Question

In: Mechanical Engineering

A refrigerator with a cooling capacity of 5 ton uses ammonia as the working fluid. The...

A refrigerator with a cooling capacity of 5 ton uses ammonia as the working fluid. The condenser and evaporator maintain a pressure of 1500 kPa and 200 kPa respectively. The compressor has an isentropic efficiency of 80%. If the vapor leaving the evaporator is superheated by 5°C and the liquid leaving the condenser is supercooled by 5°C, determine:
a) The power input to the compressor

b) The mass flow rate of ammonia

c) The COP of the refrigerator

Solutions

Expert Solution

samet mamat answered 2 years ago
Next > < Previous

Related Solutions

a refrigerator uses refrigerant 134a as a working fluid and operates on the vapour -compression refrigiration...
a refrigerator uses refrigerant 134a as a working fluid and operates on the vapour -compression refrigiration cycle.the evaporator is maintained at -100C and the refrigirant is a dry saturated vapour as it leaves the evaporator. the compressor has an efficiency of 80%.the conditions at the outlet of the condensor are 300C and 9 bar. 1-if the mass flow rate of the refrigerant is 0,08kg/s workout the rate of heat removal from the refrigerant space.the power input to the cpmpressor and...
A commercial refrigerator with refrigerant 134a as the working fluid is used to keep the refrigerated...
A commercial refrigerator with refrigerant 134a as the working fluid is used to keep the refrigerated space at TL = -35°C by rejecting waste heat to cooling water that enters the condenser at 18°C at a rate of 0.25 kg/s and leaves at 26°C. The refrigerant enters the condenser at 1.2 MPa and 50°C and leaves at the same pressure and 41.3°C. If the compressor consumes 3.3 kW of power, determine (a) the mass flow rate of the refrigerant, (b)...
A refrigerator is running with tetrafluoroethane (R1-34a) as the fluid and working based on the following...
A refrigerator is running with tetrafluoroethane (R1-34a) as the fluid and working based on the following cycle. Saturated vapor at -12oC is entering the compressor and leaving it at 40oC. The superheated vapor after the compressor then condensed at constant pressure to saturated liquid, which ethers the “Joule-Thompson” throttling valve and back to the initial pressure. Assume your system is operating ideally, with a cooling load of 0.2 kW (200 J/s). (a) Draw the cycle on the P-H diagram and...
A refrigerator with R-410a as the working fluid has a minimum temperature of −10°C and a...
A refrigerator with R-410a as the working fluid has a minimum temperature of −10°C and a maximum pressure of 1 MPa. Assuming an ideal refrigeration cycle, find the specific heat transfer FROM the cold space, the specific heat transfer TO the hot space, and the coefficient of performance. Will this refrigeration cycle work in an ordinary kitchen?
A refrigerator using R-12 as the working fluid keeps the refrigerated space at ?16? in an...
A refrigerator using R-12 as the working fluid keeps the refrigerated space at ?16? in an environment at 27?. You are asked to upgrade this refrigerator by replacing R-12 with the ozone-friendly R-134a. What changes in the pressure levels would you suggest in the new system? How do you think the COP of the new system will compare to the COP of the old system?
A refrigerator using R-12 as the working fluid keeps the refrigerated space at ?16? in an...
A refrigerator using R-12 as the working fluid keeps the refrigerated space at ?16? in an environment at 27?. You are asked to upgrade this refrigerator by replacing R-12 with the ozone-friendly R-134a. What changes in the pressure levels would you suggest in the new system? How do you think the COP of the new system will compare to the COP of the old system?
Design a refrigerator working on propane ammonia and R407C refrigerant and producing -20K, -10K and O...
Design a refrigerator working on propane ammonia and R407C refrigerant and producing -20K, -10K and O K temperature during steady state operation.... carryout experimental validation using appropriate software. write energy and exergy equation in Fortran 77 only... plot graph in scilab....
A Carnot-cycle refrigerator rejects heat at the pressure of 1000 kPa during which the working fluid...
A Carnot-cycle refrigerator rejects heat at the pressure of 1000 kPa during which the working fluid R -134a changes from saturated vapor to saturated liquid. The heat is added to the cycle at the pressure of 320 kPa. Show the cycle in a T-s diagram and determine the coefficient of performance of the cycle using a) the first law of thermodynamics b) the Carnot cycle efficiency equation and c) the T-s diagram.
Refrigerant 134a is the working fluid in a vapor-compression heat pump system with a heating capacity...
Refrigerant 134a is the working fluid in a vapor-compression heat pump system with a heating capacity of 60,000 Btu/h. The condenser operates at 180 lbf/in.2, and the evaporator temperature is 0°F. The refrigerant is a saturated vapor at the evaporator exit and a liquid at 110°F at the condenser exit. Pressure drops in the flows through the evaporator and condenser are negligible. The compression process is adiabatic, and the temperature at the compressor exit is 180°F. Determine (a) the mass...
A design related question. 1)design a walk in refrigerator and freezer with 10 ton and 30...
A design related question. 1)design a walk in refrigerator and freezer with 10 ton and 30 ton cooling capacity respectively. 2) freezer must be maintained between (24 to 15 deg celcius) and refrigerator between (3-7 deg celcius) 3)ambient condition ( 38 deg celcius) and refrigeration compressor efficiency assumed at 75%. 4)heat exchanger maintained at 11 deg celcius. 5) emphasis on reducing operating cost, so one compressor can be used and also flash chamber 6) reducing compressor work input and increasing...
ADVERTISEMENT
Subjects
ADVERTISEMENT
Latest Questions
ADVERTISEMENT