A 2-stroke motor cycle petrol engine cylinder consists of 15 fins. If the outside and inside...

A 2-stroke motor cycle petrol engine cylinder consists of 15 fins. If the outside and inside diameter of each fin are 200 mm and 100 mm respectively, the average fin surface temperature is 475 c and atmospheric air temperature is 25 c calculate the heat transfer rate from the fins when the motor cycle is stationary.Assume all the fins in a horizontal position.

Solutions

Expert Solution

samet mamat answered 1 year ago

Next > < Previous

Related Solutions

The 12 cylinder 2 stroke cycle compression ignition engine of an oil tanker is operating at...

The 12 cylinder 2 stroke cycle compression ignition engine of an oil tanker is operating at 150 rpm The brake mean effective pressure of the engine is 400 kPa and the excess air coefficient is 2. The crankshaft of the engine is directly coupled to a propeller and a torque of 1500 kN-m is applied. The engine operates on light fuel oil which can be approximated as C12H26. If the brake specific fuel consumption is 200 g/hp-h what is the...

A single-cylinder, four stroke research engine operates on Otto cycle. The specification of the engine is...

A single-cylinder, four stroke research engine operates on Otto cycle. The specification of the engine is shown as below:- Displacement volume of the cylinder = 540 cm3 Clearance volume of the cylinder = 60 cm3 Minimum temperature = 200°C Minimum pressure = 200 kPa Net work output = 1000 kJ/kg Sketch the process on a P-V diagram and by using constant specific heat at room temperature, determine: i) the temperature and pressure at each process, ii) the thermal efficiency of...

1. An aluminum air-cooled engine cylinder head for a single cylinder, 2-stroke engine is to be...

1. An aluminum air-cooled engine cylinder head for a single cylinder, 2-stroke engine is to be die-cast. The overall diameter of the cylinder head is 101.6 mm. If the projected plan area of the runners and gating system is 100 mm2 and the casting pressure is 10 MPa (1500 psi), what minimum locking force is required for the die-casting machine in kN.

A four-cylinder four-stroke engine is operating at a bmep of 2 bar. The pressure at inlet...

A four-cylinder four-stroke engine is operating at a bmep of 2 bar. The pressure at inlet valve closure is 0.37 bar, and the fmep is 0.8 bar. Assuming that the engine gross indicated efficiency is unchanged, verify that disablement of the valves on two cylinders would reduce the fuel consumption by about 13 per cent compared with about an 8 per cent fuel saving if the fuel was not supplied to two cylinders. Assume that the gross imep is proportional...

A two-cylinder, four-stroke gas engine has a bore of 380 mm and a stroke of 585...

A two-cylinder, four-stroke gas engine has a bore of 380 mm and a stroke of 585 mm. At 240 rev/min the torque developed is 11.86 kNm. If the engine is supplied with a mixture of gas and air in the proportion of 1 to 7 by volume. The estimated volumetric efficiency is 85% and the Qnet,p of the gas is 38.6 MJ/m3. Calculate the brake thermal efficiency of the engine.

A four-cylinder petrol engine has a swept volume of 2000 cm3, and the clearance volume in...

A four-cylinder petrol engine has a swept volume of 2000 cm3, and the clearance volume in each cylinder is 60 cm3. Calculate the air standard cycle efficiency. If the introduction conditions are 1 bar and 24 ?C, and the maximum cycle temperature is 1400 ?C, calculate the mean effective pressure based on the air standard cycle. ANSWERS(59.1%; 5.30 bar)

15. There are two types of private cars in Country A: small-cylinder engine and large-cylinder engine....

15. There are two types of private cars in Country A: small-cylinder engine and large-cylinder engine. The gasoline price in Country A has increased rapidly recently. With the help of demand-supply diagrams, briefly explain why the increase in gasoline price leads to an increase in the price of new small-cylinder engine cars and a decrease in the price of new large-cylinder engine cars in Country A.

Why does excess charge accumulate on the outside of a cylinder conductor opposed to the inside?

A ship is fitted with six-cylinder CI engine of 75 mm bore and 100 mm stroke....

A ship is fitted with six-cylinder CI engine of 75 mm bore and 100 mm stroke. The engine has a brake power output of 110 kW at 370 rpm. The volumetric efficiency at this operating condition, referred to ambient conditions, of 1.013 bar and 20˚C is 80%. You have just fitted a mechanically driven supercharger which has isentropic efficiency of 0.7 and the pressure ration of 1.6. The supercharged version of the engine has a volumetric efficiency of 100% referred...

A test was conducted on a 4-stroke four cylinder engine having 6.9 cm diameter and 8.9...

A test was conducted on a 4-stroke four cylinder engine having 6.9 cm diameter and 8.9 cm stroke. The fuel supply to the engine is 0.065 kg/min. The B.P measurements are given below with constant engine speed of 300 rpm: With all cylinder firing = 16.9 kW Cut off at 1st cylinder = 8.46 kW Cut off at 2nd cylinder = 8.56 kW Cut off at 3rd cylinder = 8.6 kW Cut off at 1st cylinder = 8.46 kW If...

Subjects