The steel beam has the cross section shown. The beam length is L = 6.9 m, and the cross-sectional dimensions are d = 345 mm, bf = 185 mm, tf = 15 mm, and tw = 10 mm.

The steel beam has the cross section shown. The beam length is L = 6.9 m, and the cross-sectional dimensions are d = 345 mm, bf = 185 mm, tf = 15 mm, and tw = 10 mm. Calculate the largest intensity of distributed load w0 that can be supported by this beam if the allowable bending stress is 185 MPa.

Solutions

Expert Solution

samet mamat answered 1 year ago

Next > < Previous

Related Solutions

A steel wire with a cross-section area 2.5X10^-3 m2 and a length of 10 m is...

A steel wire with a cross-section area 2.5X10^-3 m2 and a length of 10 m is used to pull a truck on the road. The truck is 10 tons and the friction coefficient between the tires and road is 0.25N/kg. Steel has a Young’s modulus 250MPa. Suppose this wire contain surface cracks. Determine the largest linear size of the surface crack so that the wire will not fail due to fracture in this application. Kc = 0.1 MPa m^0.5

A uniform steel beam of length 5.00 m has a weight of 4.50 ✕ 10^3 N....

A uniform steel beam of length 5.00 m has a weight of 4.50 ✕ 10^3 N. One end of the beam is bolted to a vertical wall. The beam is held in a horizontal position by a cable attached between the other end of the beam and a point on the wall. The cable makes an angle of 25.0° above the horizontal. A load whose weight is 12.0 ✕ 10^3 N is hung from the beam at a point that...

A 1.5 m length of wire has a cross-sectional area of 5.0×10−8 m2. When the potential...

A 1.5 m length of wire has a cross-sectional area of 5.0×10−8 m2. When the potential difference across its ends is 0.20 V, it carries a current of 0.40 A. What is the resistivity of the material from which the wire is made?

Subjects