A 500 nF capacitor is initially connected to a 100 V DC voltage source. At some...

A 500 nF capacitor is initially connected to a 100 V DC voltage source. At some long time later, the switch is flipped and the capacitor is now connected to a 120 mH inductor.

a) What is the frequency of oscillation in the circuit after the switch is flipped.

b) After the switch is filpped, what would the peak current value be?

c) What is the maximum possible value for the energy stored in the inductor?

d) The energy in an LC circuit oscillates between the inductor and the capacitor. What is the charge on the capacitor when the energy in the inductor is half of its maximum value?

e) The energy in an LC circuit oscillates between the capacitor and the inductor. If I is initially zero when the switch is flipped (t = 0) how much time has elapsed before the energy in the inductor is half of its maximum.

Expert Solution

genius_generous answered 2 years ago

A 100 Hz AC voltage source, with a peak output of 170 V, is connected to...

A 100 Hz AC voltage source, with a peak output of 170 V, is connected to an inductor. If the rms current through the inductor is 1 A, what is the value of the inductor? 1. 1.9 H 2. 190 mH 3. 19 mH 4. 1.9 mH

If the voltage amplitude across an 8.50-nF capacitor is equal to 12.0 V when the current...

If the voltage amplitude across an 8.50-nF capacitor is equal to 12.0 V when the current amplitude through it is 3.33 mA, the frequency is closest to: A) 32.6 MHz B) 5.20 MHz C) 32.6 kHz D) 5.20 kHz E) 32.6 Hz

10.An AC voltage source is connected in series to an inductor, a capacitor, and a resistor...

10.An AC voltage source is connected in series to an inductor, a capacitor, and a resistor of 8 Ohms. At the frequency when the phase angle is zero, capacitive reactance is 7 Ohms. What is the phase angle between the current and voltage at a frequency which is a factor of 3.2 times less than this frequency? answer in degresss and if negative 6. the resistance of a coil spun in a generator is 2 Ohms. the coil is in...

2. A 15-MΩ resistor and a 48-nF capacitor get connected in series to a 15-V battery....

2. A 15-MΩ resistor and a 48-nF capacitor get connected in series to a 15-V battery. a. How long will it be until the capacitor is “fully” charged? b. If the battery is then disconnected from the circuit, how long will it be until the capacitor’s voltage is 9.0 V? What is the charge of the capacitor at that moment? c. If we’d like the capacitor’s voltage in this circuit to decrease from 15-V to 9.0-V in 1.5 seconds after...

A series RC circuit is connected in parallel to a 5 volt DC voltage source, where...

A series RC circuit is connected in parallel to a 5 volt DC voltage source, where resistance R=1 M ohm and capacitance C= 1 microfarad. If at the start of operation, voltage across the capacitor is 5 volts, calculate the voltage across the capacitor at t=2 seconds. Also sketch the instantaneous voltage across the resistor. using differential equation.

A 1200 kW, 550 V DC generator has a terminal voltage of 500 V at rated...

A 1200 kW, 550 V DC generator has a terminal voltage of 500 V at rated current. It is being driven at a speed of 400 rpm. The armature resistance is 0.0009 Ω. a. Determine the armature voltage. b. Determine the developed torque. c. Determine the armature copper loss.

A capacitor of unknown capacitance C is charged to 130 V and connected across an initially...

A capacitor of unknown capacitance C is charged to 130 V and connected across an initially uncharged 75 uF capacitor. if the final potential difference across the 75 uF capacitor is 47 V what is C? After you find the value of C, you charge this capacitor C to a potential difference V=140 V between its plates. The charging battery is now disconnected and a slab material ( k=7.20 is slipped between the plates. what is the potential energy of...

A 100 F capacitor and a 225 resistor are connected in series with a 75.0 V battery....

A 100 F capacitor and a 225 resistor are connected in series with a 75.0 V battery. The switch is closed and the capacitor begins to charge. a)When does the capacitor hold 15.0 % of its maximum charge? Express your answer in milliseconds. b)What is the voltage across the resistor at this same time? Please state your answers as clear as possible and show all the steps and formulas used. Thank you!!!

2- Develop a simulink model for natural PWM inverter connected to a dc source of 100...

2- Develop a simulink model for natural PWM inverter connected to a dc source of 100 V and an output frequency of 60 Hz. The load is a series RL load with R = 10 Ohm and L = 25 mH. Use the simulation to Determine (a) The frequency Ratio to eliminate the 11th harmonic . (b) The fundamental output Voltage V1 (first term of Fourier series) (c) The fundamental output current I1 (d) If the load requires a fundamental...

An 8.5 nF capacitor is charged up by a 20 V battery. The battery is removed...

An 8.5 nF capacitor is charged up by a 20 V battery. The battery is removed and replaced with a coil of wire. It then takes 7.3 x 10-5 s for this now LC circuit to undergo a full charging cycle. (a) Calculate the inductance of the coil (b) Calculate the total energy of the circuit (c) Calculate the charge on the capacitor after 1 x 10-5 s.

Question