the wall is perfect and that the sound must go through it (not around it).

Solutions

Expert Solution


Related Solutions

A.) If the sound volume increases from 60 dB to 80 dB, then the sound volume...
A.) If the sound volume increases from 60 dB to 80 dB, then the sound volume increases by a factor of??? (Remember that you can enter large numbers like 100000 as 1e5) B.) If the sound volume decreases from 120 dB to 40 dB, then the sound volume decreases by a factor of??
An audio system 1 produces a sound level of 90.0 dB and system 2 produces a...
An audio system 1 produces a sound level of 90.0 dB and system 2 produces a sound level of 93.0 dB. (a) Determine the ratio of the intensities (in W/m 2 ) . (b) Suppose a recording device was placed 2 m away from s ystem 2 . H ow far away from system 1 must that recording device be placed in order for the intensity to be the same as it was near system 2?
A sound wave generated by a source of frequency 440 Hz is moving through 25 oC...
A sound wave generated by a source of frequency 440 Hz is moving through 25 oC air. The sound wave strikes a solid block of steel and propagates into the steel. What is the wavelength of the sound wave inside the steel. The density of steel is 7.85 g/cm3 and the bulk modulus of steel is 1.6 x 1011 N/m2 . Select a choice 1. 0.787 m 2. 4515 m 3. 346 m 4. 10.26 m 5. 1.27 m
Sound with a frequency 710 Hz from a distant source passes through a doorway 1.17 m...
Sound with a frequency 710 Hz from a distant source passes through a doorway 1.17 m wide in a sound-absorbing wall. (a) Find the number of the diffraction minima at listening positions along a line parallel to the wall. (b) Find the angular directions of the diffraction minima at listening positions along a line parallel to the wall. (Enter your answers from smallest to largest starting with the first answer blank. Enter NONE in any remaining answer blanks.)
What dB level corresponds to a 500 Hz tone that is perceived to be at 40...
What dB level corresponds to a 500 Hz tone that is perceived to be at 40 phons?
A sound wave with an intensity level of 80.6 dB is incident on an eardrum of...
A sound wave with an intensity level of 80.6 dB is incident on an eardrum of area 0.600 ✕ 10-4 m2. How much energy is absorbed by the eardrum in 4.0 minutes? µJ? A source of sound waves of frequency 1.2 kHz is traveling through the air at 0.55 times the speed of sound. (a) Find the frequency of the sound received by a stationary observer if the source moves toward her. Hz (b) Repeat if the source moves away...
Design a matlab code that: 1-play sound 2- add noise to the sound 3- filter the...
Design a matlab code that: 1-play sound 2- add noise to the sound 3- filter the noised signal using fir or iir filter Note: FIR: Finite impulse response filter IIR: Infinite impulse response filter
In a location where the speed of sound is 332 m/s, a 2,000 Hz sound wave...
In a location where the speed of sound is 332 m/s, a 2,000 Hz sound wave impinges on two slits 30 cm apart. (a) At what angle is the first-order maximum located? ° (b) If the sound wave is replaced by 4.60 cm microwaves, what slit separation gives the same angle for the first-order maximum? cm (c) If the slit separation is 1.00 μm, what frequency of light gives the same first-order maximum angle? Hz
The ideal (daytime) noise-level for hospitals is 45 decibels with a standard deviation of 10 db;...
The ideal (daytime) noise-level for hospitals is 45 decibels with a standard deviation of 10 db; which is to say, this may not be true. A simple random sample of 81 hospitals at a moment during the day gives a mean noise level of 47 db. Assume that the standard deviation of noise level is really 10 db. All answers to two places after the decimal. (a) A 99% confidence interval for the actual mean noise level in hospitals is...
A communication network has a bandwidth of 10 kHz. Calculate the signal-to-noise ratio in dB if...
A communication network has a bandwidth of 10 kHz. Calculate the signal-to-noise ratio in dB if the capacity of the channel for a 100Kbps [2 Marks] ii. A communications channel with a bandwidth of 4kHz has a signal power to noise ratio of 7. Determine the Channel Capacity. [2 Marks] ii. The bandwidth in b above is reduced by 25%. How much should the signal power be increased to maintain the same channel capacity?
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT